孔径法测量铜带残余应力的试验研究

介绍了用于薄板残余应力测量的新方法——孔径法,该方法是通过测量冲孔直径的变化来间接求出各方向的残余应力;文中详细阐述了残余应力的标定方法;由于可针对不同材料建立了被测材料的平均应力(σ_l)与被测板材宽度(B)、厚度(H)以及冲孔后直径变化率(△D_i/D)之间的数学模型,因而使薄板残余应力测量变得简便而经济;此外还对该方法的分辨率与测量精度进行了实验、计算与分析。     

Rene′95粉末合金喷丸强化研究

研究了Ｒｅｎｅ′９５热等静压粉末高温合金喷丸后的残余应力场、组织结构、致密度及其与疲劳性能的关系。结果指出，喷丸强化能够有效地提高合金高周和低周疲劳强度。     

垂直平行束状孔爆破模型试验与分析

垂直平行密集束状孔落矿有底柱崩落法是一种新的采矿方法。通过爆破模型试验，测试爆破应力，观察分析爆破效果，探求最佳布孔形式，选择最优爆破孔网参数。试验结果表明：用平行束状孔取代扇形落矿，改善了爆破效果，简化了采场结构，减少了采切工程量。     

Electrochemical intercalation in NiOx thin films

In this work we investigated the mechanism of the electrochemical intercalation reactions in rf sputtered nickel oxide thin films electrodes by two techniques: mechanical stress change measurements by means of an optical technique and mass changes using an electrochemical quartz microbalance (EQCM). The experiments were performed in alkaline electrolytes containing cations of the first column of the periodic table. Reversible mass and volume changes were observed. In order to explain these experimental results, an exchange reaction is proposed, in which the oxidation process is accompanied by the deinteractional of a relative large number of “light” cations, simultaneously with the intercalation of a smaller number of heaviest cations.     

Longitudinal elastic waves in columns due to earthquake motion

An analysis is presented of longitudinal waves in a thin elastic column. Velocity is specified at one end, and the boundary condition at the other end is expressed in terms of a range of effective impedances of an attached structure. Propagation, reflection and interference of the waves are followed by the method of characteristics. Integration of differential equations along characteristics yields the wave-induced stress, which is then applied to problems of earthquake excitation. Numerical examples are given for recorded updown ground motion of the Kobe Earthquake.     

Relaxation phenomena caused by equilibration of point defects

Relaxation phenomena due to equilibration of point defects in metals are reviewed. The relaxation effect in specific heat observed in tungsten and platinum confirms that in both cases the nonlinear increase in the high-temperature specific heat has to be attributed to point-defect formation. Relaxation phenomena observed by measurements of electrical resistivity and positron annihilation are also considered. The comparison of the data seems to be favorable for the conclusion that all the phenomena are of one origin.     

Gas diffusion and dielectric studies of polystyrene‐fullerene compositions

Polystyrene‐fullerene compositions containing up to 0.45 mol % (3 wt %) fullerene C₆₀ were investigated. It was established that the addition of fullerene to polystyrene (PS) leads to an increase of molecular packing density and so influences the transport of small molecules through the polymer films. Gas diffusion through films of PS‐fullerene compositions is slower than through PS films, and gas separating properties of compositions are higher. Dielectric studies showed that the fullerene is distributed as clusters in the polymer matrix of solid composition prepared from a toluene solution of PS and fullerene. Heating without air to the temperature higher than PS glass transition leads to increasing relaxation time of α‐transition in PS of compositions containing >0.15 mol % (1 wt %) fullerene. This effect is caused by rather strong interaction of PS chains via fullerene molecules entered into the PS‐fullerene complex. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 85: 2946–2951, 2002     

Surface stress effects on the thermodynamics of epitaxy

An analysis of the thermodynamics of epitaxy in thin films is presented which includes the effects of the surface stresses of the free surface and the film-substrate interface. It is shown that these effects, which are usually ignored in the theory of epitaxy, can have a major influence on both the critical thickness for epitaxy and on the partitioning of the misfit strain between the volume elastic strain and interface dislocations.     

圆杆弹性和弹—塑性扭转公式的探讨

对圆杆在线弹性阶段，弹－塑性阶段和全塑性阶段的扭转剪应力的计算公式作了分析，并推导了在材料的应力－应变关系（τ－γ关系）不服从虎克定律时，扭转真实剪应力的计算公式。文中对扭转强度计算公式的来源，物理含义及其都作了详细的说明。这对执行和理解国家ＧＢ１０１２８－８８《金属室温扭转试验方法》是有益的，而且对高校中材料力学的教学具有一定的参考价值。     

地应力及其测量法简介

地应力对工程岩体的稳定性影响很大，工程实践中常需定量地确定工程范围内的地应力。本文简要地介绍了地应力的概念、应用及常用的测量方法。