调整煤源结构优化炼焦煤质量管理

介绍了湘钢在调整煤源结构、优化炼焦煤质量管理方面所做的一些工作。近年来 ,湘钢依靠科技进步 ,坚持精料方针 ,不断强化企业管理 ,使焦炭质量有了较大的提高 ,为降低高炉焦比 ,提高高炉的利用系数做出了应有的贡献     

电动机笼形转子铸铝常见质量问题分析

在电机制造中，笼形转子三相异步电动机的转子铸铝质量的好坏直接影响电机的性能及力能指标。因此本文对常见的转子铸铝质量问题进行了分析，并提出了相应地解决措施，以获得优质的电机。     

煤气设施防腐实践及影响质量因素分析

根据近几年三明钢铁公司煤气设施的防腐实践，就影响煤气设施的质量因素进行了分析。     

深入贯彻十六大精神加速企业创新体系建设为全面实现"十五"目标而奋斗

总结了2001年以来冶金集团总公司的科技质量工作,指出了存在的主要问题,布署安排了今后两年的科技工作。     

Psychometric considerations in the dimensional analysis of subjective picture quality

A discussion of the factors involved in the subjective perception of television picture quality is presented. Much of the work in this field is cited, and it is concluded that future work needs to consider a broader range of variables than has been looked at so far.     

煤矿矿井水检测质量控制措施探讨

探讨了影响煤矿矿井水检测质量的主要因素,按照全过程、全要素控制的理念提出了检测前、检测中和检测后的控制措施。     

Comparison of Two Drying Schedules for European Hophornbeam (Ostrya carpinifolia Scop.) Lumber

Two types of conventional kiln-drying schedules (mild and harsh) based on moisture content (MC) were compared with regard to time, drying quality, and energy cost. The results were evaluated according to the classification of the European Drying Group. Proper drying periods of mild and harsh schedules were found to be 550 and 514 h, respectively. Evaluations in terms of drying quality indicated that better results were achieved with the mild schedule, especially when comparing drying defects and final MC. From an energy efficiency point of view, the harsh schedule, by saving 36 h of drying time, reduced electricity by 594 KWh and was therefore found to be $65 more profitable in this trial.     

Application of a Three-dimensional Wind Driven Circulation Model to Assess the Locations of New Drinking Water Intakes in Lake Ontario

A 3D transport model is used to perform a comparative analysis of several potential drinking water intakes located along the northwest shore of Lake Ontario between Toronto and Oshawa. The model is specifically used to assess each intake under both long- and short-term transport of a potential pollutant release from the Pickering Nuclear Generating Station and potential and actual pollutant releases from local land sources respectively. A model based on a 500 m grid resolution is calibrated using data collected in the aftermath of the 1992 tritium spill at the Pickering Nuclear Generation Station and subsequently used to simulate long-term transport. A model based on a 100 m grid resolution is verified using drogue studies and used to simulate short-term transport events. Both models are used to assess pollutant levels at each of nine potential intake locations under different wind scenarios and pollutant releases. Field data for the study included water quality and flow measurements from local sewers and rivers, and estimates of pollutant levels from the local waste water treatment plants. This paper describes the model setup for both the long-term and short-term transport models, calibration using field data, long-term transport modeling, short-term transport modeling, and the comprehensive analysis approach used to evaluate the nine potential intake locations proposed. Results indicated that four intakes in particular outperformed other intake locations by maintaining bottom pollutant levels within governmental standards and warning times that exceeded 20 hours.     

肝单光子发射计算机断层若干物理因素的讨论

我们于1985年对我院1984年开展肝单光子发射计算机断层以来的52例肝病人进行了分析总结。结果表明,肝单光子发射断层在诊断肝内占位性病变方面比普通肝静态γ照相有许多优点。需要指出的是,肝单光予发射断层的若干优点及诊断的准确性是与物理条件的正确选择和应用密切相关的。本文根据至今积累的近100例断层经验,从技术方面介绍了影响单     

基于小波熵的电容器扰动识别和定位

对投电容器扰动识别和定位的方法进行了改进。针对其他此类方法的不足，比如在电压幅值低时投电容器扰动的识别、定位“可信度不高”等，文中通过提取小波变换的特定层的系数，对需要识别的电容器扰动的分解信号相对增强，而其他扰动的分解信号相对减弱，然后再提取熵特征值，结果表明它可以作为识别低电压时投电容器扰动的依据。在对电容器扰动进行定位时，参考了功率和能量定位法，并对其进行了改进。仿真分析证明，在电压幅值较低时，可以准确和可靠地对电容器扰动进行识别和定位。