Compiler compatible 5.66 Mb/mm2 8T 1R1W register file in 14 nm FinFET technology

1-read/1-write (1R1W) register file (RF) is a popular memory configuration in modern feature rich SoCs requiring significant amount of embedded memory. A memory compiler is constructed using the 8T RF bitcell spanning a range of instances from 32 b to 72 Kb. An 8T low-leakage bitcell of 0.106 μm² is used in a 14 nm FinFET technology with a 70 nm contacted gate pitch for high-density (HD) two-port (TP) RF memory compiler which achieves 5.66 Mb/mm² array density for a 72 Kb array which is the highest reported density in 14 nm FinFET technology. The density improvement is achieved by using techniques such as leaf-cell optimization (eliminating transistors), better architectural planning, top level connectivity through leaf-cell abutment and minimizing the number of unique leaf-cells. These techniques are fully compatible with memory compiler usage over the required span. Leakage power is minimized by using power-switches without degrading the density mentioned above. Self-induced supply voltage collapse technique is applied for write and a four stack static keeper is used for read Vmin improvement. Fabricated test chips using 14 nm process have demonstrated 2.33 GHz performance at 1.1 V/25 °C operation. Overall V_min of 550 mV is achieved with this design at 25 °C. The inbuilt power-switch improves leakage power by 12x in simulation. Approximately 8% die area of a leading 14 nm SoC in commercialization is occupied by these compiled RF instances.     

1,5-己二烯交联烯烃聚合物的合成及其抗剪切稳定性

以金属配合物为催化剂、1,5-己二烯为交联剂,采用本体聚合法合成了交联超高相对分子质量烯烃类聚合物(简称交联聚合物)。用傅里叶变换红外光谱、核磁共振、凝胶渗透色潜表征交联聚合物的结构和相对分子质量。用旋转黏度计和超声波仪研究了1,5-己二烯用量对交联聚合物溶液表观黏度的影响及交联聚合物的相对分子质量对交联聚合物溶液抗剪切稳定性的影响。实验结果表明,在最佳聚合条件(单体80mL、助催化剂0．4mL、CS-1催化剂0．090g、1,5-己二烯0．40mL、0℃、24 b)下所合成的交联聚合物的重均相对分子质量为7．7×106,数均相对分子质量3．6×106。加入少量1,5-己二烯能提高交联聚合物的抗剪切能力,同时也能提高交联聚合物的相对分子质量。交联聚合物的相对分子质量越大,抗剪切稳定性越好。1,5-己二烯用量约为0．1 mL时(单体40 mL),交联聚合物溶液的表观黏度达到最大值(16．8 mPa·s)。     

钻井钢丝绳检测方法与装置的研究

钻井钢丝绳对于钻井平台安全可靠性有直接影响。采用磁性检测方法对钻井钢丝绳进行检测,并对钻井钢丝绳的励磁方式、聚磁方法及传感器与钢丝绳的配合间隙问题进行分析。在此基础上,研制了钻井钢丝绳检测仪器,能够实现对钻井钢丝绳断丝、磨损等缺陷的定性、定量检测,并能够对缺陷进行定位,为钻井钢丝绳的寿命评估提供了依据,对提高钻井平台的安全性具有重要意义。     

利用HFC网络开展VoIP业务

本文首先介绍了VoIP的原理、相关协议．然后介绍了VoIP业务在HFC网络应用的业务环境和体系结构。并对其中的功能实体进行描述和说明。最后介绍一个具体的业务实例。     

AlSb晶体内二维磁极化子的磁场与温度效应

在考虑声子之间相互作用的同时，本文应用线性组合算符和微扰法研究了电子自旋对弱耦合二维磁极化子特性的影响。对AlSb晶体所作的数值计算结果表明，随着磁场的加强，磁极化子平均数减少；随着温度的增加，磁极化子平均数也增加；随着温度的增加，电子自旋作用以及声子之间相互作用都加强；随着磁场的加强，电子自旋作用增加而声子之间相互作用基本不变。     

基于SAA7114H的视频图象采集系统的设计

介绍一种高度集成并具有广泛通用性的视频图象信号采集系统。系统的开发采用了功能强大的视频解码芯片SAA7114H和可编程逻辑门阵列器件(FPGA)，并考虑了在线编程的模式。文中给出了YUV色彩空间与RGB色彩空间的转换公式，经验证效果很好。在实际应用中，该系统作为前端图象采集部分取得了良好的效果。     

CDMA 1x EV-DO覆盖模型的分析与仿真

结合经过校正后的适合于本地无线环境的OKUMURA-HATA传播模型，建立起一种新的本地化基于1x EV—DO系统数据业务吞吐量分析的覆盖预测仿真模型，可应用于1xEV—DO系统的网络规划及系统性能分析。     

BaTiO3基Au纳米颗粒复合薄膜的制备及其光学性质研究

采用溶胶-凝胶（sol-gel）方法，成功的将高体积面分比的Au纳米颗粒复合到BaTiO3的非晶薄膜中，并对其光学性质进行了研究。用XRD、TEM、椭偏仪、吸收光谱、光克尔效应OKE（Optical Kerr Effcet）方法对薄膜进行了表征和测试。从吸收光谱观察到表面等离子体共振SPR（Surface Plasma Resonance)峰随热处理温度升高而红移的现象。光学非线性测试表明薄膜具有高的三阶非线性极化率Χ^(3)和超快的响应时间。     

Synthesis of amphiphilic magnetic microspheres by dispersion copolymerization of styrene and poly(ethylene oxide) macromonomer

Amphiphilic magnetic microspheres ranging in diameter from 5 to 100 µm were prepared by dispersion copolymerization of styrene and poly(ethylene oxide) vinylbenzyl (PEO‐VB) macromonomer (MPEO) in the presence of Fe₃O₄ magnetic fluid. The effects of various polymerization parameters on the average particle size were systematically investigated. The average particle size was found to increase with increasing styrene concentration and initiator concentration. It also increased with decreasing stabilizer concentration and molecular weight of MPEO. The content of the hydroxyl groups localized in the microspheres ranged from 0.01 to 0.2 mmol g^?1. © 2003 Society of Chemical Industry     

番禺30-1砂岩强水驱气藏储层非均质性研究

针对垂向非均质性严重且边底水能量强的番禺30-1气田面临的潜在开发问题，通过岩心分析及测井二次解释，对其夹层特征及储层非均质性等进行了研究，划分出19个流动单元并定量描述了各流动单元的特征参数，建立了该气田的精细地质模型。综合评价表明，新建的地质模型具有较高的精度，为该气藏合理开发提供了坚实的地质基础。