全文获取类型
收费全文 | 7467篇 |
免费 | 530篇 |
国内免费 | 281篇 |
专业分类
电工技术 | 14篇 |
综合类 | 361篇 |
化学工业 | 1325篇 |
金属工艺 | 83篇 |
机械仪表 | 54篇 |
建筑科学 | 62篇 |
矿业工程 | 46篇 |
能源动力 | 114篇 |
轻工业 | 3435篇 |
水利工程 | 10篇 |
石油天然气 | 2425篇 |
武器工业 | 1篇 |
无线电 | 28篇 |
一般工业技术 | 92篇 |
冶金工业 | 155篇 |
原子能技术 | 7篇 |
自动化技术 | 66篇 |
出版年
2024年 | 72篇 |
2023年 | 142篇 |
2022年 | 237篇 |
2021年 | 258篇 |
2020年 | 320篇 |
2019年 | 284篇 |
2018年 | 236篇 |
2017年 | 270篇 |
2016年 | 283篇 |
2015年 | 266篇 |
2014年 | 397篇 |
2013年 | 549篇 |
2012年 | 604篇 |
2011年 | 543篇 |
2010年 | 381篇 |
2009年 | 372篇 |
2008年 | 314篇 |
2007年 | 443篇 |
2006年 | 413篇 |
2005年 | 323篇 |
2004年 | 272篇 |
2003年 | 224篇 |
2002年 | 202篇 |
2001年 | 181篇 |
2000年 | 134篇 |
1999年 | 125篇 |
1998年 | 102篇 |
1997年 | 67篇 |
1996年 | 60篇 |
1995年 | 65篇 |
1994年 | 37篇 |
1993年 | 15篇 |
1992年 | 17篇 |
1991年 | 11篇 |
1990年 | 6篇 |
1989年 | 7篇 |
1988年 | 6篇 |
1987年 | 4篇 |
1986年 | 7篇 |
1985年 | 11篇 |
1984年 | 3篇 |
1983年 | 3篇 |
1982年 | 2篇 |
1980年 | 5篇 |
1978年 | 2篇 |
1977年 | 2篇 |
1972年 | 1篇 |
排序方式: 共有8278条查询结果,搜索用时 15 毫秒
21.
废电解液除杂制取硫酸铜和粗镍 总被引:1,自引:0,他引:1
介绍了废电解液除杂制取硫酸铜和粗镍的主要工艺条件及试验结果。在废电解液中加入CH80调节pH值到一定范围后,再加入CH64将电解液中Fe2+等杂质除去,铁的去除率可达到94%~98%。然后向滤液中加入CH80调节pH值沉淀铜。过滤后的滤饼用H2SO4溶解后再结晶,可得到CuSO4·5H2O晶体。滤液中加入Na2CO3沉淀镍,过滤后的滤饼即为粗镍(NiCO3)。铜和镍的回收率分别达96%和90%。该流程简单,投资少,效益高,环境保护好,在工业上有较广的应用前景。 相似文献
22.
降凝剂对高蜡稠油的改性效果及机理研究 总被引:5,自引:0,他引:5
实验研究了工业品原油降凝剂WHP改善含蜡56.9%、其中96.6%为正构烷烃的胜利郑王庄稠油流动性的效果。WHP含乙烯/醋酸乙烯/乙烯醇嵌段聚醚三元共聚物30%-35%。在60℃将WHP加入稠油中,测定其凝点和32℃、0-42.6 s^-1范围5个剪切速率下的黏度,均随WHP加量的增加(50-300 mg/L)而降低,200 mg/L为最佳加量,在该加量下0.32 s^-1黏度由34.16 Pa·s降至79.2 mPa·s,凝点(℃)、屈服值(Pa)、稠度系数(Pa·s^n)分别由49.0、32.42、31.57降至39.5、0.1297、0.02142,流型指数由0.1176升至0.9790。由黏温曲线求出,加入200mg/L WHP使该稠油析蜡点由65℃降至58℃,反常点由70℃降至50℃。根据空白和加剂原油扫描电镜照片显示的蜡晶形态,利用共晶机理分析讨论了WHP这种高分子表面活性剂的降凝、降黏、改善流动性的作用。图3表3参5。 相似文献
23.
蒸馏与减粘热联合装置的设备腐蚀及防护 总被引:4,自引:2,他引:2
介绍了锦西石化分公司南蒸馏与减粘热联合装置炼制辽河高酸值原油及带炼高硫进口油在 2 0 0~40 0℃范围内对设备、管线和阀门的腐蚀特点、腐蚀机理以及针对高温环烷酸腐蚀所采取的防护措施。通过试验和理论分析 ,提出了应用新材料和新工艺解决减粘后高温渣油系统的腐蚀及低温露点腐蚀的建议 相似文献
24.
储层石蜡沉积预测技术研究与应用 总被引:1,自引:0,他引:1
在油田开发过程中 ,由于油藏温度、压力等条件的变化 ,高含蜡原油在近井带容易产生石蜡沉积 ,堵塞地层孔隙或裂缝 ,严重影响油田开采 ,尤其对于低渗油田 ,伤害特别严重。文中应用理想溶液理论、质量守恒和能量守恒等基本原理 ,建立更符合油田实际情况的油藏中石蜡沉积预测数学模型 ,开发一套方便实用的油藏中石蜡沉积预测软件系统FPOS1 0。在此基础上 ,应用室内实验数据和现场数据对吉林新民油田油井石蜡沉积情况进行预测和现场拟合 ,确定新民油田临界石蜡沉积半径为 2 5m ,快速、准确地为现场清防蜡措施提供理论依据。 相似文献
25.
常减压蒸饱装置几起典型硫腐蚀事例分析 总被引:1,自引:1,他引:0
随着高(含)硫原油加工量的增加,硫腐蚀事故也时有发生。通过对常减压装置硫腐蚀事例进行分析,指出合理的混炼比,加强“一脱三注”管理,材料升级和实施腐蚀监测是防止腐蚀事故发生的有效措施。 相似文献
26.
分别以94%品位高钛渣和90%品位高钛渣为原料,采用沸腾氯化工艺制备粗TiCl4,分析了两种品位高钛渣对沸腾氯化工艺的影响。结果表明:94%品位高钛渣由于其活性低而对沸腾氯化工艺的影响较大。 相似文献
27.
The presence of chlorophylls in vegetable oils is considered undesirable due to their adverse effects on oxidative deterioration, bleachability and hydrogenation. The usual methods for determination of chlorophylls in vegetable oils are absorption spectrophotometry, fluorometry and liquid chromatography using fluorescence detectors. This paper outlines a fluorometric method using a laser as the excitation source. The chlorophylls in crude palm oil, rapeseed oil, soya bean oil and olive oil were determined directly by laser-based fluorometry using (a) a helium-neon laser (632-8 nm, 5 mW) as the excitation source and an optical-multichannel analyser (OMA) with an intensified diode array as the detector, and (b) a helium-neon laser and a photomultiplier tube as the detector. The method is especially suitable for the detection of chlorophylls in crude palm oil since no pre-extraction step is required. The levels of chlorophylls measured in vegetable oils using the laser technique was also compared against values obtained by conventional spectrophotometric methods. The simplicity and rapid quantification of laser based fluorometry suggest that this technique can be readily applied to the detection or a wide variety of fluorescing species in vegetable oils. 相似文献
28.
介绍了火烧山原油的物性与破乳剂结构和配比的关系、TA1031破乳剂的室内脱水评价及性能特点、TA1031的现场应用效果、破乳剂现场用药量与室内最佳用药量的关系、原油现场脱水过程中破乳剂用药量与污水含油的关系。 相似文献
29.
原油沥青质沉积引起储集层损害的室内评价 总被引:1,自引:1,他引:0
防止沥青质沉积造成的储集层损害是渤海稠油油藏开发生产中遇到的技术难题之一。结合渤海SZ36-1油田实际情况,使用岩心流动实验装置,建立沥青质沉积导致储集层岩心渗透率下降的室内评价方法,并应用SARA法对稠油发生沥青质沉积的可能性进行预测。评价实验结果表明,损害程度与沥青质沉积量和储集层岩心的原始渗透率有关。沉积量越大,原始渗透率越低,则损害越严重。表5参12 相似文献
30.
Jos A.D. Muoz Antn Alvarez Jorge Ancheyta Miguel A. Rodríguez Gustavo Marroquín 《Catalysis Today》2005,109(1-4):214-218
The present paper focuses on the study of process alternatives for heat integration of a heavy crude oil hydrotreatment plant. Experimental information obtained from a pilot scale, kinetics and reactor modeling tools, and a commercial process simulator were employed to develop mass and energy balances. Four study cases, which employ a combination of quenching and heat exchangers, were identified and evaluated. The results indicated that the case with two quenches with hydrogen and three heat exchangers is the best process heat integration (PHI) option from an energetic point of view. 相似文献