聚酰亚胺基纳米氟碳膜的结构和性能研究

利用射频磁控溅射法，以聚四氟乙烯为靶材，在聚酰亚胺(PI)薄膜上沉积纳米氟碳膜。利用扫描电子显微镜(SEM)、透射电子显微镜(TEM)、原子力显微镜(AFM)观察了纳米氟碳膜的表面形貌。通过优化放电条件，在PI薄膜上得到了一层致密均匀的由纳米粒子组成的氟碳膜。利用X射线光电子能谱(XPS)研究了膜的结构及其对放电条件的依赖性。结果表明：这种纳米氟碳膜由-CF3，-CF2，-CF-和-C-4个组分构成。水接触角的测量数据表明：在PI基底上沉积纳米氟碳膜可以提高其憎水性能。     

二氧化硅薄膜材料热传导尺寸效应的实验研究

对微米SiO2薄膜材料沿膜面方向热传导尺寸效应进行了实验研究。结果表明,膜厚从微米数量级的尺寸开始,其传热的热导率就已开始体现出鲜明的膜厚尺寸依赖特性(即sizeeffect),经由微观能量输运理论分析后,得到了实验与理论相吻合的结果。     

Numerical analysis on solidification process and heat transfer of FGH95 superalloy droplets during PREP

In order to understand the relation between microstructure of superalloy powders and its solidification progress, the processing parameters are optimized during plasma rotating electrode processing (PREP). It was predicted from the results that the droplet velocities, droplet temperature, and fractional solidification with flight time about FGH95 superalloy droplet have been carried out based on Newtonian heat transfer formulation coupled with the classical heterogeneous nucleation and the specific solidification process. It has been found that the droplet dynamic and thermal behavior is strongly affected by the distribution of droplet diameters, the proportion of cooling atmosphere, but is relatively unaffected by the droplet superheat.     

纳米二氧化钛薄膜光催化降解性能的研究

采用液相沉积法制备了纳米TiO2薄膜。研究了煅烧温度、膜厚、紫外光强、掺入Fe^3 等因素对纳米TiO2薄膜的光催化降解性能的影响。研究结果表明，煅烧温度450℃、膜厚150nm的条件为佳。采用上述最佳条件制作了光催化反应器。用此光催化反应器对硝基苯酚的光催化降解进行了研究。在选定的降解条件下,质量浓度为30mg／L的对硝基苯酚经过45min降解，降解率可达94．5％。     

TiN薄膜厚度对耐磨性影响的研究

利用空心阴极离子镀膜机在碳钢上制备TiN薄膜，采用销-盘式磨损试验机，在润滑条件下，研究不同厚度TiN薄膜的耐磨性．结果表明：TiN薄膜厚度低于1μm时薄膜易碎，高于2μm时耐磨性明显提高．     

自腐蚀电位、平衡电极电位关系E_e~m

班朝磊  杨建桥 《陕西科技大学学报》2003,(5)

Novel screen technology for high‐contrast front‐projection display by controlling ambient‐light reflection

Abstract— One problem with front‐projection displays is that the screen contrast ratio decreases in bright ambient light. In this paper, we propose a new front‐projection display system that incorporates the control of reflection of ambient light in the screen design, providing a high contrast ratio even in a brightly lit room.     

Organic‐polymer thin‐film transistors for active‐matrix flat‐panel displays?

Abstract— Organic‐polymer‐based thin‐film transistors (OP‐TFTs) look very promising for flexible, large‐area, and low‐cost organic electronics. In this paper, we describe devices based on spin‐coated organic polymer that reproducibly exhibit field‐effect mobility values around 5 × 10^?3 cm²/V‐sec. We also address fabrication, performance, and stability issues that are critical for the use of such devices in active‐matrix flat‐panel displays.     

半导体薄膜生长实时监控系统的设计与应用

文章分析了半导体薄膜生长工艺流程的特点。在此基础上，为实验室的ECR—MOCVD设备设计了一套半导体薄膜生长的实时监控系统，介绍了系统的硬件结构以及在WIN98环境下用VB6．0实现生长实时监控系统软件的实现方法。经实验证明，系统保证了工艺流程的连续可靠运行，实验数据的可靠性和工艺流程的可重复性也大大提高，使用方便，降低了试验人员的劳动强度，实现了预期的设计目标。     

管载二氧化钛凝胶镀膜光催化清除乙烯气体

报道了用sol gel方法在玻璃管上制备二氧化钛薄膜对清除乙烯气体的光催化实验,研究了二氧化钛一次镀膜对乙烯浓度随催化反应时间的变化关系。结果发现,二氧化钛镀膜有较好的清除乙烯的效果,当反应进行到46h时乙烯气体的色谱峰完全消失,即乙烯气体已经被完全清除掉,对相同处理条件下的二氧化钛粉体做XRD分析知该条件下的二氧化钛为锐钛矿晶型。