聚酯装置热媒系统串级使用节能改造

现有部分聚酯车间设计和建设时间较早,装置能耗较高,为了节能降耗,对现有热媒系统进行改造,一是将装置高温回油梯级使用到低温系统;二是改造部分热媒系统为串级使用,停开或降低热媒泵电耗。经过以上一系列改造和优化,有效提高了热能使用效率,减少了装置耗电,从而实现了热媒系统的节能降耗。     

原位聚合法纳米材料改性不饱和聚酯树脂研究

利用原位聚合法将nm SiO2预先分散到生产不饱和聚酯树脂的原料体系中,通过改进树脂生产工艺,可直接制得纳米改性不饱和聚酯树脂,并使树脂固化后的强度、韧性、耐热性等性能得到较大幅度的提高,并对其改性机理作了初步的探讨。     

Adsorption of aroma chemicals on cotton fabric from aqueous systems

The adsorption of aroma chemicals on cotton fabric was studied relative to the surfactant concentration, surfactant type, water solubility, and fiber morphology. The adsorption increased with increasing surfactant concentration to a maximum near the critical micelle concentration, then decreased with further increases in surfactant concentration. The adsorption also was found to be highly dependent on the fiber surface area and pore structure; dramatic differences were observed between untreated and mercerized cotton fabric and are believed to be due to morphological differences. Cationic and anionic surfactants increased the aroma chemical adsorption, which varied with surfactant type, with cetyltrimethylammonium chloride (CTAC)>sodium dodecyl sulfate (SDS)>H₂O. Water solubility also influenced adsorption; in most cases, adsorption increased with water solubility. In addition, adsorption was also influenced by chemical structure and hydrophobic interactions. The adsorption of aroma chemicals on cotton fabric can be attributed to the aqueous solution being physically held in capillaries and pore structures within the fibular structure of cotton fiber and also to molecular interactions among the aroma chemical molecules, surfactants, and cotton substrate.     

有机累托石改性不饱和聚酯／玻璃纤维复合材料的研究

采用有机累托石改性不饱和聚酯，以改性的不饱和聚酯为基体，以两种玻璃布(EW210、CWR400-90)为增强材料，以两个不同凝胶时间的不饱和聚酯树脂体系制备三种有机累托石改性的不饱和聚酯磁璃纤维复合材料(UPB1、UPB2、UPB3)。测试了不饱和聚酯/玻璃纤维的力学性能；研究了复合材料的耐湿热性及耐介质性能；利用扫描电镜及透射电镜分析了复合材料的增强机理。结果表明，采用有机累托石改性不饱和聚酯所制备的不饱和聚酯／玻璃纤维复合材料的综合力学性能优于纯不饱和聚酯／玻璃纤维复合材料。     

Effects of the o‐aromatic ring in the molecular chain on the properties of polyester polyols

A series of liquid polyester polyols from adipic acid (AA), phthalic anhydride (PA), ethylene glycol, propanediol‐1,2, and trihydroxymethylpropane, varying in the molar ratio of PA to AA, were prepared. The effects of the o‐aromatic ring in the molecular chain, which came from PA, on the viscosity, glass‐transition temperature, and thermal degradation temperature of the polyester polyols were studied with viscometry, differential scanning calorimetry, and thermogravimetry. The intrinsic viscosity and glass‐transition temperature increased with the concentration of the o‐aromatic ring increasing. The temperature of the maximum thermal degradation rate for aliphatic polyester polyols was 434.20°C. Two steps of thermal degradation were found when there were o‐aromatic rings in the molecular chain. One thermal degradation temperature was 358.36–360.48°C, and the other was 412.85–427.18°C. Polyester polyols with o‐aromatic rings had higher stability at lower temperatures (<240.00°C). However, aliphatic polyester polyols had higher stability at higher temperatures (300.00–480.00°C). The activation energy and order of degradation were calculated from thermogravimetric curves. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 83: 1617–1624, 2002     

短纤维-橡胶复合材料在输送带中的应用

介绍了以不连续的聚酯短纤维群为骨架材料，ＮＲ／ＳＢＲ为基质胶的定向短纤维橡胶复合材料（ＯＳＦＲＣ）在输送带中的应用。结果表明，ＯＳＦＲＣ输送带与棉帆布芯输送带相比，使用寿命提高１倍，带体综合物理性能好，在应力作用下不脱层，无受潮霉烂现象，输送平稳且不打滑，适宜在苛刻条件下使用。     

德国吉玛公司聚酯微细纤维生产技术

介绍了德国吉玛公司聚酯微细纤维的生产技术。分别对微细纤维的常规单组分纺丝法、生产微细纤维技术的特殊要求及微细纤维的质量指标作了阐述。     

改性聚氨酯固色剂的固色工艺研究

采用了一种自制的丙烯酸酯改性聚氨酯固色剂,对活性染料染色后织物进行固色整理.通过对固色剂的用量、焙烘温度、焙烘时间和轧余率的探讨,确定了色织物的最佳固色整理工艺为：活性染料染色织物→二浸二轧（固色剂50g/L,轧余率75%）→烘干（70℃×3 min）→焙烘（150℃×3 min）.实验结果表明,此类固色剂对活性染料染色棉织物有良好的固色效果,可使织物的干湿摩擦牢度和水洗牢度有所提高.其固色效果与4种市售固色剂基本相当,固色后织物色光基本不变.     

多胺型无醛固色剂的合成及应用

以二甲胺、环氧氯丙烷、四乙烯五胺为主要原料,制备了一种无甲醛多胺型固色剂.通过实验,确定了合成多胺型固色剂的最佳合成工艺及最佳固色工艺.最佳合成工艺为：将摩尔比为1∶1.5的二甲胺、环氧氯丙烷于28℃左右反应2h后,加入占单体总量2%的四乙烯五胺,在70℃反应5h.最佳固色工艺为：染色棉织物→两浸两轧（整理剂40g/L,轧余率80%）→烘干（100℃）.整理织物后,可使直接染料的各项牢度提高1~2级,且对色光影响较小.