喷射成形Al-Zn-Mg-Cu系超高强度铝合金热处理制度的实验研究

研究了喷射成形Al-Zn-Mg-Cu系超高强度铝合金的沉积态和挤压态的组织,对挤压态合金进行了固溶处理和时效处理,得到了时效硬度曲线,并进行了力学性能测试.结果显示:沉积态合金孔隙较多;挤压态合金内存在大量的颗粒,经能谱分析为富铜相;固溶温度达到490℃时,晶界出现熔化现象.时效硬度曲线表明:采用120℃时效,在15~25h之间达到硬度峰值;采用135℃时效,达到硬度峰值的时间与合金的成分有关,随着Zn含量的增加,达到硬度峰值的时间变短,而抗拉强度基本稳定在700MPa左右.     

局部火灾下钢筋混凝土平面框架结构的耐火性能研究

高温后混凝土与钢筋间的黏结性能影响钢筋混凝土结构的安全评估,实际工程中钢筋混凝土常承受侧向约束作用。为此,该文以高温温度和侧压力为参数,完成了48个钢筋混凝土试件的中心拉拔试验,分析侧压力对高温后试件破坏形态、峰值黏结应力、峰值滑移、残余黏结强度的影响规律,建立了峰值黏结应力随高温温度和侧压力变化的经验公式。将侧压下钢筋-混凝土黏结应力场简化为肋前混凝土挤压力和侧压力的线性叠加,并基于微观传力模型及高温后混凝土的多轴强度破坏准则推导计算了无侧压及单向侧压下的黏结强度理论。研究结果表明：侧压作用和高温温度直接影响试件破坏形态;随着侧压力增加,高温后混凝土与钢筋间的峰值黏结应力、残余黏结强度、峰值滑移逐渐增大,但温度达到500 ℃后,有侧压试件峰值滑移较无侧压试件小;黏结强度理论计算值与实测值较为吻合,能较好地预测高温后混凝土与钢筋间的黏结强度。     

我国钢管混凝土拱桥应用现状与展望

以轴压比、含钢率和钢材强度为参数,进行了8根高强钢管超高强混凝土柱和1根普通强度钢管超高强混凝土对比柱的拟静力试验,分析了各参数对破坏形态、荷载-位移滞回曲线、骨架曲线和各个抗震性能指标(如延性、耗能和强度与刚度退化等)的影响程度。结果表明：压弯破坏为主要破坏模式;弹性刚度受轴压比影响不大,但受含钢率和钢材强度影响较大;极限承载力受轴压比、含钢率和钢材强度影响较大,随前者增大而降低,随后两者增大而增大;延性受轴压比、钢材强度和含钢率影响较大,随前两者增大降低,随后者增大而增大;耗能能力随轴压比增大而减弱,随含钢率和钢材强度增大而增强;刚度和强度退化程度随轴压比增大而降低,随含钢率增大而增大,且前者随钢材强度增大而增大,后者则随钢材强度增大呈减小趋势。通过对比不同规程抗弯刚度计算方法,结果表明：受材料适用范围限制,各规程不适用于该类高强材料组合构件。     

煤矸石基混凝土在井下巷道硬化工程中的应用试验

煤矸石是我国目前排放量较大的固体废弃物之一,利用煤矸石部分或全部代替混凝土粗骨料生产煤矸石基混凝土是其高效利用的途径。通过实验室开展不同煤矸石粗骨料替代率、水胶比、添加剂等条件下的煤矸石基混凝土的抗压强度试验,探究煤矸石基混凝土的基本力学性能,确定煤矸石基混凝土的最佳配合比。研究结果表明：煤矸石基混凝土抗压强度随着煤矸石粗骨料替代率的增大而减小;在胶凝材料中加入质量比为5%的硅灰、0.3%的减水剂有助于迅速提高煤矸石基混凝土的前期强度。在山西李村煤矿二采区胶带巷5^#辅运联巷开展了煤矸石基混凝土的井下硬化试验,验证了煤矸石基混凝土在井下硬化工程中的良好效果。     

Connection‐Strength Estimation of Neuronal Networks by Fitting for Izhikevich Model

Recently, there has been abundant research using multineuron recording, but there are many problems with extracting the features from the obtained spike time series, which are huge in volume and complex. Here we introduce a new method of estimating synaptic connection strengths between neurons by fitting to the Izhikevich model by maximum likelihood estimation. We demonstrate that our method can estimate connection strengths from spike time series given by a simulated neural ensemble and can estimate nonconnectivity between two independent cultured neuronal networks. These results suggest that our method is applicable to network and plasticity analysis of neuronal networks.     

Surface layer condition and the fatigue strength of an AZ91 alloy after ball peening

The present work compares the states of the surface textures and the oscillatory fatigue strengths of specimens made of an AZ91 alloy after turning and dynamic bearing ball peening. It was found that the specimens ball peened at different time have similar surface geometric structure parameters but different strengthening intensity. It was shown that fatigue strength follows greater peening intensity and random and isotropic surface. It was also ascertained that improving (by peening) the condition of the surface layer means enhancing fatigue strength by 20–87% compared with turning.     

Optimization of the shear strengths of ultrasonically consolidated Ti/Al 3003 dual-material structures

The interfacial bonding between layers in ultrasonically consolidated structures is poor for some material combinations, resulting in relatively low bond strength. This makes resultant parts unsuitable for structural applications. This work discusses a study of the effects of post process heat treatment of ultrasonically consolidated commercially pure titanium and aluminum alloy 3003 dual-material systems. The lap shear strengths of as-consolidated specimens as well as heat treated ones were tested. The results show that there is significant improvement of the strengths of post processed specimens over the as-consolidated ones. The improvement is as a result of stress relieving of the strain hardened interface between the two materials and some interactions of the base materials across the interfacial boundaries at elevated temperatures, leading to stronger bonds. The study highlights the role of post process heat treatments for improving the mechanical properties of ultrasonically consolidated structures.     

铝圆筒持久强度试验

鉴于用户对铝圆筒持久性能测定的高可靠性要求,却因无法制取满足国标要求的持久强度试验的试样而无法对其进行测试,因此专门设计并制造了一套铝圆筒持久强度试验台(专利号01101063.O),对成品铝圆筒进行持久强度测试.结果表明:外推得到95%置信度下铝圆筒在40℃服役10 a(年)的持久强度σ1040=(399±18)MPa.铝圆筒的持久性能可以满足用户要求.     

Application of strength reduction method to dynamic anti-sliding stability analysis of high gravity dam with complex dam foundation

Considering that there are some limitations in analyzing the anti-sliding seismic stability of dam-foundation systems with the traditional pseudo-static method and response spectrum method,the dynamic strength reduction method was used to study the deep anti-sliding stability of a high gravity dam with a complex dam foundation in response to strong earthquake-induced ground action.Based on static anti-sliding stability analysis of the dam foundation undertaken by decreasing the shear strength parameters of ...