基于红外光学原理的便携式甲烷报警仪

提出了基于红外光学原理的便携式甲烷报警仪的设计方案,详细介绍了报警仪的硬件电路设计、软件设计、光学气室结构、外形结构设计及标定技术。该报警仪采用红外光源、高精度干涉滤光片一体化热释电探测器和单光束双波长技术,配合镀金膜气室实现对CH4等气体的实时检测,具有不易老化、响应快、灵敏度好、性能稳定、抗干扰能力强等优点。     

便携式光离子化有害气体检测仪的设计

针对室内空气污染源的多样性与传统气体检测器检测种类的单一性的矛盾,设计了一种能够同时检测多种气体的新型便携式光离子化气体检测仪.该检测仪采用了MEMS结构的离子化室和混合信号级微处理器C8051F040,减小了仪器体积,降低了仪器功耗.利用单片机控制电流跨导增益的方法,实现了仪器的双量程数据采集功能,保证了仪器在两个量...     

Performance of Sewage Sludge Treatment and Electricity Generation by Different Configuration Microbial Fuel Cells

This paper compared the degradation efficiency of sludge organic matters and electric-production by two typical microbial fuel cells——dual-chamber microbial fuel cell(DMFC)and single chamber air cathode microbial fuel cell(SAMFC),and the variations of sludge protein,polysaccharide and ammonia nitrogen within the systems were also investigated.The results showed that the concentration of sludge soluble chemical oxygen demand,protein and carbohydrate of DMFC are higher than these of SAMFC during the systems operation,while DMFC can achieve a better ammonia nitrogen removal than SAMFC.Under the same operation condition,the stable voltage output of DMFC and SAMFC is 0.61 V and 0.37 V;the maximum power density of DMFC and SAMFC is 2.79 W/m3and 1.25 W/m3;TCOD removal efficiency of DMFC and SAMFC is 34.14%and 28.63%for 12 d,respectively.Meanwhile,DMFC has a higher coulomb efficiency than SAMFC,but both are less than5%.The results showed that DMFC present a better performance on sludge degradation and electric-production.     

汽包水位温压补偿控制系统研究和应用

对汽包双室平衡容器水位温压补偿控制系统进行了探讨和研究,根据温压补偿模型,分析了P L C系统难以独立实现的原因以及查表法的缺陷,提出了P L C系统与上位机系统相结合的水位温压实时连续补偿的综合控制策略,提出并分析比较了三种体系结构及其实现原理和技术,工程应用结果表明该控制系统提高了水位控制的实时性、稳定性、准确性和安全性。     

用于KM6载人航天器空间环境模拟器氦制冷机的系统设计

描述了用于KM6载人航天器空间环境模拟器氦制冷机的系统设计。介绍了制冷循环和纯化方法的选择、系统参数的确定、制冷循环流程图和系统的主要特点。制冷机采用并联的气体润滑透平膨胀机，其设计制冷量为600W(20K)。采用了液氮预冷的布雷顿循环和低温吸附内纯化器。     

Pressurised chamber design for conducting rolling contact experiments with liquid refrigerant lubrication

A novel pressurised chamber was designed to construct a special purpose test rig to achieve saturated liquid state of refrigerants for lubricated rolling contact fatigue experiments. Traditional bench testing using refrigerants as the lubricant is difficult due to the gaseous phase at standard atmospheric conditions. Pressurising the concentrated contact test chamber is therefore necessary to evaluate at a liquid state and therefore simulate practical applications. The gas/liquid phase transitions have a significant influence on the lubricant properties and hence wear mechanisms. It is necessary to modify the wear test conditions for the Hydrocarbon (HC) and Hydrofluorocarbon refrigerants to obtain realistic simulation of refrigerator compressor tests. The chamber design and test rig are described in this paper. A preliminary experimental study of the influence of the HC (R600a) on rolling wear of the silicon nitride (Si₃N₄)/steel elements using the pressurised chamber is presented. Rolling fatigue test methods are adopted to measure the wear performance of silicon nitride/steel bearing materials. In this case the rolling wear mechanisms of Si₃N₄ were measured using R600a refrigerant lubrication.     

Development of a Position Sensitive Neutron Detector with High Efficiency and Energy Resolution for Use at High-Flux Beam Sources

We are developing a high-efficiency neutron detector with 1 cm position resolution and coarse energy resolution for use at high-flux neutron source facilities currently proposed or under construction. The detector concept integrates a segmented ³He ionization chamber with the position sensitive, charged particle collection methods of a MicroMegas detector. Neutron absorption on the helium produces protons and tritons that ionize the fill gas. The charge is amplified in the field region around a wire mesh and subsequently detected in current mode by wire strips mounted on a substrate. One module consisting of a high-voltage plate, a field-shaping high-voltage plate, a grid and wire strips defines a detection region. For 100 % efficiency, detector modules are consecutively placed along the beam axis. Analysis over several regions with alternating wire strip orientation provides a two-dimensional beam profile. By using ³He, a 1/v absorption gas, each axial region captures neutrons of a different energy range, providing an energy-sensitive detection scheme especially useful at continuous beam sources.     

基于屏栅电离室的双参数谱仪研制及其应用

以屏栅电离室为基础，同时引出其阳级和阴极信号，研制了1台能够同时记录两路信号的双参数谱仪，在DEC－3000工作站上编制程序，实现了双维谱数据的获取、显示和存储。利用所建立的谱仪，测量了α放射源的双维谱，计算了α粒子的角分布，并讨论了如何利用角分布来校正活度测量中自吸收和反散射的影响以及改善电离室阳极能谱的能量分辨率。     

硅微条探测器

硅微条探测器的位置分辨率可好于σ＝1．4μm，这是任何气体探测器和闪烁探测器很难作到的。主要介绍硅微条探测器的特点、结构、工作原理及其在近年来的发展和在高能物理、核医学等领域应用概况。     

新型引水式电站布置方式在小天都水电站的建设实践

四川省甘孜藏族自治州康定县境内的小天都水电站 ,在优化设计中采用了气垫调压室技术和新型的“一坡到底”方式布置引水洞线的布置方式。具有技术先进、安全可靠、投资省、工期短的优点 ,为解决工程建设中地质、环境影响的两大难题铺平了道路