Development of temperature compensated high elongation resistance strain gauges for use up to 250°C

The paper describes the development and evaluation of temperature compensated high elongation resistance strain gauges for use from room temperature to 250°C. These gauges could be temperature-compensated on steels with coefficient of thermal expansion α = 11 ppm/°C. Thermal output within 250°C was about 1 μm/m/°C and maximum standard deviation of 5 gauges was 34 μm/m. Strain limit was > 4% at room temperature and at 250°C. Gauge factors of different strain ranges at R.T. and at 250°C are tabulated. Some applications are stated.     

Distribution and Fate of Escherichia coli in Lake Michigan Following Contamination with Urban Stormwater and Combined Sewer Overflows

Escherichia coli distribution and persistence in nearshore Lake Michigan were assessed following heavy rains and sanitary sewer overflow (SSO) and combined sewer overflow (CSO) events over a 5-year period, including an 18-day period following 25.4 cm of rainfall in which intensive studies were conducted following multiple CSO and SSO events. E. coli levels in the Milwaukee estuary and harbor following SSO and CSO events ranged from 10⁴ to nearly 10⁵ CFU/100 mL, which were significantly higher (p ≤ 0.05) than levels following rainfall alone. Sites outside of the breakwall but within the contamination plume (e.g., within 2 km of the harbor) were an order of magnitude lower. Locations 2–5 km from the harbor ranged from below detection limits, of < 1 to 5 CFU/100 mL. E. coli levels corrected for dilution based on specific conductivity measurements were lower than what would be expected for loss due to dilution alone, suggesting a combination of die-off and dilution, were responsible for the rapid disappearance of these organisms outside of the harbor. E. coli and fecal coliforms measured concurrently demonstrated that fecal coliforms could be recovered longer than E. coli in the open waters of the lake. E. coli isolated directly from sewage treatment plant influent were found to have a marked increase in antibiotic resistance traits for ten antibiotics commonly used in the human population compared with isolates from two animal sources of fecal pollution. However, E. coli obtained from sewage impacted water (n = 2,513) and from stormwater impacted water (n = 1,465) collected the previous year when there were no sewage overflows, were found to have no significant difference (p < 0.05) in the frequency of resistance when comparing the two conditions. E. coli survival characteristics and population dynamics are most likely influenced by multiple factors in complex systems such as the watershed/estuarine/lake environments of the Great Lakes.     

S—135钢板热轧工艺研究

S—135钢板是水电站用高强耐磨不锈钢板,既要求强度高、韧性好,又要求耐磨、耐蚀性强,生产难度较大。除我厂外,目前国内尚无其它厂家能够生产这种钢板。该钢板在加热轧制,冷却过程中要解决很多技术难点。我们通过采用特殊的控制轧制和控制冷却工艺,很好地解决了诸多技术难点,使S—135钢板的开发研制取得了成功。为电站用高强度耐磨不锈钢生产提供了宝贵的经验,也为控制轧制及控制冷却技术在中板生产行业的应用起到了积极的推动作用。     

HDPE的耐磨蚀性与抗冲击性的研究

用自制的旋臂式磨蚀实验仪，研究了５种高密度聚乙烯和１种顺丁橡胶改性的高密度聚乙烯，在铁尾矿和铁精矿浆体中的耐磨蚀性。耐磨蚀性最差的是ＨＤＰＥ２２００Ｊ，耐磨蚀性较差的是ＨＤＰＥ６３００Ｍ；ＨＤＰＥ５０００ｓ，６０９８和２４８０的耐磨蚀性较好；ＨＤＰＥ／ｃｉｓ－ＢＲ的耐磨蚀性最好。     

Effect of Microstructure on the Accelerated Creep of 20CrMoV12‐1 and P 91 Steels

In the initial part the change of microstructure for steel X20 CrMoV 121 is discussed in terms of the distribution of carbide precipitates and its effects on accelerated creep resistance and hardness are presented. In the following, experimental results of microstructure and accelerated creep resistance are presented for the steels X20CrMoV 121 and P91 annealed for up to 8760 hours at 650°C and 750°C before the testing. A similar evolution of the distribution of carbide particles of a size above 102 nm is found for both steels, while the accelerated creep resistance is diminished much stronger for the steel X20CrMoV 121. This difference is due to a greater stability of NbC than that of VC precipitates, both related to the evolution of the chemical composition of complex chromium, molybdenum and iron carbide particles.     

Heat transfer in YBaCuO thin film/sapphire substrate system

The thermal boundary resistance at the YBaCuO thin film/Al₂O₃ substrate interface was investigated. The transparency for thermal phonons incident on the interface as well as for phonons moving from the substrate was determined. We have measured a transient voltage response of current-biased films to continuously modulated radiation. The observed knee in the modulation frequency dependence of the response reflects the crossover from the diffusion regime to the contact resistance regime of the heat transfer across the interface. The values of transparency were independently deduced both from the phonon escape time and from the time of phonon return to the film which were identified with peculiarities in the frequency dependence. The results are much more consistent with the acoustic mismatch theory than the diffuse mismatch model.We are grateful to A. Elantev for helpful discussion. We acknowledge the financial support of the Russian Scientific Council on the HTS problem (Project No. 90462).     

Measuring the load eccentricity in helical compression springs

An experimental device able to detect the load eccentricity in helical compression springs is described. The theory underlying the resolution of measured bending strains of the apparatus into effective load eccentricity is discussed. Laboratory results are offered for heavy duty springs and compared to theoretical estimates retrieved from the literature.     

一个高电阻值测量电路

介绍一种新的高阻测试方法，可满足对高达１×１０＾１６Ω的测试要求。测试结果显示，对于１×１０＾１３Ω重复误差优于±２％。高阻测试电路通过接口与６８０９微机配套使用，操作简便，读数直观，便于长时间重复测量。     

The origin of the band at 1462 cm−1 generally appearing upon desorption of pyridine from acidic solids. Steps towards a more comprehensive understanding

The pyridine adsorption-desorption method, followed by IR spectroscopy, is generally applied for acidity determination of solid catalysts. A peculiar band at 1462 cm^–1 was observed by several authors upon pyridine desorption at higher temperatures and was interpreted in various ways. A new complex between Lewis framework acid sites and pyridine is proposed and several evidences are reported.