UASB-SBR工艺处理城市生活污水的研究

研究了UASB工艺处理城市生活污水的可行性，通过UASB与SBR组合工艺的运行实验，得出在水力停留时间3h时，COD去除率为61．67％-82．32％，出水COD达到国家污水排放二级标准。在氮磷去除效果不佳的情况下，采用SBR工艺处理后，其出水COD、SS、氮、磷等指标均达到国家污水一级排放标准。     

Extraction of Lipids from Municipal Wastewater Plant Microorganisms for Production of Biodiesel

Municipal wastewater treatment plants in the USA produce over 6.2 × 10⁶ t of dried sewage sludge every year. This microorganism-rich sludge is often landfilled or used as fertilizer. Recent restrictions on the use of sewage sludge, however, have resulted in increased disposal problems. Extraction of lipids from sludge yields an untapped source of cheap feedstock for biodiesel production. Solvents used for extraction in this study include n-hexane, methanol, acetone, and supercritical CO₂. The gravimetric yield of oil was low for nonpolar solvents, but use of polar solvents gave a considerably increased yield; however, the percentage of saponifiable material was less. Extraction of lipids with a mixture of n-hexane, methanol, and acetone gave the largest conversion to biodiesel compared with other solvent systems, 4.41% based on total dry weight of sludge. In situ transesterification of dried sludge resulted in a yield of 6.23%. If a 10% dry weight yield of fatty acid methyl esters is assumed, the amount of biodiesel available for production in the USA is 1.4 × 10⁶ m³/year. Outfitting 50% of municipal wastewater plants for lipid extraction and transesterification could result in enough biodiesel production to replace 0.5% of the national petroleum diesel demand (0.7 × 10⁶ m³).     

新型碳质催化剂用于NH3选择性催化还原NOx的研究

以城市污水处理厂剩余污泥为原料制备了一种新型碳质催化剂。通过试验考察了催化剂在NH₃选择催化还原NO中的应用效果。结果表明,催化性能较好，最佳的制备和催化反应条件为：锌铁物质的量比1∶0.5，热解温度750 ℃，反应温度400 ℃，O₂浓度15%。在此条件下，NOx的最大转化率达98.3%。通过考察证明催化剂自身具有一定的还原性能。对催化剂进行了FTIR、TG、SEM和BET分析，结果表明，催化剂具有很丰富的孔结构、活性粒子和表面官能团，比表面积较大，最大可达307 m²·g^-1，分析结果显示具有良好的催化条件。     

Simultaneous hydrolysis and fermentation of pulp mill primary clarifier sludge

Bioconversion of sludge from the primary clarifier of a sulphite pulping operation to ethanol offers a number of advantages over conventional disposal options. The amount of material which must be disposed of is reduced while, at the same time, salable and environmentally friendly fuel-ethanol is produced. In this study, primary clarifier sludge (PCS) was shown to be hydrolysed to produce fermentable sugars at a rate proportional to enzyme loading. Initial (1 hour) hydrolysis rates as high as 12.6 g reducing sugar/L · h were observed at an initial enzyme loading of 10 filter paper units (FPU)/g. Hydrolysis was inhibited by spent sulphite liquor (SSL), an inhibition which could be completely overcome by fermenting the SSL to remove sugars. Surfactants were found to only marginally improve the production of sugars. To reduce the deleterious effects of end product inhibition, single stage simultaneous hydrolysis and fermentation (SHF) was carried out using cellulase enzymes and Saccharomyces cerevisiae.     

城市污水处理厂污泥中温两相厌氧消化的研究

采用中温两相厌氧消化处理西安市污水处理厂污泥,结果表明,污泥可在较短的停留时间(296 h,产酸相30 h,产甲烷相266 h),较高的有机负荷(约2.65 kg VS/m3.d)下稳定运行,系统VS去除率38.87%,pH≈7.5,产气速率6.33 L/L.d,单位VS产气率3.00 L/g。与单相厌氧消化处理结果对比,两相厌氧消化系统的停留时间可减少一半,而污泥有机负荷提高2倍,且有机物的去除率大,处理效果好,稳定性高,抗冲击负荷能力强,产气性良好。     

污水厂污泥制地砖及共性能

参照普通陶瓷砖的生产工艺，烧制污泥地砖，对其抗压、抗折、抗磨损性能、腐蚀性能及影响因素进行检测和分析，以探讨用城市污水处理污泥制造地砖的可能性。实验表明：随污泥含量增加，烧制成品的抗压强度显著下降，抗折强度略有增加。细粒径污泥粉配料有利于提高制品整体强度。采用复合材料结构可提高制品的抗压强度。成品的抗磨损性能优于普通砖的，略低于普通市售陶瓷砖的。这种地砖的水浸出液不具有腐蚀性能，且污泥中所含重金属Mn，Cu被很好固化在砖中而不能渗出。     

双面彩色相纸分切中的静电预防

静电无处不在。双面彩色相纸由于采用聚丙烯作为基材,和单面相纸相比在分切中更容易产生静电。严重的静电斑会造成产品报废。在环境湿度、设备接地、分切速度和静电消除器安装这四个方面,采取相应的措施可有效的控制分切过程中静电的产生,保障相纸的表观质量。     

透射成像纸币冠字号定位方法

纸币成像方式分为反射和透射成像两种方式。反射方式成像的纸币图像清晰、背景单一,但采集任意方向进入点验设备的冠字号图像需两个图像传感器,占用仓室空间大;相同条件下,透射方式仅需一个图像传感器,具有空间上的优势,但透射方式的图像背景复杂、两面图像重叠、易光照不均。针对这些问题,提出一种冠字号定位的新算法。检测冠字号的字符间间隙特征点;在特征点检测基础上,进行水平投影,根据人民币固有属性计算冠字号区域的准确水平位置;在水平定位基础上,通过定位欧姆龙环间接计算出冠字号区域的准确垂直位置;利用连通域标记算法定位出单个字符。对2000张正常流通05版人民币进行测试,定位正确率为100％。     

膜分离活性污泥法在辣根废水处理中的应用

本文以处理辣根废水为例，介绍一种新的水处理方法-膜分离活性污泥法，并阐述了膜分离活性污泥法如何解决污泥膨胀问题以及传统活性污泥法所不具有的特性。     

Kinetic studies of the pyrolysis of sewage sludge by tga and comparison with fluidized beds

The pyrolysis of sewage sludge was examined by thermogravimetric analysis using different heating rates, particle sizes and final temperatures. A semi-empirical model was developed with four global consecutive/competitive reactions to volatile and solid products including also a heat balance. This model was extrapolated to isothermal reactor conditions and compared to experimental data on fluidized bed pyrolysis. Depending on the particle size and reactor temperature, about 90% of the maximum conversion in a fluidized bed takes place under external heat transfer control, the rest under kinetic control. Incomplete conversion occurs at short particle residence times, which were calculated approximately by the model.