10 Gb/ s 0. 18 􀀁m CMOS 激光二极管驱动器芯片

基于0．18μm CMOS工艺设计的10Gb／s激光二极管驱动器电路。核心单元为两级直接耦合的差分放大器，电路中采用了并联峰化技术和放大级直接耦合技术以扩展带宽，降低功耗。模拟结果表明，在1．8V电源电压作用下该电路可工作在10Gb／s速率上，输入单端峰峰值为0．3V的差分信号时，在单端50Ω负载上的输出电压摆幅可达到1．4V，电路功耗约为85mW。     

光场力对烧蚀物时空分布的影响

对烧蚀物的时空分布进行了研究。烧蚀物离开靶材表面时的速率分布由蒸发机制决定,在激光作用时间内烧蚀物的传输行为由扩散机制和光场力机制共同决定,激光作用结束后烧蚀物的传输行为由扩散机制单独决定,并解释了烧蚀物的时空分布及烧蚀物趋光运动的现象。     

灯泡贯流式机组发电机冷却装置技术改造方式的探讨

灯泡贯流式发电机组直径小,转速低,发电机的通风冷却是一个难点。通过对京南、马骝滩、石面坦及南津渡等水电站的发电机运行过程中出现的温升过高,定子线棒绝缘受损等问题的分析,提出了解决的措施与改进方案,并对灯泡贯流式机组冷却系统的设计提出了建议,可供参考和借鉴。     

An improved cryofixation method: cryoquenching of small tissue blocks during microwave irradiation

The metal contact method of rapid freezing is greatly improved by irradiating the specimen with microwaves at 2.45 GHz for a short period of time (50 ms), while pushing the specimen onto the surface of the copper block cooled by liquid N₂. The microwave irradiation, together with two technical improvements (a light-mass plunger and a recently developed β-gel shock absorber) for preventing bounce, produces a good freezing zone for squid retina, with high reproducibility for each experimental trial, extending from the contact surface to a depth of about 15 μm, which is comparable to the depth obtained by the metal contact method using liquid He in the absence of microwave irradiation. A good freezing zone was also experimentally demonstrated in specimens of rat liver and heart muscle. Microwave irradiation does not have appreciable effects on the ultrastructure of squid retina. The mechanism underlying the improvement in the rapid freezing under the microwave irradiation is discussed.     

Ti 离子注入 LiNbO_3表面光学性能

本文研究了 x,y,z 三种切向的 LiNbO_3单晶片注入350keV 高能 Ti 离子(注入剂量为1.5×10~(17)/cm~2)后的表面光学性能。利用光谱仪及 AUEL 椭偏仪对三种切向 LiNbO_3试样在不同工艺处理后的光透射率及折射率进行了测试。注入损伤造成的光损耗可通过热处理消除,使晶格结构恢复至与完整晶格排列相近;注入层的折射率可增加11—13％左右。     

用于泵浦固体激光器的激光二极管线阵的输出特性

从实验上测量了激光二极管线阵的输出特性,研究了温度、电流对输出功率、光谱特性,以及偏振特性的影响,为设计全固态激光器提供有益的参考。     

红外半导体激光光镊的实验研究

激光光镊技术是一项在许多科学领域有广阔应用前景的技术。本文详细给出构建一台红外半导体激光光镊的设计思想及实例。由于采用了独特的对大功率多模红外激光选模整形和双透镜陷阱操纵技术等性能价格最优化选择 ,该系统易于构建 ,陷阱操作方便 ,其构建价格仅一般光镊的几十分之一 ,非常适合光镊技术的推广和一般实验室构建     

High‐Tg Carbazole Derivatives as Blue‐Emitting Hole‐Transporting Materials for Electroluminescent Devices

A series of dicarbazolyl derivatives bridged by various aromatic spacers and decorated with peripheral diarylamines were synthesized using Ullmann and Pd‐catalyzed C–N coupling procedures. These derivatives emit blue light in solution. In general, they possess high glass‐transition temperatures (T_g > 125 °C) which vary with the bridging segment and methyl substitution on the peripheral amine. Double‐layer organic light‐emitting devices were successfully fabricated using these molecules as hole‐transporting and emitting materials. Devices of the configuration ITO/HTL/TPBI/Mg:Ag (ITO: indium tin oxide; HTL: hole‐transporting layer; TPBI: 1,3,5‐tris(N‐phenylbenzimidazol‐2‐yl)benzene) display blue emission from the HTL layer. The EL spectra of these devices appear slightly distorted due to the exciplex formation at the interfaces. However, for the devices of the configuration ITO/HTL/Alq₃/Mg:Ag (Alq₃ = tris(8‐hydroxyquinoline)aluminum) a bright green light from the Alq₃ layer was observed. This clearly demonstrates the facile hole‐transporting property of the materials described here.