液晶光阀光电导层光吸收系数的研究

用化学气相沉积法制备了液晶光阀中光电导层———非晶硅薄膜,从实验中得出最佳制备工艺的参数取值。给出了用包络线法测量非晶硅薄膜光吸收系数的原理,测量了样品的光吸收系数随波长的变化规律。得到样品在最佳工艺条件下的光吸收系数高于1×103cm-1。     

不同锌钛比对纳米钛酸锌（ZnO—TiO2）体系成分的影响

以工业偏钛酸、硫酸锌、氨水为主要原料，用直接沉淀法并进行热处理得到钛酸锌粉体，并用XRD对产物成分进行了检测。结果表明，不同的锌钛比对钛酸锌（ZnO-TiO2）体系的成分有较大影响。     

SDS/正戊醇/水体系的液晶研究

在 2 5℃测定了十二烷基硫酸钠 (SDS) /正戊醇 /水三元体系的相平衡 ,确定了液晶区域的边界范围。在液晶区域内选取一系列样品点 ,用差示扫描量热法 (DSC)和2 HNMR与液晶照片对照 ,研究了该体系的液晶结构特点。结果表明 :在恒定温度下 ,该体系存在着两个液晶区域 ,并且随含水量的增加 ,液晶结构发生变化。当组成固定时 ,体系的液晶相结构随温度升高也发生变化     

Al_(10)Zn_(2.9)Mg_(1.7)Cu超高强铝合金的喷射成形制备研究

采用喷射成形技术制备了Al1 0 Zn2 .9Mg1 .7Cu高强高韧铝合金沉积坯件 ,研究了喷射成形制备过程中各工艺参数对沉积坯件的成形性、显微组织、致密度的影响 ,确定了适当的工艺参数 ,研究了沉积坯件的热挤压及热处理工艺 ,对材料的组织进行了分析并对不同状态的材料性能进行了比较。研究结果表明 :当喷射成形工艺参数合理时 ,沉积坯件具有良好的成形性与致密度 ,在随后的热挤压过程中 ,通过较低的挤压比即可使材料达到全致密 ;通过对合金进行适当的热处理 ,材料的极限抗拉强度达到 810MPa ,同时延伸率保持在 8%～ 11% ,该材料是一种理想的轻质高强结构材料。     

Ozonation of CI Reactive Black 5 using rotating packed bed and stirred tank reactor

This study investigates the ozonation of CI Reactive Black 5 (RB5) by using the rotating packed bed (RPB) and completely stirred tank reactor (CSTR) as ozone contactors. The RPB, which provides high gravitational force by adjusting the rotational speed, was employed as a novel ozone contactor. The same ozone dosage was separately introduced into either the RPB or the CSTR for the investigation, while the experimental solution was continuously circulated within the apparatus consisting of the RPB and CSTR. The decolorization and mineralization efficiencies of RB5 in the course of ozonation are compared for these two methods. Moreover, the dissolved and off‐gas ozone concentrations were simultaneously monitored for the further analysis. As a result, the ozone mass transfer rate per unit volume of the RPB was significantly higher because of its higher mass transfer coefficient and gas–liquid concentration driving force. Furthermore, ozonation kinetics was found to be independent of the gravitational magnitude of an ozone gas–liquid contactor. Therefore, the results suggest employing RPBs as ozone‐contacting devices with the advantage of volume reduction. The experimental results, which can be used for further modeling of the ozonation process in the RPB, also show the requirement of correct design for the RPB. Consequently, the present study is useful for the understanding of practical application of RPBs. Copyright © 2004 Society of Chemical Industry     

液相添加剂对PTCR陶瓷电性能的影响

液相添加剂ＡＳＴ（Ａｌ２Ｏ３＋ＳｉＯ２＋ＴｉＯ２）对ＢａＴｉＯ３陶瓷材料电性能的影响很大，随着Ａｌ２Ｏ３含量的增加，材料的电性能降低；ＳｉＯ２、ＴｉＯ２的物理特性对材料电性能影响较大；过量ＴｉＯ２对材料ＰＴＣ效应有重要影响，适当过量ＴｉＯ２含量，可得到性能优良的ＰＴＣＲ陶瓷。     

混合型表面活性剂液膜法处理含酚废水研究

研究了兰－１１３Ｂ＝Ｓｐａｎ－８０－－煤油ＮａＯＨ液膜体系处理苯酚废水的最佳操作工用于对高浓度含酚废水进行处理，实验结果表明，混合型表面活性剂各项指标均较好，除酚效率可达９９％以上，对内相ＮａＯＨ的最佳浓度的确定给出了估算方法。