Thermodynamic Analysis of Various Dehumidifying Dryers for Wood

Typical methods of dehumidification of air circulating in the dehumidifying driers (indirect and direct cooler and partial exchange of the air) were analysed. Energy aspect of cooler operation was evaluated. The method for minimization of unit thermal energy consumption in a dehumidifying drier by the optimal selection of the cooler point was also given. Methods of the heat recovery of heat conveyed in a cooler lending to save energy (heat regeneration. expansion and compression of the air, a dehumidifier) were analysed. It was indicated that introduction of dehumidifiers into contemporary wood driers caused significant improvement of energy aspects of their operation     

沈阳太平洋广场空调冷热源方案比较

对一幢１１．５万ｍ＾２的四星级综合建筑的空调冷热源不同的蓄冷和取冷比较了四种方案，论证了其中直燃型溴化锂吸收式冷热水机组供冷供暖、小型燃油锅炉供蒸汽的方案最为合理。     

含氮化合物废气选择性催化氧化技术研究进展

通过对当前含氮化合物废气治理技术的对比分析,总结选择性催化氧化的相关技术优势。根据对含氮化合物的种类及来源分析,介绍氨气、腈类、胺类及其他含氮化合物的催化净化技术。重点总结催化剂的种类、研发进展和在实际使用中可能遇到的问题,同时展望含氮化合物废气选择性催化氧化技术的研发方向。     

三维定量储层地质模型与参数动态预测方法

提出了三维定量储层地质模型及其参数动态预测方法，用该方法可预测储层开采状态，水淹区及剩余油区分布和各剩余油区的可采储量，三维定量储层地质模型的预测图件可为合理开采提供依据。     

The effect of pre-wetting on dynamic contact angles

A roll-coating experimental system is used to study the effect of pre-wetting on dynamic contact angles, the interfacial displacement depth, and the associated phenomenon of air entrainment. The system consists of a roll, which is horizontally rotating in a liquid pool. The dynamic contact angle is recorded by a macrophotography system. The test liquids are glycerol solutions with viscosities in the range 104 < μ < 748 mPa · s. The value of (μV/ρg)^0.5 is taken as the characteristic length to be used in the dimensionless relationships which correlate experimental measurements. The effect of base layer entry angle into the liquid pool on the dynamic contact angles and other flow parameters is studied. Comparison is made with measurements in dry tape-coating and other pre-wet roll–coating systems.     

氢/空气火焰在半开口有障碍管道中的传播特性

针对氢／空气混合物，通过实验研究了其预混火焰在半开口管道中的火焰传播加速现象。结果表明，火焰传播状态随着氢气当量比的变化而发生改变。当氢／空气混合物被点燃后，由于障碍物的扰动，火焰在管道中不断加速传播，并最终到达一准稳态传播。在氢气当量比0．34附近时，火焰速度发生跃变。当氢气当量比足够大时，火焰传播由爆燃态转变为爆轰态。在本实验条件下，爆燃转准爆轰的临界条件是d/λ=2.6(d是圆环形障碍物内径，λ是爆轰格胞尺度）。障碍物阻塞比的变化对最大火焰速度和压力提升的影响不明显。     

某医院净化手术部空调设计

介绍了各净化间的设计参数，送、回、排风系统和自控系统的设计，以及运行情况。探讨了基于手术部湿度优先控制模式下的新风系统的设计及控制。     

风冷冷水机组室内安装方案的探讨

结合实际工程，介绍风冷冷水机组在工程应用中置于建筑转换层或建筑内的设计，并对风冷冷水机组室内安装的设计进行探讨。     

一种低频 空间定向及高灵敏遥感方法研究

本文提出一种低频、空间定向及高灵敏的遥感方法。文中介绍了传感器及其二次仪表设计原理和关键技术。由作者研制的本检测系统,在空气中的定向接收灵敏度,离1米处高达120mV/μPa,比HP4905A型机的输出信噪比高8倍.