回收PET共混物的非等温结晶和熔融行为

采用双螺杆挤出机制备了聚丙烯(PP)/回收聚对苯二甲酸乙二酯(r-PET)、r-PET/马来酸酐接枝PP(PP-g-MAH)和r-PET/甲基丙烯酸缩水甘油酯接枝PP(PP-g-GMA)共混物,并研究了共混物组成、熔融温度与时间以及降温速率对共混物非等温结晶与熔融行为的影响.结果表明,r-PET与PP共混,结晶温度均提高,这与组分间起到异相成核诱导结晶作用有关.r-PET结晶温度随PP-g-MAH用量增加而降低,但受PP-g-GMA用量影响较小;r-PET可提高PP-g-MAH结晶温度,但降低PP-g-GMA结晶温度.熔融温度提高,共混物中PP结晶温度和熔点均降低,r-PET熔融峰形和熔点取决于共混物的熔融温度及界面相互作用.     

Quantitative preparation of long chain thioethers from an oxo-trans-2-enoic ester and a 9,12-dioxo-trans-10-enoic acid

Branched-chain thioethers have been prepared from methyl 4-oxo-trans-2-hexadecenoate and 9,12-dioxo-trans-10-octadecenoic acid. The reagents involved in these preparations were mercaptoacetic and mercaptopropionic acids. The yields of these thioethers are almost quantitative.     

非异氰酸酯法合成除草剂异丙隆

报道了以氯甲酸甲酯为起始原料合成除草剂异丙隆的方法。考察了原料配比,反应温度和反应时间对反应的影响。结果表明,氯甲酸甲酯法制除草剂异丙隆,总收率为82.7%,原药纯度达95%。     

甲酸甲酯合成与转化的催化技术

本文评述了甲酸甲酯(MF)合成与转化的催化技术,展示了从MF出发发展C_1化学的可能途径,在MF的合成方面详细地分析了从甲醇出发的羰化法、脱氢法和氧化法催化技术,简介了我们的有关研究工作。     

粗苯甲酸甲酯醇解合成苯甲酸丁酯的工艺研究

研究开发了由对苯二甲酸二甲酯生产过程中副产物粗苯甲酸甲酯合成苯甲酸丁酯的工艺过程。分酯过量与醇过量两种情况分别考察了反应配料比、催化剂用量、反应温度和回流比对转化率的影响 ,确定了最佳工艺条件。实验表明 ,在钛酸酯存在下 ,当醇酯摩尔比为 1.5∶1、催化剂用量为 1%、回流比为 2∶2时 ,反应转化率达 82 .79%。     

二氢茉莉酮酸甲酯的合成进展

二氢茉莉酮酸甲酯是一种重要的合成香料,目前尚未见有直接从天然产物中提取的产业化文献报道,其香气独特优异,性质稳定,对其合成方法的研究一直是化学工作者们的科研热点。本文对其合成方法的研究进行了综述。     

Feeding response of Ips paraconfusus to phloem and phloem metabolites of Heterobasidion annosum-inoculated ponderosa pine,Pinus ponderosa

In studies of feeding by the bark beetle, Ips paraconfusus, two pine stilbenes (pinosylvin and pinosylvin methyl ether), ferulic acid glucoside, and enantiomers of the four most common sugars present in ponderosa pine phloem (sucrose, glucose, fructose, and raffinose) did not stimulate or reduce male feeding when assayed on wet -cellulose with or without stimulatory phloem extractives present. When allowed to feed on wet -cellulose containing sequential extracts (hexane, methanol, and water) of ponderosa pine phloem, methanol and water extractives stimulated feeding, but hexane extractives did not. Males confined in wet -cellulose containing aqueous or organic extracts of culture broths derived from phloem tissue and containing the root pathogen, Heterobasidion annosum, ingested less substrate than beetles confined to control preparations. In an assay using logs from uninoculated ponderosa pines, the mean lengths of phloem in the digestive tracts increased as time spent feeding increased. Males confined to the phloem of basal logs cut from ponderosa pines artificially inoculated with H. annosum ingested significantly less phloem than beetles in logs cut from trees that were (combined) mock-inoculated or uninoculated and did not contain the pathogen. However, individual pathogen-containing treatments were not significantly different from uninoculated controls. It was concluded that altered feeding rates are not a major factor which may explain why diseased ponderosa pines are colonized by I. paraconfusus.     

Synthetic hydrogels 3. Solvent effects on poly(2-hydroxyethyl methacrylate) networks

Poly(2-hydroxyethyl methacrylate) networks were synthesized in aqueous solutions of propylene glycol, ethylene glycol, ethylene glycol monomethyl ether, or ethylene glycol dimethyl ether and the influences of solvent on phase separation during the polymerization process studied. Results from conversion-phase diagrams, turbidity measurements, swelling studies, and viscosity measurements show that the phase separation process is dependent upon the solubility parameter of the organic solvent, the instantaneous monomer concentration at each stage of the gel formation process, and the crosslinker content of the reaction mixture.     

吸收剂量对二甲基硅橡胶与甲基乙烯基硅橡胶分子量和凝胶含量的影响

将ＧＰＣ和特性粘数［η］测定相结合，在室温和－７８℃下，用Ｃｏ~（６０）辐射源辐照，研究了二甲基硅橡胶（ＭＱ，吸收剂量２．０５×１０~３～３．９７×１０~４Ｇｙ）和甲基乙烯基硅橡胶（ＭＶＱ，吸收剂量１０~２～１０~４）分子量和凝胶含量的变化。结果表明，辐照ＭＶＱ较辐照ＭＱ易生成凝胶，在凝胶点前的较低吸收剂量时，溶胶的分子量出现极大值，分子量分布曲线呈单峰；随吸收剂量的增加，分子量分布变窄，分子量降低；出现凝胶的吸收剂量，ＭＱ大约是ＭＶＱ的１０倍。辐照ＭＱ时，凝胶点前的溶胶的分子量分布曲线为双峰，并随吸收剂量的增加，双峰消失，分子量下降；在凝胶点时，分子量出现极大值。     

Synthesis of Biodiesel from Soybean Oil using Heterogeneous KF/ZnO Catalyst

Biodiesel was produced by transesterification of soybean oil with methanol using ZnO loaded with KF as a solid base catalyst. It was found that the catalyst with 15 wt.% KF loading and calcined at 873 K showed the optimum activity. XRD, IR and Hammett indicator method were employed for the catalyst characterization. The results showed the activity of the catalysts was correlated with their basicity. The influence of various reaction variables on the conversion was also discussed.