Effects of the cryogenic cooling on the fatigue strength of the AISI 304 stainless steel ground components

For environmental considerations, the substitution of the conventionally used oil-based grinding fluids has nowadays become strongly recommended. Although several alternatives have been proposed, cryogenic cooling by liquid nitrogen is the non-polluting coolant that has been given relatively more attention because of its very low temperature. In this investigation, in order to contribute to developing this promising cooling mode, its beneficial effects on the ground surface integrity of the AISI 304 stainless steel and their consequences on the fatigue lifetime are explored. Results of this investigation show that grinding under cryogenic cooling mode generates surfaces with lower roughness, less defects, higher work hardening and less tensile residual stresses than those obtained on surfaces ground under oil-based grinding fluid. These surface enhancements result into substantial improvements in the fatigue behaviour of components ground under this cooling mode. An increasing rate of almost 15% of the endurance limit at 2 × 10⁶ cycles could be realized. SEM analyses of the fatigue fracture surfaces have shown that the fatigue cracks observed on the specimens ground under cryogenic cooling are shorter (i.e., 30-50 μm) than those generated under oil-based cooling mode (i.e., 150-200 μm). The realized improvements in the surface integrity and in the fatigue behaviour are thought to be related to the reduction of the grinding zone temperature observed under cryogenic cooling, as no significant differences between the grinding force components for both cooling modes have been observed.     

低温液体冷却循环器的研究与开发

根据低温生物、生化实验研究和产品小试时应用低温条件的特点，提出机械制冷的冷却循环器，讨论了工作原理和制冷量计算，对其制冷系统和温度控制进行介绍。     

内燃机车临时补水设备的设计与应用

针对内燃机车“途中缺水”故障 ,设计并安装临时补水设备 ,解决了电化区段临时补水的问题 ,满足了内燃机车“不停车、不停机”即可补水的要求。     

轧后穿水冷却工艺对棒材组织性能的影响

针对轧机产量提高后冷床冷却能力不足的问题 ,研制开发了棒材轧后穿水冷却技术。通过对小规格 2 0MnSiV热轧带肋钢筋进行轧后穿水冷却 ,钢材上冷床温度降低了 90～ 110℃ ,提高了产品质量 ,改善了各项力学性能 ,抗拉强度平均提高了 3 5～ 40MPa ,钢材性能合格率由 97.5 %提高到了 99.6% ,解决了冷床冷却能力不足、制约生产的瓶颈问题。     

冷却水污垢及其对冷却器换热的影响

分析了冷却器的结垢机理 ,提出了冷却器污垢层、污垢热阻随运行时间的规律 ,以及污垢热阻与换热系数、换热面积的关系式 ,并通过算例阐述了污垢热阻对冷却器的影响程度 ,进而定性地分析了污垢热阻对空分装置的影响。     

Cost effectiveness of decentralized energy supply systems taking solar and wind utilization plants into account

In this article, results are presented of annual simulations of a decentralized (regional) plant for the power and heat supply of a residential complex. This complex consists of four houses with 40 flats all in all. The annual power consumption of the complex is 157 MWh and the heat requirement is 325 MWh. The concrete dynamics of the energy demands over the year is taken into consideration. The energy supply system is composed of a power-controlled combined heat and power (CHP) plant (55 kW), a photovoltaic plant (PV array or PV plant) array for power generation as well as a field of solar thermal collectors with a short-term accumulator for water heating and a long-term accumulator for supplying heat for domestic heating purposes. Simulation results demonstrate that synergetic effects result from the combination of a CHP plant with wind power and PV plants of varying sizes, which have an effect on the cost effectiveness of the plant as a whole with the different dynamics of energy sources (wind and solar energies) and of the consumption of power and heat being the decisive factors. The power deficits of wind power and PV plants are compensated through the application of a natural gas-operated CHP plant. In almost all variants, the demand for fossil energy carriers is distinctly less than in conventional energy supply plants.     

机械过冷的制冷系统在汽车空调中的应用

由于很多汽车空调采用斜盘式压缩机，有利于采用机械过冷的制冷系统，来增加汽车空调的制冷量、提高制冷效率。本文的主要目的是通过对系统工质的流量分配、空调制冷量和性能系数(COP)与中间压力之间的变化关系的研究，来研究机械过冷在汽车空调中应用的可行性。     

可再生能源在空调制冷中的应用

针对目前压缩式制冷技术带来的能源短缺和环境污染问题，介绍了几种可再生能源在空调制冷中的应用技术，如地道风供冷、地源热泵系统、太阳能空调制冷，分析了可再生能源用于空调制冷的特点及发展现状，并对其应用前景做了展望。     

卸荷裂隙在水利水电工程建设中的危害

卸荷裂隙是对水工建筑物稳定最不利的软弱结构面之一。文中较系统地介绍了这种结构面的特点、分布规律、形成的力学机理、对工程的危害、勘查方法及处理措施。     

本钢烧结矿冷却及其余热回收的试验研究

从烧结矿冷却并回收其余热的角度出发，介绍了利用烧结机尾落矿空间，采用喷吹空气装置对烧结矿进行冷却的小型模拟试验，从测出的结果来看，有可能成为一种新的烧结矿冷却方式。