Processing and microstructure of non-oxide ceramic fibres

Research and development efforts on high-temperature, oxidation-resistant fibres have increased over the past decade due to the demand for light-weight, stiff and strong composite materials in aerospace applications. Varieties of ‘high-performance’, continuous, non-oxide fibres with low-density, high tensile strength and tensile modulus have been developed either from organic precursors or via chemical vapour deposition for fabrication of ceramic matrix composites. Fibres derived from polymer precursors (e.g. Nicalon, Tyranno, HPZ) are small in diameter (compared to CVD monofilaments) and are ideally suited for ceramic composites. Processing, microstructural stability and mechanical properties of these newly developed SiC and Si₃N₄ base fibres are briefly reviewed in this paper.     

构造作用对油气生成和运聚的影响

有机质从埋藏开始，就处于极其复杂的地球物理化学场中，环境提的能量，一是热量，二是机械能，机械能，主要是通过机械力作用传递给系统的，另外还以机械波的形式赋予系统一定的机械能。当发生断褶构造运动时，机械力对油气运移的影响尤为突出，它经能量的迁移转化，促成了包括机械力降解和地应力驱动等一系列的连锁反应，制造了一次次高效的成油（生运）事件，本文以突变论为着眼点，按照改造控制建造的思路，大胆提出构造运动制造生排烃事件，成就含油气系统的假说。     

锂离子电池有机电解液成膜添加剂的研究现状

文章综述了锂离子电池有机电解液成膜添加剂的作用原理，具体介绍了CO2、SO2、VC化合物、卤化物、有机铜盐以及马来酐等添加剂的研究现状。     

Inorganic–organic hybrid materials with zirconium oxoclusters as protective coatings on aluminium alloys

Inorganic–organic hybrid materials are attracting a strong scientific interest mainly for their outstanding inherent mechanical and thermal properties, which can be traced back to the intimate coupling of both inorganic and organic components. By carefully choosing the experimental parameters used for their synthesis, chemically and thermally stable acrylate-based hybrid material embedding the zirconium oxocluster Zr₄O₄(OMc)₁₂, where OMcCH₂C(CH₃)C(O)O, can be deposited as UV-cured films on aluminium alloys.

In particular, the molar ratios between the oxocluster and the monomer, the polymerisation time, the amount of photo-initiator and the deposition conditions, by using an home-made spray-coating equipment, were optimised in order to obtain the best performing layers in terms of transparency and hardness to coat aluminium alloy (AA1050, AA6060 and AA2024) sheets. Furthermore, it was also evaluated whether the hybrid coatings behave as barrier to corrosion.

Several coated samples were prepared and characterised. Environmental scanning electronic microscopy (ESEM) and scratch test were used to investigate the morphology of the films and to evaluate their scratch resistance, respectively. Electrochemical impedance spectroscopy (EIS) was performed in order to evaluate if the coatings actually protect the metallic substrate from corrosion.

In order to measure shear storage modulus (G′) and loss modulus (G″) of the materials used for coatings, bulk samples were also obtained by UV-curing of the precursors solution. Dynamical mechanical thermal analysis (DMTA) was performed in shear mode on cured disks of both the hybrid materials and pristine polymer for comparison. The values of T_g were read off as the temperatures of peak of loss modulus. The length and mass of all the samples were measured before and after the DMTA analysis, so that the shrinkage of the materials in that temperature range was exactly evaluated.     

用土壤含水层处理系统去除水库微污染有机物的试验研究

本文针对当前中国饮用水源污染以微污染为主的特点，以北京三家店水库原水和永定河河道砂为研究对象，设计了用于表征土壤含水层处理系统的一维土柱，进行污水净化效果的试验研究。结果表明，土壤含水层处理系统对三家店水库微污染水中的有机物有一定的去除效果，在0．12m／d的水力负荷条件下，对CODMo去除率虽然仅为15％，但是出水达到了地表水Ⅱ类水质标准；对BOD5的去除率达到了55％，可以被有效地去除。渗透速率相同时，水力负荷周期对去除效果的影响不明显，但在保证一定水力负荷的情况下，可适当延长落干期，恢复土壤的渗透能力，达到较好的处理效果。同时，土壤含水层处理系统的净化能力主要发生在土层50cm以内。     

有机羧酸钠盐对PET结晶和熔融行为的影响

采用差示扫描量热仪研究了5种具有不同取代基的苯甲酸钠盐作为结晶成核剂对聚对苯二甲酸乙二醇酯（HET）结晶和熔融行为的影响，并同滑石粉进行了对比。结果表明，成核剂的加入能明显改变PET的结晶和熔融行为。苯甲酸钠、对苯二甲酸甲酯单羧酸钠和对羟基苯甲酸钠提高既汀的熔融结晶温度（Tc）分别达22．93、21．7和19．37℃，但使PET降解严重；对苯酚钠甲酸钠能够提高Tc达17．75℃且对PET相对分子质量影响很小；对苯二甲酸二钠成核作用最差。低于滑石粉。此外，成核剂的成核能力越强，PET双熔融峰中的低温峰顶温度就越高。     

A Nonvolatile Organic Memory Device Using ITO Surfaces Modified by Ag‐Nanodots

We report on a single‐layer organic memory device made of poly(N‐vinylcarbazole) embedded between an Al electrode and ITO modified with Ag nanodots (Ag‐NDs). Devices exhibit high ON/OFF switching ratios of 10⁴. This level of performance could be achieved by modifying the ITO electrodes with some Ag‐NDs that act as trapping sites, reducing the current in the OFF state. Temperature dependence of the electrical characteristics suggest that the current of the low‐resistance state can be attributed to Schottky charge tunnelling through low‐resistance pathways of Al particles in the polymer layer and that the high‐resistance state can be controlled by charge trapping by the Al particles and Ag‐NDs.