环保型木器涂料

介绍水性和紫外光固化两类环保型木器涂料及其研究进展。水性木器涂料主要为丙烯酸酯与聚氨酯两大类，其研究进展集中表现为乳液改性，包括自交联、共混共聚、微乳液等；紫外光固化木器涂料包括其光固化树脂、活性稀释剂和光引发剂的功能及进展；指出研究新型乳液以提高水性木器涂料涂膜的表面性能，开发新型原材料以降低紫外光固化木器涂料的成本、扩大适应范围将成为今后环保型木器涂料的研究重点。     

Preparation of fluoroacrylate nanocopolymer by miniemulsion polymerization used in textile finishing

Latex based on fluoroacrylate (TAN) and other comonomers was prepared via miniemulsion polymerization in the presence of stearyl trimethyl ammonium chloride (STAC) and 2, 2′‐azobis (2‐amidinopropane) dihydrochloride (ABAP) as a water soluble initiator. Light transmittance studies demonstrated that the light transmittance of prepared emulsions increases with the amount of TAN, STAC, cosolvent DPM, and hydrophobe DM. Given suitable reaction temperature and quantities of TAN, STAC, DPM, and DM, a copolymer emulsion of fluoroacylate with a particle size of 50 nm was produced. The water repellency tested on polyester fabrics displayed greater effectiveness than that of commercial products with higher fluorine content. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 94: 1466–1472, 2004     

An improved light attenuation technique for measuring large interfacial areas

A laser-based light attenuation technique was successfully used to measure interfacial areas as high as 5832 m²/m³ and Sauter mean bubble diameter varying between 50 and 5600 μm. Good agreement between this approach and the photographic technique was obtained particularly at low gas holdups.     

异氰酸酯改性光敏水性环氧丙烯酸酯的合成

以双酚A型环氧树脂与丙烯酸反应合成了具有羟基侧基的环氧丙烯酸酯，再用甲苯二异氰酸酯与内烯酸-β-羟乙酯的半加成物对上述环氧丙烯酸酯树脂进行接枝改性，再用酸酐引入羧基，经胺中和后，水性化．可得较为稳定的自乳化光敏树脂水分散体系。通过化学测试和IR解析．确定了合成条件、合成终点及产物结构，并以此为基料配成紫外光固化涂料，所得涂层性能优异。     

可见光响应的"Cu核- Cu2O壳"型光催化剂性能的研究

以碱性染料结晶紫为目标污染物,金属卤化物灯为可见光光源,研究了自制的"Cu核-Cu20壳"微粒的光催化性能.实验结果表明,该催化剂对可见光有良好的响应,当固液比为1500,光照120min,质量浓度为60mg/L的结晶紫溶液色度和COD去除率分别达98%和92%.检测结果表明,光催化过程中有氢氧自由基产生,染料发生了彻底的降解.     

大面积水域浓度场测试方法及系统研究

针对大面积水域浓度场难以实现实时测量、测量精度不高等问题,采用了一种多通道荧光测试系统和方法。首先,基于单色光诱导荧光检测浓度(LIF)原理,使用探头获取离散点的浓度参数。然后,经总线或通信网络技术,将数百个测点连接起来。最后,通过数据总线或网络将采集的数据输送到中央测控计算机中,处理离散的数据后形成完整的浓度场。在恒定流浓度场中的试验结果表明,污染物测量相对误差均值不超过5%,单次测量相对误差最高值为8.33%,传感器线性度不超过5%,可检测的荧光素钠溶液浓度分辨率为0.001 ppm,系统测量稳定、精度较高。相较于其他浓度测量方法,该系统具有测量面积大、实时测量的优势,可为水污染防治等领域提供可靠的技术支撑。     

Efficient and color pure blue light emitting random copolymer with fluorene and fluorenylstilbene

A blue electroluminescent polymer, random copolymer of fluorenylstilbene and fluorene, was prepared by the nickel catalyzed coupling reaction. The structure and properties of the copolymer were analyzed by various spectroscopic methods. The obtained polymer had good solubility and thermal stability with high T_g. The polymer in thin film emits strong blue luminance (max=468 nm) with narrow bandwidth upon photoexcitation. PL spectrum of the polymer in the film is almost consistent with that of solution one as well as the EL spectrum, indicating that the aggregation and the excimer fluorescence are suppressed by the introduction of fluorenylstilbene comonomer. Moreover, the introduction of fluorenylstilbene comonomer lowered the oxidation potential to lead feasible hole injection, when the compared with poly(fluorene) homopolymer. The ITO/PEDOT/polymer/LiF/Al device showed the maximum brightness of 3500 cd/m² with a turn on voltage of 4.4, the maximum efficiency of 0.878 lm/W and blue emission with CIE chromaticity coordinates of ((x,y)=(0.17, 0.25)).     

高分子金属配合物发光材料的制备技术进展

高分子金属配合物发光材料是一类很有价值的功能材料,评述了有关它的各种合成方法。以金属离子与含配位基团的聚合物进行反应,容易在高聚物之间形成交联,难以获得发光强度高的高分子配合物;使金属离子与高分子配体和小分子配体同时作用,可以得到荧光强度比较理想的产物,但反应难以定量控制;以小分子金属配合物单体与某些单体之间进行共聚合反应,也可获得荧光强度较高的高分子配合物,但聚合反应的空间位阻较大;通过两端都含有配位基团的刚性链的有机小分子配体直接与金属离子配合形成高分子金属配合物;以小分子金属配合物单体进行均聚或者将小分子金属配合物接枝到高聚物上也可以形成高分子金属配合物。     

氮掺杂纳米TiO_2改性涂料及其抗菌性能

将自制的氮掺杂锐钛矿型纳米二氧化钛光催化剂作为功能性组分,加入耐光催化氧化的硅丙乳胶涂料中,制备出一种新型光催化功能性建筑涂料,实现了可见光光催化效应。使用紫外-可见光吸收光谱研究该功能性涂料对紫外线的吸收能力;采用菌落计数法研究该涂料在可见光照射下对金黄色葡萄球菌的杀灭性能。同时分析了纳米粉体种类、引入量及方式对涂料紫外线的吸收性能和抗菌性能的影响。     

Long-term weathering behavior of UV-curable clearcoats: Depth profiling of photooxidation,UVA, and HALS distributions

The long-term weathering performance of two UV-curable clearcoat systems was studied using in-plane microtomy in combination with infrared spectroscopy, UV spectroscopy, and ESR spectroscopy. Oxygen transport characteristics were also studied using the half-time method. The photooxidation versus depth profile was highly dependant on the presence of hindered amine light stabilizers (HALS) for both coating systems. Ultraviolet light absorbers (UVA) had little effect on the photooxidation profile. A photooxidation gradient was formed in both clearcoats due to a reduction in oxygen solubility when compared to standard thermoset clearcoats. This gradient was only seen in formulations not containing HALS. Presented at the 82nd Annual Meeting of the Federation of Societies for Coatings Technology, on October 27–29, 2004, in Chicago, IL.