INVESTIGATION OF THE USE OF LASER-DOPPLER VELOCIMETRY IN TWO-PHASE BUBBLY FLOWS

Understanding the dynamic phenomena of viability loss of shear sensitive cells and bubble breakage and coalescence within airlift reactors requires knowledge of local, liquid-phase hydrodynamics. The laser-Doppler velocimeter (LDV) is a non-invasive instrument which may be used to obtain this information. Experimental procedures and software were developed to detect and measure Doppler bursts in two-phase flow in a split-cylinder airlift reactor. Off-line analysis of the data indicated a detection rate approximately one order of magnitude greater than that observed using an available commercial frequency tracker. Approximately 400 to 500 observations are needed for the ensemble mean to characterize the local mean velocity to within ±5% for a superficial gas velocity of 10.4 cm/s, the highest superficial gas velocity used in these studies. The limitations, prospects, and signal-processing options for LDV in this application are also discussed     

环己烷液相无催化剂的氧化动力学研究

采用搅拌釜反应器,在确认已排除传质因素对反应速率影响的情况下,研究了环己烷液相无催化剂的氧化反应动力学。应用自由基理论及最优化计算技术,从导出的8个候选动力学模型中,确定了最佳的动力学模型,它能满意地描述环已烷氧化过程。该动力学可为环己烷氧化工业生产操作条件的优化、反应器的选型及工业设计提供依据。     

Side-chain functionalized liquid crystalline polymers and blends, 10: phase behavior and structure of side-chain liquid crystalline ionomers containing ions of d-metals

Novel side-chain liquid crystalline (LC) ionomers containing d-metals Co(II) and Ni(II) were synthesized and characterized. Both families of the ionomers are characterized by the same influence of charged group content in polymer on their phase behavior. The incorporation of 2-3 mol% of metal ions in the nematic polymer matrix leads to the induction of SmA phase and rise in the clearing point. The peculiarity of their phase behavior in comparison with the earlier investigated LC ionomers with alkaline or alkali-earth metals is the full destruction of the mesophase at the concentration of d-metal higher than 12 mol%. This phenomenon was associated with the well-known ability of the transition metal ions to form various complexes that, in the case of LC ionomers, can negatively influence the ordering of the side mesogenic groups. The proposed structure of the LC ionomers is discussed in comparison with the metallomesogenic polymer systems.     

Growth and characterization of Si doped vapor phase epitaxial GaAs for mesfet

This paper describes the Si-doping of GaAs that was grown using the AsCl₃:H₂:GaAs, Ga Chemical vapor deposition process. The doping sources were AsCl₃:SiCl₄ liquid solutions which proved to be highly reproducible for Si doping within the range, 1×1O¹⁶ to 2×10¹⁹ cm^?3. Incorporation of Si into the GaAs apparently occurs under near equilibrium conditions. This point is considered in detail and the consequences experimentally utilized to grow n, n+ bilayers using a single AsCl₃:SiCl₄ doping solution. Si impurity profiles based upon differential capacitance and SIMS data are presented. These can be very abrupt for n, n⁺ structures with order of magnitude changes occurring within 500 Å. For the 1×10₁₆ to 8×l0¹⁸ cm^?3 doped samples the mobilities at 78 and 298°K are comparable to the higher values reported for GaAs thin films grown by CVD. Power FET devices made from this material have demonstrated an output density of 0.86 watts/mm at 10 GHz.     

Leakage tests for Am solid sources used for liquid xenon detector monitoring

Experimental tests are described to check solid ²⁴¹Am radioactive sources used to monitor operation of liquid xenon detectors. In particular, radioactive leakage was tested in extreme temperature conditions following immersion in liquid nitrogen for different time periods. No radioactivity loss was detected from the sources considered. The paper describes the source characteristics, test methods and results obtained.     

液态金属离子源发射系统电场的模拟分析

发射系统是液态金属离子源的关键部件之一，它的性能的优劣直接影响到整个离子源的工作稳定性和可靠性。因而对其发射系统进行仿真分析，可以很好地指导液态金属离子源的设计制造。本文采用国际上重视的动态喷流柱模型，利用模拟电荷法对液态金属离子源的发射系统的电场进行了计算分析，画出了发射尖端电场强度随不同参数变化的曲线，得出发射尖端表面场强与球冠半径、发射体突出臂长度密切相关，而与引出电极的结构关系甚小的结论，因此液态金属离子源发射特性（如角电流强度）的改善，必须在发射尖的设计制作上下功夫。从而为液态金属离子源的设计提供了一个有效的辅助工具。