动态光散射法研究海藻酸钠凝胶松弛行为

在前文的基础上，用相关函数轮廓分析的方法剖析了运动模型模式的复杂性。通过海藻酸钠水溶液在０．１ｍｏｌ／ＬＣａＣｌ２水溶液透析凝胶化过程中交联网络的松弛时间谱表明它不是单一的峰，有两上特征运动模式，并随透析向更慢的运动模式发展，这很慢的运动模式估计与区域的结构的生成有关。     

水解母液生产葡萄糖酸钙新工艺

葡萄糖酸钙的生产一般是以淀粉为原料经液化、糖化、发酵、中和、精制、结晶、干燥制得的。而以母液为原料，其原料成本低，工艺流程短，减少了营养元素的添加，大幅度地降低了生产成本，值得推广。     

对我厂防治加热管内碳酸钙垢的思索

分析了我厂两碱法原卤净化后,加热管内壁结碳酸钙垢的原因,探讨了我厂采取加盐酸、加阻垢剂、用超声波阻垢器的方法,以及对加热管内碳酸钙垢防治的情况和存在的问题.     

饲料级磷酸氢钙中氟的几种分析方法比较

本文采用茜素络合酮比色法和氟离子选择电极法对饲料磷酸氢钙进行氟的测定实验对比,得出常用的氟离子选择电极法完全可以代替经典的蒸馏比色法的结论。     

Effect of Bio-Based Cobalt Alginate on the Fire Safety and Mechanical Properties for Epoxy Resin

There is a growing demand to develop epoxy resins (EP) with smoke suppression as well as satisfactory flame retardancy. Herein, bio-based cobalt alginate is successfully fabricated and incorporated into EP to prepare EP/Cobalt Alginate composites with better fire safety performance. The addition of cobalt alginate reduces the thermal-decomposition rate, temperature at maximum weight-loss rate of EP, whereas obviously improves the thermal stabilities at a higher temperature range. Furthermore, the addition of cobalt alginate substantially reduces the fire hazard of EP, resulting in 56.2% reduction in peak heat release rate, as well as 17.8% and 56.3% reduction in total smoke production and peak smoke production rate, respectively, compared with EP matrix. Moreover, the presence of cobalt alginate increases smoke-suppressant properties, according to the smoke density test. Additionally, the incorporation of cobalt alginate has no obviously destructive effect on the mechanical properties of EP, while EP/Cobalt Alginate-3 exhibits a 27.0% improvement in impact strength. In prospective, this study may provide a significant method for producing eco-friendly flame retardant EP.     

六铝酸钙材料的合成及其显微结构研究

分别采用轻质碳酸钙和活性氧化铝 ,或纯铝酸钙水泥和活性氧化铝为初始原料 ,反应烧结合成了六铝酸钙 (CA6)材料 ,研究了原料和成型压力对合成材料的烧结性能和显微结构的影响 ,同时借助于XRD、TG -DSC、SEM和EDAX等测试手段对其反应过程、物相变化和显微结构进行了分析和观察。研究结果表明 :(1) 130 0℃时 ,合成材料的主晶相为刚玉相和CA2 ,并开始有CA6形成 ;温度升至14 0 0℃ ,CA6大量生成 ;15 0 0℃时反应完成 ,产物全部为CA6相。 130 0～ 15 0 0℃时 ,上述反应表现为体积膨胀过程 ,试样的体积密度和径向线收缩率随温度的变化不大 ;而高于 15 0 0℃时 ,试样明显趋向烧结 ,体积密度升高 ,线收缩率加大。采用纯铝酸钙水泥和活性氧化铝合成的试样的体积密度均高于采用轻质CaCO3 和活性氧化铝的 ,尤其在烧成温度高于 15 0 0℃时。坯体的成型压力对这两种合成试样的烧结性能均没有显著影响。 (2 )合成六铝酸钙材料的晶粒形貌与合成工艺有关 ,制备片状晶粒的六铝酸钙材料需满足两个条件 :一是晶核有足够的发育空间 ,二是从晶核生长形成片状结构需足够的物质扩散。采用纯铝酸钙水泥和活性氧化铝为原料的试样 ,其CA6晶核很容易发育成片状晶形 ,且随着坯体成型压力的增加 ,片状CA6有向等轴状发展的趋势 ;采用     

有广阔市场前景的化工产品—过氧化钙

本文叙述过氧化钙的性质,并以实例说明过氧比钙在水产养殖、食品加上、果蔬保鲜。环境保护、农作物栽培、橡胶及化工等奋方面的应用。     

Effect of pH, sulfate and sodium on the EDTA titration of calcium

The ethylenediaminetetraacetic acid (EDTA) titration method limits the measurement of calcium concentration to 50 mg/l in water. However, various acids and salt solutions are used in the investigation of the durability of concrete, and the adaptability of the EDTA titration method to determine the calcium in these solutions must be investigated. Hence, the purpose of this study was to investigate the interfering effects of hydrochloric acid, sulfuric acid, sodium chloride and sodium sulfate on measuring the calcium in the aqueous leaching solutions using the EDTA titration method. The calcium standard solutions were prepared using CaCl₂ with initial pH from −0.8 to 7 and calcium concentration up to 160 mg/l. Sulfuric acid and hydrochloric acid were used to prepare calcium solutions with lower pH. Salt solutions with 3% NaCl and 3% Na₂SO₄ were used to evaluate the interfering effects of salt elements such as sulfate and sodium on the EDTA titration. Results indicated that the EDTA titration method was reliable in measuring the calcium up to 160 mg/l, the maximum concentration investigated in this study, in hydrochloric acid with pH higher than zero and 3% sodium chloride solution. Sulfuric acid with pH higher than zero and 3% sodium sulfate solutions showed 3% to 4% less calcium in the solutions. Acid solutions with pH less than zero showed interference with calcium measurement.     

Crystallization and dissolution behavior of l(+) calcium and zinc lactate in ethanol-water solvent

Crystallization and dissolution behavior of L(+) calcium and zinc lactate in 50% ethanol-water solution was studied. The effects of stirring, standing, ultrasonic wave, and temperature on the crystallization of L(+) calcium and zinc lactate were evaluated. It was found that standing had a positive effect on crystallization of L(+) calcium and zinc lactate, while stirring promoted dissolution of crystallized particles and resulted in high residual concentration in mother liquor. The application of ultrasonic wave did not influence much on crystallization process. L(+) calcium and zinc lactate crystallized easily at 5 ‡C; however, complete crystallization took more than 72 hours. These two salts dissolved rapidly and reached equilibrium within 1 hour.     

火焰原子吸收光谱法测定特殊硅铁中微量钙

采用氢氟酸、硝酸分解试样,加氯化铵络合钙,六次甲基四胺沉淀干扰杂质,控制体系的酸度为中性,加三乙醇胺作增感剂,镧盐作释放剂,以火焰原子吸收光谱法对特殊硅铁中微量钙进行测定,方法的相对标准偏差为1.72%~5.63%,回收率为92.00%~105.00%。