声诱饵仿真试验系统

介绍了声诱饵仿真试验系统的组成、工作原理、对接装置结构等,建立了对接装置声耦合状态下的数学模型,对近场声压分布进行了仿真计算,得出了匹配材料厚度、发射和接收换能器的选取原则。     

Investigation into polishing process of CVD diamond films

A new technique used for polishing chemical vapor deposition (CVD) diamond films has been investigated, by which rough polishing of the CVD diamond films can be achieved efficiently. A CVD diamond film is coated with a thin layer of electrically conductive material in advance, and then electro-discharge machining (EDM) is used to machine the coated surface. As a result, peaks on the surface of the diamond film are removed rapidly. During machining, graphitization of diamond enables the EDM process to continue. The single pulse discharge shows that the material of the coated layer evidently affects removal behavior of the CVD diamond films. Compared with the machining of ordinary metal materials, the process of EDM CVD diamond films possesses a quite different characteristic. The removal mechanism of the CVD diamond films is discussed.     

Malted weaning food made from maize,soybean, groundnut and cooking banana

Infant malnutrition and mortality are common in Africa, although Africa is endowed with agricultural produce that could be harnessed through processing to produce adequate infant food. This project was set up to explore the possibility of using local raw materials to develop a nutritious, low‐dietary‐bulk, cheap infant food. The materials used included cereal (maize), pulses (soybean and groundnut) and tuberiferous plants (cooking banana). The grains were first germinated and dried or kilned before milling and formulation. The malted products were compared with fermented ones in terms of nutritional, dietary bulk and acceptability criteria. Malting increased the nutrient content, reduced the dietary bulk and enhanced the taste of the infant food. In terms of protein content, least gelation concentration and overall acceptability, malted samples had values in the range of 138–151 mg g^?1, 150–175 g l^?1 and 7.2–8.82 respectively, while the control (fermented) sample had values of 54 mg g^?1, 100 g l^?1 and 6.29 respectively. Roasting of malted cereals above 55 °C reduced the bulk reduction ability but enhanced the taste of the products. A combination of malted maize and soybean, roasted groundnut and cooking banana in the ratio of 50:15:15:20 gave a very recommendable weaning food for infants between the ages of 6 months and 2 years. © 2002 Society of Chemical Industry     

T8钢－聚有机硅氧烷仿生减粘降阻复合涂层的特性

研究了Ｔ８钢－聚有机硅氧烷仿生减粘降阻复合涂层的表面润湿性、磨料磨损特性及对土壤的减粘降阻性能与金属材料相比，仿生复合涂层的表面憎水性显著提高，水在其表面上的接触角达９２°；与４５钢相比，其磨料磨损的体积相对耐磨系数为６３％，降阻率达１５．２２％～２２．２７％     

正确选用热力管网保温材料的几个问题

介绍了做好热力管网保温应具备的有关知识和数据，以及宝钢蒸汽主干管网在采用四种保温材料下的经济保温层厚度和相对的节能效益，认为目前适于宝钢公司热源温度在６００℃以下较好的保温材料有新型矿渣棉制品和泡沫石棉板。     

Mean residence time of gas in mechanically agitated gas–liquid contactors

In the present study of gas–liquid contactors, mean residence/contact time was calculated from knowledge of superficial velocity and the gas phase hold-up, for various gas rates and impeller geometry and speeds, and compared with values obtained from RTD measurements. A new correlation, involving Flow Number, Froude Number, system geometry and the physical properties, is proposed. This uses the authors data and those available in literature.     

点阴极电场辅助阳极连接中的紧密接触面积和电流

用等效电路的方法研究了点阴极情况下的电场辅助阳极连接效应，计算了连接电流，连接孕育期和紧密接触面积，本文结果表明，连接初期电流迅速衰减，随后缓慢变小，直至某一稳定值，孕育期随温度上升指数下降，连接温度高时，孕育期将难以观察到；待连接表面之间紧密接触面积随时间延长而非线性扩展，紧密接触区域增大时，其边界向外推进速度渐小，而接触面积增加渐快。     

湿硫化氢环境下的球罐腐蚀状况分析

在湿硫化氢环境下 ,尤其储存介质中的硫化氢含量超标时 ,很容易对储存容器壳体 (含焊缝和母材 )造成硫化氢应力腐蚀或氢鼓包。作者较仔细分析了 1 0 0 0m3 丙烯球罐产生硫化氢应力腐蚀开裂和40 0m3 LPG球罐产生氢鼓包的原因。提出了此类设备在设计选材、设备制造、施工安装和使用维护等环节应注意的问题。     

天然多糖类/蛋白质复合材料的研究进展

在参考了 31篇文献的基础上 ,详述了天然多糖类与蛋白质复合材料的研究进展     

巴氏杀菌调理食品及其品质控制关键技术

归纳性地介绍了在食品工业发展进程中出现的四种调理食品的显著特点，对其卫生安全性的重要保证措施－灭菌作了一定的理论分析，并阐明了新型巴氏灭菌调理食品的品质控制关键技术。