液相水解法合成金红石型TiO2

提出的钛液反应水解法，改变了传统的外加晶种存在下具有工业意义的水解过程。该法无须外加晶种，选择了以酒石酸，聚丙烯酰胺为沉淀剂，絮凝剂，在常压下使钛液直接长温水解，液相共沉淀制备金红石型ＴｉＯ２。还研究了反应条件，分析了产品的特性。     

Surface‐initiated atom transfer radical polymerization from Mg(OH)2 nanoparticles to prepare the well‐defined polymer‐Mg(OH)2 nanocomposites

Well‐defined polymer‐Mg(OH)₂ nanocomposites were prepared by atom transfer radical polymerization (ATRP). The ATRP initiators were covalently attached to the Mg(OH)₂ by esterification of 2‐chloropropionyl chloride with hydroxyl group. The amount of polymer grafted from Mg(OH)₂ can be controlled using a different catalyst system and adding a small amount of polar solvent. The well‐defined diblock copolymer, consisting of poly(styrene) (PS) and poly(methyl methacrylate) (PMMA) were synthesized. The products were characterized by nuclear magnetic resonance, Fourier transform infrared, differential scanning calorimetry, and thermal gravimetric analysis. The morphologies of PS/PMMA and PS/PMMA/Mg(OH)₂‐g‐PS‐b‐PMMA blends are compared by using a scanning electron microscope. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 103: 3680–3687, 2007     

2-氯乙基氨基甲酸乙酯气相色谱分析

采用气相色谱法，柱填充物为3％OV-101涂渍在Chromosorb W AW DMCS080～250μm）上，柱温：190℃，气化室：230℃，检测室：230℃；内标物为联苯，用内标法对2-氯乙基氨基甲酸乙酯有效成分进行分离和检验。方法标准偏差≤0．31，变异系数〈0．32，平均回收率为99．86％。     

4-甲氧基苯乙腈的又一种合成法

以4-羟基苯乙酰胺为原料,经甲基化和脱水两步反应合成了4-甲氧基苯乙腈,总收率76.5%。     

"十五"期间国内石油化学工业发展梗概

概述了我国目前石油和化学工业的现状,与发达国家相比存在的主要差距,以及"十五"期间发展思路和规划目标.     

Electrochemical investigation of LiNi0.5Mn1.5O4 thin film intercalation electrodes

This work provides kinetic and transport parameters of Li-ion during its extraction/insertion into thin film LiNi_0.5Mn_1.5O₄ free of binder and conductive additive. Thin films of LiNi_0.5Mn_1.5O₄ (0.2 μm thick) were prepared on electronically conductive gold substrate utilizing the electrostatic spray deposition technique. High purity LiNi_0.5Mn_1.5O₄ thin film electrodes were observed with cyclic voltammetry, to exhibit very sharp peaks, high reversibility, and absence of the 4 V signal related to the Mn³⁺/Mn⁴⁺ redox couple. The electrode subjected to 100 CV cycles of charge/discharge delivered a capacity of 155 mAh g⁻¹ on the first cycle and sustained a good cycling behavior while retaining 91% of the initial capacity after 50 cycles. Kinetics and mass-transport of Li-ion extraction at LiNi_0.5Mn_1.5O₄ thin film electrode were investigated by means of electrochemical impedance spectroscopy. The apparent chemical diffusion coefficient (D_app) value determined from EIS measurements changed depending on the electrode potential in the range of 10⁻¹⁰-10⁻¹² cm² s⁻¹. The D_app profile shows two minimums at the potential values close to the peak potentials of the corresponding cyclic voltammogram.     

2，6－二氯－4－硝基苯胺的合成

以盐酸－过氧化氢为氯代试剂，由对硝基苯胺制备了２，６－二氯－４－硝基苯胺。结果表明，过氧化氢的比例、反应温度对收率有较大的影响。过氧化氢过量，反应温度在５０℃时，可缩短反应时间，提高收率。     

碳纤维经氧等离子/KH550处理后的表面形态和结构

碳纤维(CF)表面经氧等离子、KH550和 LiAlH_4处理后,其物理和化学性能得以改善.由于提高了 CF 和树脂间的联结,使 CF 复合材料的层间剪切强度提高50%以上,在湿热下的强度保留率达94%以上.使用纤维接触角测定仪,SEM 和 XPS 等对 CF 表面的浸润性、形态和化学组成进行了研究.实验指出:CF 经等离子和 KH550处理后,其临界表面能有了提高;CF 本身仅受氧离子刻蚀,故其拉伸强度的损失小于其他处理方法.     

4-乙酰氧基氮杂环丁酮的合成工艺研究

以6-氨基青霉烷酸(6-APA)为原料,经溴代、酯化、格氏反应、还原、羟基保护、开环、氧化断裂等步骤得到目标产物,反应总收率达27.9%。