等温脉冲自由射流压力场动态特性的实验研究

针对冶金工业过程脉冲燃烧及脉冲流技术所进行研究的基础部分,借助于计算机辅助信号分析手段,运用湍流统计理论,对等温脉冲自由射流压力场动态特性进行了系统的实验研究。实验的Re范围为19486～93936,st范围为0～0.057,所对应的射流脉冲频率为0～25Hz。研究结果表明;脉冲射流极大地提高了射流区压力波动水平,任何受气体的动量、热量和质量传递制约的工业过程均可望通过适当地采用脉冲流技术加以强化.     

Oxidation of methane in a wide range of pressures and effect of inert gases

The analysis of methane oxidation in a wide range of pressures (0.05–10 atm) demonstrates that the efficiency of CH₃ radicals recombination is of great importance for high selectivity of C₂ hydrocarbons formation. The relative efficiency of different “colliders” assisting the stabilization of exited C₂H*₆ molecules increases in the series: solid surface> Ar> He. The increase of the overall reaction rate upon increasing pressure of the inert gases in the case of catalysts having a higher surface area and more developed pore structure is likely due to the contribution of the surface-induced chain reaction in the volume of pores.     

Influence of the surface conditions on permeation in the deuterium–MANET system

The condition of the surfaces is of crucial importance for the deuterium permeation through materials. In this work a study of the surface constants for the adsorption (σk₁) and release (σk₂) of deuterium under different surface conditions on the martensitic steel DIN 1.4914 (MANET) has been carried out. The growth of an oxide surface layer (Cr₂O₃) of about 25–30 nm in a MANET sample, heat treated in an oxidizing environment, compared to the bare MANET that have a ‘natural' oxide of about 5 nm has provoked a reduction of both the permeation rate and the recombination coefficient (about 3 orders of magnitude). In addition, the permeation governing process has changed from diffusion-limited to surface-limited. The measurements of the permeation rate of deuterium were performed by a gas-phase permeation technique over the temperature range 574–746 K and for deuterium driving pressures in the range from 3 to 10⁵ Pa.     

Effects of electrode arrangement and pressure on synthesis of diamond films by arc discharge plasma jet chemical vapor deposition

The setup and deposition conditions of electrode arrangement and pressure have been studied to synthesize diamond films at high growth rate on wide area efficiently by arc discharge plasma jet chemical vapor deposition. An apparatus has been used in which four plasma torches, one is used for cathode and the others for divided anodes, are arranged and the positions of these torches are changeable. Growth rate, deposition area and thickness of diamond films have increased with changing the electrode arrangements without improvement of thickness variation. Maximum growth rate of our apparatus has occurred at the pressure of 6.7 kPa and diamond films that have less variations of quality and surface roughness have been synthesized at lower pressure during deposition. Moreover, a high conversion rate, which is the ratio of carbon atoms that form diamond in supplied methane gas, of 16% has been obtained at the pressure of 6.7 kPa and methane concentration of 2%.     

中型孔径小梯段露天石方深孔水压爆破

介绍了一种石方开挖新技术－－露天石方深孔水压爆破技术。用试验的方法，通过和常规石方爆破进行类比，从而研究了此项新技术在中型孔径小梯段应用条件下的各种爆破参数，并进行了定性和定量分析，得到了一些初步的结论。     

沙南油田高效开采技术政策研究

在该油藏大量动静态研究成果的基础上 ,根据国内外相似油田开发实例 ,运用数理统计、渗流力学、油藏工程及数值模拟的方法 ,结合矿场实际资料 ,对油藏进行天然能量、井网密度、注水系统、采油系统、最终采收率等参数的研究 ,获得了油田高效开发的技术界限。     

TORO400E电动铲运机卷缆系统研究

介绍了TORO400E电动铲运机卷缆系统的工作原理及常见故障表现,按照国家标准,对卷缆系统的压力进行调整,计算出阻尼油缸压力调整值。在实际使用中运用,取得了良好的效果。     

Dynamic analysis of the NPP pressure sensor system

The aim of the work was to develop on-line methods of control and diagnostics of pressure sensors at a NPP. The analysis was carried out along two lines:

1. i) The detection system including the sensor itself was modeled theoretically to obtain and study its transfer function, and to establish correspondence between the spectral characteristics of the pressure signal.

2. ii) The numerical processing of the signal using the AR technique to reconstruct the transfer function and evaluate the system's response, to a step impulse, as well as the spectral analysis. The hydraulic model presented indicate that the spectral lines observed at 10 Hz are due to longitu-dinal oscillations of water in the system branches, while the response time of the detection system is effectively the time of signal retardation in the porous ceramic diaphragms of the δ-cell of the sensor itself.

     

车辆TPMS轮速传感器误差消除方法研究

轮胎压力监测系统能够实时地自动监测行驶中汽车的轮胎气压,对于提高行车安全具有重要的意义。基于轮胎压力监测系统硬件平台,阐述了轮速信号的获取,研究了异点剔除方法,提出了基于弹性BP神经网络分析轮速传感器误差的方法,实现了对轮速信号的修正。仿真和实验结果表明,该轮速传感器误差消除方法的精度可达2×10-4rad,能够显著降低传感器误差,提高轮速信号的获取精度。     

高职计算机专业校内生产性实训教学模式研究

校内生产性实训是培养具有高素质技能人才的重要手段与教学形式．其对于提升高职教育内涵、服务经济与社会发展具有重要的意义。分析当前高职院校校内生产性实训的现状、特点与类型,在笔者所在学院的实践基础上,构建计算机专业校内生产性实训的“教、学、生产一体化”的教学模式．