User experience and personal innovativeness: An empirical study on the Enterprise Resource Planning systems

Although user experience and personal innovativeness are two important factors in new technology adoption, there has been no prior study to test these factors with the Enterprise Resource Planning (ERP) adoption. This paper investigates moderating roles of user experience on the relationship between the personal innovativeness and the ERP adoption motivations. This issue is important because if the user has more experience with the systems then the power of influence of personal innovativeness on ERP adoption motivation would be different. Thus, this paper tests these important insights of ERP systems adoption with the two different field samples with high (more than three years) and low (less than three years) user experience, based on the innovation diffusion theory, self determination theory, and different types of motivations such as intrinsic and extrinsic motivations. The findings, based on the PLS analysis of the model using 107 ERP end users, show that there are clear moderating effects of user experience—such as impacts of personal innovativeness on ERP systems adoption motivations are higher in case of low user experience samples, as expected. Academic and practical implications are discussed in the paper based on these empirical findings.     

甲烷浓度对金刚石薄膜(100)织构生长的影响

以H2和CH4的混合气体为气源,用微波等离子体辅助化学气相沉积法(MPECVD)在1 cm×1 cm S i(100)基体上沉积了金刚石薄膜。研究了不同的甲烷浓度对金刚石薄膜(100)织构生长趋势的影响。分别采用扫描电子显微镜(SEM),Ram an光谱对金刚石膜的表面形貌、质量进行了分析。结果表明,当基体温度为750℃,气压为4.8×103Pa,甲烷浓度为1.4%时,薄膜表面为(100)织构。     

Hydrogen evolution during the oxidation of formaldehyde on Au:: The influence of single crystal structure and Tl-upd

Hydrogen evolution during formaldehyde oxidation in alkaline solution has been monitored by Differential Electrochemical Mass Spectrometry on Au(111) and polycrystalline gold. The current efficiency for hydrogen evolution increases with higher concentration and is in the same range on both, polycrystalline Au and Au(111) electrode. The onset potentials and half-wave potentials are higher on Au(111). Reaction orders for the faradaic current on the bare gold electrodes have been determined as 0.21 for higher and 0.76 for lower concentrations. Reaction orders for hydrogen evolution during formaldehyde oxidation are 1.4 times higher in each case. Tafel slopes in the range of 140-160 mV are found. This signifies that the first reaction step involving the formation of adsorbed hydrogen is largely determining the overall reaction rate. In the presence of thallium adlayers hydrogen evolution from formaldehyde oxidation is largely suppressed. On the thallium modified polycrystalline Au, formaldehyde oxidation is shifted for 100 mV to higher potentials where Tl is partially desorbed and hydroxide is coadsorbed on the modified surface. On thallium modified Au(111), a similar process takes place, but in the same potential region as the onset of formaldehyde oxidation on the bare surface and therefore the formaldehyde oxidation is only slightly shifted. Tafel slopes are decreased to 80 mV/dec in the presence of thallium. In the presence of adsorbed thallium, the first reaction step is in equilibrium, the coverage with adsorbed hydrogen is smaller and its recombination to H₂ is largely suppressed.     

Synthesis and characterization of poly(ϵ‐caprolactone)‐b‐poly(ethylene glycol) block copolymers prepared by a salicylaldimine‐aluminum complex

A series of poly(?‐caprolactone)‐b‐poly(ethylene glycol) (PCL‐b‐PEG) block copolymers with different molecular weights were synthesized with a salicylaldimine‐aluminum complex in the presence of monomethoxy poly(ethylene glycol). The block copolymers were characterized by ¹H NMR, GPC, WAXD, and DSC. The ¹H NMR and GPC results verify the block structure and narrow molecular weight distribution of the block copolymers. WAXD and DSC results show that crystallization behavior of the block copolymers varies with the composition. When the PCL block is extremely short, only the PEG block is crystallizable. With further increase in the length of the PCL block, both blocks can crystallize. The PCL crystallizes prior to the PEG block and has a stronger suppression effect on crystallization of the PEG block, while the PEG block only exerts a relatively weak adverse effect on crystallization of the PCL block. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2007     

Mechanical properties of a cryogenically mechanically alloyed polycarbonate–poly(aryl ether ether ketone) system

The processing–property relationship of a model cryogenically mechanically alloyed polymer–polymer system [polycarbonate (PC) and poly(aryl ether ether ketone) (PEEK)] was investigated. PC and PEEK powders were cryogenically mechanically alloyed for 10 h, and the resulting two‐phase powder particles were processed into testable coupons with a miniature ram‐injection molder. The bulk mechanical properties of the coupons made from the mechanically alloyed powders and nonmechanically alloyed powders were investigated as a function of mechanical alloying and injection‐molding parameters. The injection‐molded coupons were mechanically tested in the three‐point‐bending mode. The results demonstrated that no measurable improvement was achieved in the energy to break, strain at failure, or failure strength in the coupons made from the mechanically alloyed materials in comparison with those of the coupons made from the nonmechanically alloyed powders. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 88: 1196–1202, 2003     

Asymmetric Sharpless epoxidation of 13S‐hydroxy‐ 9Z, 11E‐octadecadienoic acid (13S‐HODE)

The asymmetric Sharpless epoxidation of methyl 13S‐hydroxy‐9Z, 11E‐octadeca‐dienoate (13S‐HODE, 1 ) with tert‐butyl hydroperoxide (TBHP) catalysed by titanium tetraisopropoxide {Ti(ⁱOPr)₄} in the presence of L(+)‐diisopropyl tartrate (L‐DIPT) gave methyl 13S‐hydroxy‐11S, 12S‐epoxy‐9Z‐octadecenoate 2 (erythro isomer) in 84% diastereomeric excess (de). The epoxidation of 1 with TBHP catalysed by Ti(ⁱOPr)₄ in the presence of D(‐)‐DIPT yielded methyl 13S‐hydroxy‐11RR12R‐epoxy‐9Z‐octadecenoate (threo isomer) 3 in 76% de.     

三元乙丙橡胶/蒙脱土纳米复合材料的制备方法与应用前景

橡胶／蒙脱土纳米复合材料的优异性能使其成为橡胶工业中富有潜力的一类新型材料。笔者综述了三元乙丙橡胶(EPDM)／蒙脱土纳米复合材料的制备方法、性能和工业应用领域等，讨论了蒙脱土片层的表面修饰、插层剂的选择以及复合材料的制备方法对材料性能的影响，并提出了三元乙丙橡胶／蒙脱土纳米复合材料这一新型橡胶材料在轮胎工业上的应用前景。     

Low frequency ac conduction and dielectric relaxation behavior of solution grown and uniaxially stretched poly(vinylidene fluoride) films

The measurements of ac conductivity [σ_m(ω)], dielectric constant [?′(ω)] and loss [?″(ω)] have been performed on solution grown (thickness ∼85 μm) and uniaxially stretched (thickness ∼25, 45 and 80 μm) films of poly(vinylidene fluoride) (PVDF) in the frequency range 0.1 kHz-10 MHz and in the temperature range 77-400 K. The σ_m(ω) can be described by the relation σ(ω) = Aω^s, where s is close to unity and decreases with increase in temperature. Three relaxations, observed in the present investigation, have been designated as the α_c-, the α_a- and the β-relaxations appearing from high temperature side to the low temperature side. The α_c-relaxation could not be observed in the case of uniaxially stretched poly(vinylidene fluoride) films. The α_c- and α_a-relaxations are associated with the molecular motions in the crystalline regions and micro-Brownian motion in the amorphous regions of the main polymer chain, respectively, whereas the β-relaxation is attributed to the rotation of side group dipoles or to the local oscillations of the frozen main polymer chain.     

雅砻江楞古水电站场址区宋玉断层活动性研究

楞古水电站位于区域构造复杂的雅砻江中游, 场址周边断裂构造较发育, 场址区内发育有较大的宋玉断层, 研 究其活动性对枢纽建筑布置和工程抗震设防措施均具有重要意义。在遥感解译的基础上, 通过野外验证和追踪调 查, 结合断层构造岩石英形貌扫描、 电子自旋共振(ESR) 测龄和近代地震震中分析, 确定了宋玉断裂的活动年代, 得 出了宋玉断层不属于工程活动断层的结论。     

水资源适应性利用理论及其在治水实践中的应用前景

水系统受气候变化和人类活动的影响,一直在不断地变化,因此水资源的开发利用也应适应这种变化,而不能按照固定的控制阈值或约束条件来进行。当然,也不是被动的、随意的去适应。在对水系统及其与环境变化关系剖析的基础上,分析了水资源适应性利用的原理与模式;基于对环境变化下水资源适应性利用机理的认识,提出水资源适应性利用理论的框架体系,阐述了其基本理念和关键内容;基于对我国现代治水实践的分析,分析了其暗含的水资源适应性利用理论的内容,以及我国治水实践中存在的问题及应用水资源适应性利用理论解决这些问题的可能途径。研究认为,水资源适应性利用理论对水资源合理开发、综合利用、科学管理具有重要的指导作用,为环境变化下水资源利用研究与实践奠定理论基础。