The Effect of Moisture Content on the Conversion of Ergosterol to Vitamin D in Shiitake Mushrooms

The distribution of ergosterol in different parts of shiitake mushrooms was studied in order to optimize the conversion of ergosterol to vitamin D₂ during drying. The effect of moisture on the conversion of ergosterol to vitamin D₂ was also investigated by adjusting the moisture content of fresh mushrooms to different levels in a large vacuum desiccator and subjecting them to UV irradiation at 290-320 nm wavelength, for 2 h. The moisture, ergosterol and vitamin D₂ contents were determined using standard procedures. It was found that the ergosterol content on a dry matter basis of fresh shiitake mushroom was highest in the gills (10.6 ± 0.99 mg/g DM), followed by the cap or pileus (5.34 ± 0.64 mg/g DM) and was least in the stalk or stipe (2.97 ± 0.56). The moisture content had a marked influence on the conversion of ergosterol to vitamin D₂, the best conversion taking place at a moisture content of about 70% on a wet basis.     

纯铜双层辉光离子渗钛组织形成机理及性能分析

采用双层辉光离子渗金属技术对纯铜进行了渗钛处理。用配有能谱仪(EDS)的扫描电子显微镜(SEM)、X射线衍射仪和透射电子显微镜对合金层的显微组织形貌、钛含量分布、相组成及相结构类型进行了观察与测定，对合金层的形成机理进行了探讨，并对其性能进行了对比测定。结果表明：渗钛层由合金层和扩散层组成，合金层主要由TiCu (Cu)固溶体 TiCu4构成，TiCu4为Dla型有序相，TiCu为B2型有序相，扩散层为(Cu)固溶体。渗钛处理后纯铜的表面得到显著强化。     

On the permeation rate of copper extraction through liquid membranes

The understanding of the permeation rate of metal ions through liquid membranes is important for the design of such systems. In this paper, the permeation rates of copper ions through liquid surfactant membranes, including interfacial reaction rates and the diffusion rate of the copper ion, were analyzed using a model based on a mobilized hollow spherical globule configuration. The analysis shows that the extracting reaction is dominant at the external interface of the membrane and the stripping reaction is dominant at the internal interface; this means the reactions at both interfaces are not in equilibrium during the course of extraction. It also shows that the extraction rate, the diffusion rate and the stripping rate are not of equal value, especially at the early stage of the run.     

Growth and characterization of barium copper oxalate single crystals in gels

Barium copper oxalate was grown in silica hydrogel at ambient temperature. The effect of various parameters like gel pH, gel density, gel aging and concentrations of reactants on the growth of these crystals was studied. The crystals grown were characterized by chemical analysis, X-ray powder diffractometry, infrared spectroscopy, thermogravimetric and differential thermal analysis. The results of these observations are described and discussed.     

The initial behaviour of freshly etched copper in moderately acid, aerated chloride solutions

When freshly etched samples of various types of copper were exposed in moderately acid, aerated chloride solutions, two phenomena were observed. First the corrosion potential and the pH of the solution decreased over a shorter time, then the potential increased over a long period (600-1500 min), following an s-shaped pattern. Increase in pH during the second stage was avoided using a pH-stat. The corrosion rate increased little or not at all over the entire period. A tentative interpretation of the short-term behaviour is presented with some reservation. The long-term development of the potential suggests phase formation or transformation following the Avrami pattern. By suitable derivations it was possible to fit the development of potentials to the Avrami equation. Subsequent examinations by Auger spectroscopy proved the presence of thin layers of Cu₂O on the copper surfaces, increasing in thickness with exposure time. The dissolution kinetics can be described in terms of two parallel electrochemical reactions and a simultaneous non-electrochemical dissolution reaction.     

UL简介与CCL认可

本文从六个方面对UL的基本知识作了一个简要的概述及CCL认可过程的介绍,希望能为业界同仁提供一个参考方向。     

对未来我国覆铜板业技术发展的战略与任务的探讨

对未来十年我国覆铜板业技术发展的战略与技术开发重点任务进行了探讨。     

用热失重法确定水合粘土水分含量及存在形式

文章以蒙脱土为例，采用热失重法定性定量确定了水合粘土中结合水类型、界限及其相对含量，并与等温吸附法结果进行了对比。结果表明，用该方法得到的水合蒙脱土中各种水分的相对含量及总含水量与等温吸附实验结果相一致。热失重（25~250 ℃）分析结果表明，水合蒙脱土中水分子主要存在自由水、松散吸附结合水、紧密吸附水（强吸附结合水）3种状态，分别对应于25~75 ℃、75~120 ℃、120~230 ℃区间里的失水。从热失重（25~250 ℃）规律来看，仍存在两个明显的转折点p/ps=0.9、0.98，它们为粘土-水体系的两个特征湿度，前者为粘土表面强结合水与松散结合水（渗透结合水）之间的界限，后者为松散结合水与自由水之间的界限，这验证了等温吸附法确定的两个特征湿度及对粘土表面结合水界限划分的正确性。     

精密铜带圆盘纵剪机

通过对精密铜带圆盘剪切机的工作原理和工艺过程进行研究，对引进的美国剪切机进行了技术改造，设计制作了新的装置，实现了软态铜带的剪切。     

L520型智能中子仪测定农田土壤含水量的标定研究

通过对L520型智能中子仪测定农田土壤含水量的标定研究，在试验区草甸土类型的土壤中，在0～100cm的土层中得到了一条标定土壤含水量的回归直线，用此法测定土壤含水量较重量法快捷方便且误差小。