纳米材料对PBT合成的催化性能研究

用溶胶－凝胶法制备TiO2及TiO2/SiO2复合纳米材料，作为PBT（聚对苯二甲酸丁二酯）合成的催化剂，与现在普通使用的催化剂钛酸丁酯进行了比较和研究。结果发现，TiO2/SiO2复合纳米材料催化性能最好，纳米TiO2次之。     

油砂地层中子-伽玛能谱Monte-Carlo模拟

本工作应用自行研制开发的中子 伽玛能谱测井的中子 伽玛射线随空间、能量、时间分布的蒙特卡罗模拟软件包计算了裸眼井、井眼里无下井仪器、油饱和砂岩地层、井眼注油条件下沿井轴和井壁的中子 伽玛射线随能量、时间分布及沿井轴和沿井壁的中子 伽玛射线能谱 ,研究了源距对中子 伽玛射线随能量、时间分布以及井轴与井壁中子 伽玛射线能谱的影响。     

Sensitizing Mechanism and Adsorption Properties of Dye—Sensitized TiO2 Thin Films

The dye-sensitized TiO2 complex films were prepared by the dye coat onto TiO2 surfaces,and the sensitizing mechanism and adsorption properties of the dye-sensitized TiO2 complex films were inverstigated.The influence of the application conditions of dye adsorbed on TiO2 films on the amount of dye adsorption was discussed.Experimental results show that the concentration,the temperature of dye solutions and the dipping time of TiO2 films in the dye solutions have a significant influence on the amount of dye adsorption.Cell test indicates that the conversion efficiency of light to electricity increases with the amount of dye adsorption.     

汽车用焊接钢管的发展

介绍了汽车用焊接钢和产品品种，国内皮类管的生产现状及市场需求状况；国外汽车用焊管最新发展情况。建议国内汽车用焊管应该是定点供料，定点生产，设备配套，完善工艺，建立从炼钢，轧制到制管的质量管理体制。     

石油企业办社会的“悖理行为”辨疑

企业办社会虽与市场经济的客观要求相悖，但石油企业大量办社会的事实仍揭示了所具备的理性面。认为国家作为不受所有者监督的代理者对石油企业的要求，石油企业的行业特性以及在传统体制下长期运作所成的定热是石油企业办社会的主要原因。     

大功率CO_2激光器非平衡态合成WO_3／Fe_2O_3新型陶瓷催化剂──Ⅱ．WO_3／Fe_2O_3烯烃歧化反应催化剂的催化活性

用大功率ＣＯ２激光器熔制ＷＯ３／Ｆｅ２Ｏ３新型烯烃歧化反应催化剂。考查了催化剂组成、激光功率及熔炼时间与丙烯歧化反应催化活性之间的关系。     

Xylose-lysine model systems: The effect of pH on the volatile reaction products

Aqueous molal solutions of xylose and lysine (initial pH 4–9) were refluxed either with control of the pH at 5–0 or without pH control (final pH 2–6). Analysis by gas chromatography (GC) and GC-mass spectrometry resulted in the identification of 58 and 28 compounds, respectively, from the two systems. Furans were the main reaction products in both systems and 2-furfural alone comprised 522 and 999 g kg^?1 of the volatiles, respectively, from the systems with final pH values of 5–0 and 2–6. Maintaining the pH at 5–0 resulted in a higher yield and greater numbers of nitrogen-containing compounds, and monocyclic pyrroles, pyridines and 2,3-dihydro-l H-pyrrolizines were identified only in that system. Aliphatic compounds, alicyclic compounds, benzene derivatives. l-(2–furfuryl)pyrroles and pyrazines were also identified. This investigation is the first report of the formation of 2.3-dihydro-l H-pyrrolizines in a model system containing lysine as the amino compound; a possible mechanism is proposed.     

Best L1 Piecewise Monotonic Data Modelling

Let us consider n data measurements of a univariate process that have been altered by random errors. We assume that an underlying model function has a substantially smaller number of turning points than the observed ones. We propose algorithms that make least the sum of the moduli of the errors by requiring k monotonic sections, alternately increasing and decreasing, in the sequence of the smoothed values. The main difficulty in this calculation is that the optimal positions of the joins of the monotonic sections have to be found automatically among so many combinations that it is impossible to test each one separately. Moreover, the calculation seems to be very intractable to general optimization techniques because O(n^k) local minima can occur. It is shown that dynamic programming can be used for separating the data into optimal disjoint sections of adjacent data, where each section requires a single L₁ monotonic calculation. This procedure is highly efficient, requiring at most O(kn²) computer operations and O(n) best L₁ monotonic calculations to subranges of data for a global minimum.     

Growth and characterization of hot-wall epitaxial CdTe on (111) HgCdTe and CdZnTe substrates

Thin CdTe films were deposited by hot-wall epitaxy (HWE) on (111) HgCdTe and CdZnTe substrates at temperatures from about 140 to 335°C. X-ray rocking curves were used to show that crystal quality of the CdTe (111)B films improved as substrate temperature increased from 140 to about 250°C. Rocking curve values for full width at half maximum (FWHM) decreased from 2–4 degrees at 140–150°C to less than 100 arc-s at 250°C, and a FWHM of 59 arc-s was the lowest value observed near 250°C. The FWHM of the HWE CdTe was found to be insensitive to growth rate below about 400Å/min, but increased to four degrees at 1250Å/min. X-ray diffraction confirmed that films grown on the B-face at higher temperatures were epitaxial, but contained a significant volume fraction, 35% to 50%, of rotational in-plane twins. Electron microscopy confirmed a coarse twin density, and photoluminescence spectra showed an absence of excitonic emission in the HWE films. Simultaneous growth on two (111) HgCdTe substrates with different surface polarities between 230°C and 335°C showed that deposition rate on the A-face decreased relative to that on the B-face as temperature increased. Films grown on the B-face exhibited better surface morphologies than those grown on the A-face.     

Probing the early stages of polymerization of ethylene on a model chromium/silica catalyst by Fourier transform infrared spectroscopy

The nature of the interaction of monomer, and the early stages of growth of oligomers of ethylene on a rather more uniform surface of Cr/SiO₂ catalyst than hitherto studied has been investigated by differenceFTIR spectroscopy using C₂D₄ and C₂H₄ as reactants both with and without subsequent treatment of the catalyst with CO andTHF. The active catalyst was prepared by reaction of vapour phase CrO₂Cl₂ with the vicinal hydroxyls of the silica surface. Three distinct kinds of methylene groups were detected. Arguments are given for assigning the peaks at 2935 and 2860 cm^–1 to CH₂ groups directly bound to the active site and those at 2920 and 2850 to CH₂s in the growing chain well removed from the Cr. The peaks at 2160 and 2165 cm^–1 are attributed to CD₂ groups hydrogen bonded to surface hydroxyls.