阳离子型聚丙烯酰胺絮凝剂的开发与应用

阳离子型聚丙烯酰胺具有许多优点，极具开发研究价值，是重要的高分子絮凝剂。介绍了阳离子型聚丙烯酰胺絮凝剂的制备方法，应用及其絮凝作用机理，并分析了其发展方向。     

有机硅改性水性阳离子聚氨酯的合成与性能研究

本研究合成了有机硅改性的阳离子聚氨酯乳液,有机硅的加入改善了漆膜的耐水性、漆膜光泽性和手感,随着有机硅的加入量的增加,漆膜的耐水性提高、吸水率下降,热重分析表明漆膜耐热性提高,FTIR表明乳液中不存在NCO。     

新型阳离子聚合物NCP的合成及应用

介绍了用高分子反应法在固态条件下合成高阳离子度阳离子聚合物NCP的方法,确定了其最佳反应条件,测定了聚合物阳离子度和反应效率.采用L9（34）正交试验法得出合成NCP的最佳反应条件为：聚合物与阳离子化试剂质量比为11：3;催化剂用量为1.072%,反应时间为2.5 h;反应温度为80℃.实验结果表明,在反应体系中加入催化剂和少量有机或无机溶剂可显著提高反应速率和效率;使用少量润湿剂,可最大限度地限制副反应,造成反应部位的局部浓度高,提高反应效率.阳离子聚合物NCP可作为增粘降滤失剂用于配制正电性钻井液,效果优良,且耐温性能良好,同时基于阳离子与阴离子聚合物在溶液中生成凝胶状沉淀物的特性,NCP还可用于解决注聚区块生产井产出水中含高浓度聚合物的问题.     

Cationic ring-opening polymerization of hexamethylcyclodisilazane: General aspects and tentative mechanisms

The ring-opening polymerization of hexamethylcyclodisilazane (D_2NMe), initiated by methyl triflate in 1,2-dichloroethane, forms in the first, fast kinetic step both linear polymer and cyclic dimer (D_4NMe). Subsequently a slow depolymerization process occurs leading to exclusively cyclotrisilazane (D_3NMe). On the basis of kinetic measurements carried out using an adiabatic calorimetric technique and complementary experiments, mechanisms of both propagation, cyclization and back-biting reactions are proposed. The influence of the reaction temperature was also studied; it is demonstrated that, at low temperature, polymerization does not lead to cyclic oligomer formation. In such conditions, the polymerization presents a ‘living’ character.     

有机电沉积涂料的新动向

阴极电沉积涂料是 2 0世纪 70年代以来发展起来的一种新的涂装方法 ,具有挥发性有机物 (VOCs)和有害空气污染物(HAPs)含量低、防蚀能力强、漆膜质量好、涂料利用率高、适合涂装结构复杂的构件和设备等特点。介绍了近年来阴极电沉积涂料研发的新动向。它们主要集中在有机双层电涂和高分子 聚电解质 /低聚物电解质复合物多层电涂体系 ,这些新的电涂体系在涂料的稳定性以及涂层的物理化学性质和力学性能方面具有明显的改进。     

Maghnite‐H+, a solid catalyst for the cationic polymerization of α‐methylstyrene

The polymerization of α‐methylstyrene (AMS) catalyzed by Maghnite‐H⁺ (Mag‐H) was investigated. Mag‐H is a montmorillonite sheet silicate clay, exchanged with protons. It was found that the cationic polymerization of AMS is initiated by Mag‐H at ambient temperature in bulk and in solution. The effect of the amount of Mag‐H, the temperature, and the solvent was studied. The polymerization rate increased with increase in the temperature and the proportion of catalyst, and it was larger in nonpolar solvents. These results indicated the cationic nature of the polymerization. It may be suggested that the polymerization is initiated by proton addition to monomer from Mag‐H. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

吸水膨胀型膨润土/交联聚丙烯酰胺颗粒堵剂

使丙烯酰胺、少量N，N-亚甲基双丙烯酰胺在钙膨润土存在下进行水溶液引发接枝共聚合，聚合产物经造粒、粉碎、筛分，得到粒径0．5～1．0mm的颗粒堵剂。根据颗粒堵剂吸水量大小确定丙烯酰胺与膨润土最佳质量比为7：1，引发剂最佳用量为500g／t，交联剂最佳用量为300g／t，吸水量与这3个参数之间的关系曲线都经过最大值，颗粒堵剂在去离子水中的吸水量为560～650mL/g。该堵剂已大规模生产，在胜利、中原油田许多采油厂已用于调剖、堵水和调驱施工，在青海、江苏、大港、冀东等油田也已开始使用。在胜利东辛采油厂的一个井组，连续3个月在3口井注入该堵剂共27t，使井口压力上升3MPa，产油量大幅度增加。表l参l。     

颗粒表面改性法制备PTC粉体的研究

本文介绍了一种通过液相颗粒表面改性技术添加二次掺杂物来制备ＰＴＣ粉体的新方法。即将烧结助熔剂Ａｌ２Ｏ３，ＳｉＯ２以及受主杂质ＭｎＯ采用溶液形式，包裹在ＢａＴｉＯ３基粉体颗粒表面进行改性，由此可以得到二次掺杂物Ａｌ２Ｏ３、ＳｉＯ２和ＭｎＯ分布均匀的ＰＴＣ粉体。     

Photoinitiated cationic polymerization using a novel phenacyl anilinium salt

A novel phenacyl anilinium salt, N-phenacyl, N,N-dimethylanilinium hexafluoroantimonate, (PDA), has been synthesized and used as photoinitiator for cationic polymerization of cyclohexene oxide (CHO), butyl vinyl ether (BVE) and N-vinyl carbazol (NVC). Plausible mechanism of the photoinitiation involves the decay of the excited PDA with both heterolytic and homolytic cleavages of carbon-nitrogen bond. Thus, phenacylium cations formed directly or subsequent intermolecular electron transfer, respectively, initiate the polymerization.