Soy protein combined with copper and boron compounds for providing effective wood preservation

Chromated copper arsenate (CCA), an arsenicbased wood preservative, is toxic to human health and the environment. Although CCA is stable in seasoned wood, there are potential dangers during CCA manufacture, lumber treatment, and waste disposal. This research was conducted to study the effectiveness of soy products to replace toxic chromium and arsenic compounds in wood preservative formulations. Three soy product (Arpro 2100, HM 90, and Supro 760) were used as fixative agents in preservative solutions containing anhydrous CuSO₄ and Na₂B₄O₇·10H₂O. The decay resistance of treated wood blocks was measured by a soil-block culture method. Despite the large molecular sizes of copper-protein and copper-boron-protein complexes, southern pine sapwood was treatable with these preservative formulations. Wood samples treated with >6 kg°m⁻³ CuSO₄ and 7.5 kg·m⁻³ soy product, and subsequently leached for 3 d and exposed to the decay fungus Gloeophyllum trabeum (Fr.) Mur., sustained only 0.5% weight loss over 12 wk. Wood samples needed 40 kg·m⁻³ CuSO₄ and 50 kg·m⁻³ soy protein to resist the copper-tolerant decay fungus Postia placenta (Fr.) M. Lars. & Lomb. These results suggest that soy-based wood preservatives can prevent wood products from fungal attack and can replace CCA.     

准同型相界附近(Na1-xKx)0.5Bi0.5TiO3的制备及性能研究

利用固相法制备了（Na1-xKx）0.5Bi0.5TiO3系压电陶瓷，XRD分析表明所得陶瓷样品为纯的钙钛矿结构，其准同型相界在x=0．18～0．22之间；电子探针显微分析显示所做陶瓷样品晶粒发育良好，具有规则的外形和明显的晶界；实验所得陶瓷样品损耗tanδ最大不超过5％，最好的压电常数d33=153 pC／N，平面机电耦合系数kp=0．299，它们分别出现在x=0．22和0．20处。     

氯氧化锆生产中除钠工艺的研究

概述烧碱生产氯氧化锆工艺的传统方法，介绍新的除钠方法，该法比传统方法具有明显的优势。     

肌氨酸钠的合成研究

研究了合成肌氨酸钠的新方法，在优化合成条件的基础上，确定了此合成方法的最佳工艺条件：n羟基乙腈：n甲胺（物质的量比）为1：1．10－1：1．15；nNaOH:n羟基乙腈（物质的量比）为1：1．46－1：1．56；综合反应温度为10℃；水解温度为90－100℃；缩合反应滴加后的反应时间为1h。并且得出了较高的收率。     

不同木质素磺酸钠对豆粕胶黏剂性能的影响

通过FTIR、元素分析、GPC对4种不同来源的木质素磺酸钠进行物理化学性质分析,并将其与水性聚酰胺协同改性豆粕胶黏剂(简称豆粕胶),利用测试接触角、剪切黏度和湿态胶合强度考察改性前后胶黏剂的浸润性、流变特性以及所得胶合板的胶合性能.红外谱图分析表明,在1065 cm–1附近出现了磺酸基或磺甲基中S==O的伸缩振动吸收峰,证明木质素经过磺化反应或磺甲基化反应得到木质素磺酸钠;木质素磺酸钠中磺酸基含量越高,经其改性的豆粕胶的零剪切黏度越低且在木材表面的润湿性越好;豆粕胶黏剂与杨木单板的接触角从未改性的95°降到改性后的61°;与水性聚酰胺协同改性后的豆粕胶制得胶合板的湿态胶合强度达到0.92 MPa,合格率为100％,满足国家Ⅱ类胶合板的标准要求(胶合强度≥0.70 MPa,合格率≥90％).     

环流式碳化塔研究与操作实践

遵循过程不冷却,结晶为控制过程等工艺原则、操作理论和技术路线,在 164×3620环流式碳化塔中分别进行了联合制碱法和氨碱法母液的碳酸化重碱结晶过程模拟试验,介绍了主要条件试验和连续运转120h的试验数据,讨论了晶浆浓度、操作过饱和度、液体环流速度、结晶温度和溶液碳化度等结晶过程工艺参数,考察了二氧化碳吸收传质总系数并比较了塔的二氧化碳吸收容积能力和重碱结晶容积能力,测定了碳酸氢钠平均结疤速度。     

Sodium alginate–poly(hydroxyethylmethacrylate) interpenetrating polymeric network membranes for the pervaporation dehydration of ethanol and tetrahydrofuran

Interpenetrating polymeric network (IPN) membranes of sodium alginate (NaAlg) and various amounts of poly(hydroxyethylmethacrylate) (PHEMA) have been prepared and tested for the pervaporation dehydration of ethanol and tetrahydrofuran (THF). The presence of hydrophilic PHEMA in the IPN matrix was found to be responsible for increase in membrane selectivity to water. NaAlg–PHEMA IPN membrane containing 20 wt % of PHEMA exhibited a selectivity of 571 to water for the water–ethanol mixture and 857 for water–THF mixture. These data are much better than those observed for the pristine NaAlg membrane. However, flux of the IPN membranes was smaller than that of pristine NaAlg membrane. Comparatively higher flux values were observed for water–THF mixture than for water–ethanol mixture. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 101: 3324–3329, 2006     

丙烯腈/醋酸乙烯酯/甲基丙烯磺酸钠三元水相共聚体系竞聚率的研究

根据该AN/VAC/SMAS三元共聚体系特征,根据竞聚率计算的原理,融合二元共聚和三元共聚的基础理论,利用核磁共振技术测定共聚物组成,用Mayo-lewis共聚物组成方程拟合实验数据计算竞聚率.同时研究了AN/VAC/SMAS三元水相共聚反应体系的特征,测定了该三元共聚体系表现竞聚率.     

含盐次氯酸钠酮连氮法制备水合肼研究

研究了酮连氮法制备水合肼 ,并考察了原料次氯酸钠的质量浓度以及氯化钠的含量对合成的影响。试验结果表明 ,次氯酸钠的质量浓度对合成水合肼影响较大 ,而原料中氯化钠的含量对合成水合肼影响不大 ,但对分离提纯操作工艺有一定影响。     

Electrochemical studies of pyrite oxidation and reduction using freshly-fractured electrodes and rotating ring-disc electrodes

Oxidation and reduction processes on coal- and mineral-pyrite surfaces have been investigated to better understand the reactions that control the hydrophobicity and flotation behavior of pyrite. The incipient oxidation and reduction reactions were studied using fresh surfaces of pyrite that were created by in situ fracturing electrodes potentiostated at a predetermined potential. Chronoamperometry immediately after fracture and subsequent cyclic voltammetry have established that fresh fracture surfaces of pyrite instantaneously assume a unique potential (referred to as the “stable” potential) at which neither oxidation nor reduction takes place. For Peruvian and Chinese pyrites, the stable potential is −0.28 V (standard hydrogen electrode, SHE) at pH 9.2 and 0 V at pH 4.6. The initial oxidation of pyrite begins at potentials slightly positive of the stable potential and is believed to produce a hydrophobic sulfur-rich species, most likely a polysulfide or metal-deficient sulfide. A rotating ring-disc electrode (RRDE) was employed to study the kinetics and mechanisms of surface reactions on pyrite over moderate potential ranges. Two distinct soluble reduction products (ferrous hydroxide and HS⁻) and one distinct soluble oxidation product (ferrous hydroxide) were observed on pyrite in alkaline solutions. It is concluded that the initial oxidation of pyrite and the oxidation of ferrous to ferric hydroxide occur in a similar potential range. When the electrode is oxidized, e.g. by polishing, prior to experiments, the initial oxidation of pyrite is masked by the oxidation of ferrous hydroxide, making it difficult to study the oxidation of pyrite itself.