Alternating,all-trans polyenynes: Model compounds for poly(diacetylene)s with defined conjugation length

The syntheses of polyenynes as model compounds for poly(diacetylene)s (PDAs) are described. Variation of properties (UV–VIS, Raman, NMR and bond geometries) as a function of the chain length was investigated. After extrapolation to infinite chain length these data were compared to those for PDAs. From UV–VIS spectra a value of λ = 551 nm (2.25 eV) was calculated corresponding to the electronic transition of a single polyenyne chain. This energy is located at the low energy end of a yellow PDA solution spectrum. From Raman scattering v_(C?C) = 2108–2128 cm^?1 and v_(C?C) = 1505–1532 cm^?1 were calculated after extrapolation. Similarly sp-C¹³C NMR data yielded a shift of δ = 100 ppm. These data are almost identical to data known for yellow PDA solutions. Bond geometries are almost identical to those of poly(diacetylene)s and theoretical data.     

反击式粉碎机除尘装置的设计与改造

通过对反击式粉碎机粉尘产生的原因进行分析,引入非均相物系重力沉降分离原理,设计了大同煤预粉碎工程的除尘装置,取得了良好的使用效果.     

用于重离子核反应实验测量的纵向电场气体电离室

本文报道了一种新型的大动态范围，多叠层探测器系统组件之一的纵向电场气体电离室的构造，性能和在中能得离子核反应实验中的应用。     

Skeleton chain coding for Chinese characters

The compression of Chinese characters is very important for Chinese office automation and desktop publishing. In this paper, various methods are used to compress 13,051 Chinese characters losslessly by coding their skeleton points. The skeleton points are composed of isolated points and curves. To trace every point in a curve once and consecutively is a NP problem. Therefore, we use contour path following and revisiting algorithms to trace skeleton curves with chain codes. The remaining isolated skeleton points are encoded by an Elias code. Our coding method has a better compression rate than that of conventional skeleton coding.     

丙烯酸高碳醇酯的合成

介绍了降凝剂中间体丙烯酸高碳醇酯的合成和产品分离提纯方法。考察了合成条件对酯化反应的影响，结果表明，在原料丙烯酸与十八醇摩尔比1．2：1，阻聚剂对苯二酚用量占原料总量1．5％，催化剂对甲苯磺酸用量占原料总量1．5％，反应温度80-86℃，回流反应时间6h条件下，酯化率最高达89％。产品分离提纯方法与传统分离方法比较，所需分离时间短，洗涤用水量少，而产品收率远高于传统分离方法，达95％以上。     

尿素对以硝酸铝和葡萄糖为原料合成氮化铝粉末反应过程中相变及反应速率的影响

以硝酸铝(Al(NO3)3·9H2O)和葡萄糖(C6H12O6·H2O)为原料,利用碳热还原法制备氮化铝粉末,研究了尿素对前驱物的制备及前驱物氮化反应的影响,研究发现添加尿素合成的前驱物和未添加尿素合成的前驱物在氮化反应过程中相变和反应速率存在较大差异。在没有添加尿素合成的前驱物的氮化反应过程中,出现了γ-Al2O3、α-Al2O3、AlON和AIN相,该前驱物的反应速率慢,完全氮化需要在1600℃下才能完成。对于添加尿素合成的前驱物而言,在其氮化反应过程中仅出现了γ-Al2O3和AIN相,没有α-Al2O3和AlON的生成,AIN直接由γ-Al2O3氮化生成,该前驱物的氮化反应速率快,氮化反应温度低,在1400℃下即可实现完全氮化。分析讨论了两种前驱物的氮化反应速率不同的主要原因,并利用XRD、SEM等分析方法对粉末进行了表征。     

An introduction to Wu's method for mechanical theorem proving in geometry

Wu's algebraic method for mechanically proving geometry theorems is presented at a level as elementary as possible with sufficient examples for further understanding the complete method.The work reported here was supported by NSF Grant DCR-8503498.     

Luminescence Characterization of Mg Doped Y2O2S:Ti Long Afterglow Phosphor

Y1.94-xMgxO2S:0.06Ti (0≤x≤0.10) phosphors with long afterglow were synthesized by solid state reaction route. The photoluminescence spectra, decay curves, thermoluminescent spectra and chromaticity coordinate curves were investigated. The results show that the luminescence intensity of Y1.94-xMgxO2S:0.06Ti (0≤x≤0.10) phosphors decrease gradually with increasing Mg2 ion content, and the shape of luminescence spectra and chromaticity coordinate change as well. Furthermore, two thermoluminescent peaks in single Ti-doped Y2O2S sample are found at 91.8 and 221.5 ℃, respectively. Nevertheless, significant different spectra were found for the Mg, Ti co-doped Y2O2S samples that three thermoluminescence peaks appear at 52.3, 141.7 and 226.8 ℃, respectively. These results indicate that the co-doped Mg ion changes the inherent trap depth of single Ti-doped Y2O2S:Ti phosphor, and induces simultaneously a new trap level in the Y1.94-xMgxO2S:0.06Ti phosphor. Based on the analysis of thermoluminescent spectra, photoluminescent spectra, decay curve and crystal structure defect, it was proposed that the varied structure defect and introduced new trap level by the doped Mg2 ions should be responsible for reducing luminescence intensity and varying color in the Y1.94-xMgxO2S:0.06Ti phosphor.     

大庆蜡油在酸性催化剂上反应机理的研究

以大庆蜡油为原料，采用两种不同类型的催化剂，在流化床反应器实验装鬣上进行催化裂化反应。结果表明，大庆蜡油在酸性催化剂上反应所产生的干气组成与高烯烃催化裂化汽油相同，干气的产生主要是单分子裂化反应所造成的。从干气产率、组成以及液化气组成可以看出，大庆蜡油在不同类型的催化剂上明显地表现出裂化反应类型的差异。     

Dissolution kinetics of ulexite in acetic acid solutions

Ulexite is an important boron mineral used for the production of boron compounds. The aims of this study are to examine the dissolution kinetics of ulexite in acetic acid solutions, and to present an alternative process to produce boric acid. In order to investigate the dissolution kinetics of ulexite in acetic acid solutions, the concentration of solution, reaction temperature, solid-to-liquid ratio, and particle size were selected as experimental parameters. It was determined that the dissolution rate of ulexite increased with increasing solution concentration and temperature and decreasing particle size and solid-to-liquid ratio. The activation energy of the process was found to be 55.8 kJ/mol.