f—x域内提高地震资料的信噪比

在 f-x 域,地震记录可以表示成有限个调频调幅正弦波的叠合,叠合的结果是一个连续且光滑的函数。我们可以用一个简单的 n 次多项式去逼近这个函数。本文提出了一种在 f-x 域用最小平方拟合原理消除随机噪声的新方法,并证明了在噪声为自噪以及空间采样足够密的条件下,拟合结果与噪声无关,即 f-x 域最小平方拟合处理可以有效地消除记录上的随机白噪,而对有效信号的破坏甚微。由于理论上允许振幅值及同相轴形态在空间上发生变化,因而该方法不具有混波作用,是高分辨率处理的理想工具。     

光孤子相互作用对压缩态的影响

在线性近似条件下，量子化了非线性薛定谔方程，用后向传播法数值求解了光孤子相互作用对压缩比的影响。数值结果表明，在碰撞距离附近，压缩比显著增加。     

高效防气防砂一体化管柱的研制与应用

为解决文南油田高气液比井出砂易造成卡泵的问题,研制了高效防气防砂一体化管柱。该管柱主要由闭式气锚、重力式防气装置和激光割缝筛管3部分组成。闭式气锚的分离作用消除了气体对抽油泵的影响,提高了泵效;重力防气装置利用液气分离原理和高烟囱原理进行液气分离,液流回流时间可达10min,排气最高压差可达0.2MPa;经激光割缝筛管过滤后的液体含砂粒外径小于0.05mm。该管柱在文南油田现场应用16井次,累计增液6000t,增油2717t,平均单井泵效提高7%。     

用试井方法确定注水后地层渗透率的变化

大港油田已进入开发中后期，高含水油田占73％，开发初期的一些参数已不适合现在开发的需要。研究出一套用试井方法确定注水以后地层渗透率变化的方法，对大港油田的增储上产具有重要意义。     

On the hollowness ratio effect on the dynamics of a spinning Rayleigh beam

The analytical solutions of a spinning Rayleigh beam with rotatory moment inertia and gyroscopic effect are presented in this paper. The critical speeds can be written analytically in a function of the length-to-radius ratio (l) defined by the beam's length over its outer radius and the hollowness ratio (α) defined by the hollow area over the total area of the cross section. The sensitivity analyses show that the critical speed is decreasing with l, but increasing with α. Moreover, α is more sensitive to the critical speeds. The design of a spinning beam should therefore be emphasized more on the hollowness factor. Contrary to common belief, only finite critical speeds exist and the number is independent of the boundary conditions. It increases monotonically with l, but decreases with α. The steady state unbalanced response can therefore be expressed analytically by the finite precessional modes and the corresponding generalized coordinates.     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry     

复合沉淀氯化镨钕工艺研究

针对草酸沉淀成本高的问题，提出了复合沉淀的方法，试验结果及生产应用都证明了此方法能达到降耗同效的目的。     

降低氧化铝生产中熟料折合比的探讨

在氧化铝生产过程中，熟料折合比是烧结法一项重要的综合性指标，本文通过对熟料折合比的定义、计算公式的剖析，分析了生产过程中影响熟料折合比的主要因素，对有效降低熟料折合比的措施进行了探讨。     

房间空调器高效节能技术分析

本文主要介绍了高效节能型空调器的优化设计，包括选用高效压缩机、增大换热面积，增大风量、管路的合理设计，旨在提高制冷量，降低功耗，提高能效比。     

基于自然地理形态的道路测设及其曲线方程的拟合

在山区村镇及风景旅游名胜区的建设中，其道路的曲线测设，往往要基于自然地理形态进行，也就是路径的选择，有时具有不可选择性，且要求与实地具有最大的符合性。因此，其测设的作业方法不同于一般意义的道路测设；其曲线方程的建立，也是极其困难的。本就基于自然地理形态的道路测设工作的曲线类型的选择、曲线的拟合方法、曲线方程的建立及其数据的计算，提出了利用CAD技术进行曲线拟合、曲线方程的建立、曲线计算的实用技术方法。