全文获取类型
收费全文 | 117849篇 |
免费 | 9649篇 |
国内免费 | 8078篇 |
专业分类
电工技术 | 8914篇 |
技术理论 | 2篇 |
综合类 | 8642篇 |
化学工业 | 23535篇 |
金属工艺 | 7112篇 |
机械仪表 | 8493篇 |
建筑科学 | 4699篇 |
矿业工程 | 2597篇 |
能源动力 | 4161篇 |
轻工业 | 8074篇 |
水利工程 | 1422篇 |
石油天然气 | 5220篇 |
武器工业 | 1046篇 |
无线电 | 15001篇 |
一般工业技术 | 12319篇 |
冶金工业 | 3276篇 |
原子能技术 | 1583篇 |
自动化技术 | 19480篇 |
出版年
2024年 | 345篇 |
2023年 | 1543篇 |
2022年 | 2759篇 |
2021年 | 3216篇 |
2020年 | 3034篇 |
2019年 | 2931篇 |
2018年 | 2748篇 |
2017年 | 3604篇 |
2016年 | 3880篇 |
2015年 | 4032篇 |
2014年 | 5748篇 |
2013年 | 6791篇 |
2012年 | 7151篇 |
2011年 | 8447篇 |
2010年 | 6811篇 |
2009年 | 7669篇 |
2008年 | 7552篇 |
2007年 | 8307篇 |
2006年 | 7817篇 |
2005年 | 6422篇 |
2004年 | 5507篇 |
2003年 | 5263篇 |
2002年 | 4285篇 |
2001年 | 3445篇 |
2000年 | 3010篇 |
1999年 | 2447篇 |
1998年 | 1792篇 |
1997年 | 1410篇 |
1996年 | 1302篇 |
1995年 | 1298篇 |
1994年 | 1147篇 |
1993年 | 939篇 |
1992年 | 739篇 |
1991年 | 455篇 |
1990年 | 317篇 |
1989年 | 290篇 |
1988年 | 212篇 |
1987年 | 137篇 |
1986年 | 134篇 |
1985年 | 109篇 |
1984年 | 98篇 |
1983年 | 62篇 |
1982年 | 68篇 |
1981年 | 61篇 |
1980年 | 38篇 |
1979年 | 28篇 |
1978年 | 25篇 |
1977年 | 22篇 |
1976年 | 28篇 |
1975年 | 20篇 |
排序方式: 共有10000条查询结果,搜索用时 0 毫秒
131.
本文研究在13SiMnNiCrMoV 结构钢中用尖裂纹的应力强度因子来反映三点弯曲缺口试样的疲劳裂纹萌生规律。当 R=0.1,f=100Hz,试样尺寸 B×W×L=12.5×25×117mm 时,缺口名义应力幅的门槛值为Δσ_(th)=3315ρ~(0.352) MPa,0.5mm≤ρ≤5mmΔK_(th)=250ρ~(0.352) MPam~(1/2)门槛值与ρ有关。同时得到缺口裂纹萌生的循环次数 N_i 与名义应力幅Δσ、缺口曲率半径ρ的定量关系是N_i=3.98×10~(22)ρ~(1.62)/Δσ~(4.85),N_i≤10~(5.5)并讨论了(ΔK_1/ρ~(1/2))_(th)与ρ无关的结论。 相似文献
132.
A simplified method for the preparation of particles from liquid suspensions has been developed. Particles are deposited directly on carbon planchets for rapid analysis by environmental scanning electron microscopy or by conventional scanning electron microscopy after an additional drying step. This is accomplished by filtering the liquid through thin carbon planchets. Three different grades of graphite were investigated for their suitability as the source material for these planchets. The high quality isomolded graphite is recommended for the filtration and direct observation of particles by electron microscopy. This technique is demonstrated for particles in hydraulic fluid and aquatic suspended particulate material from a natural water source. 相似文献
133.
134.
有机盐聚合醇氯化钾钻井液的应用 总被引:5,自引:2,他引:3
霍尔果斯背斜构造极其复杂,内应力极高,地层倾角大,断层、破碎带多,并存在高低压互层;安集海河组的灰绿色软泥岩水化严重并具有粘弹塑性.该区块重点探井霍003井三开、四开井段选用有机盐聚合醇氯化钾钻井液,同时为保证钻井液在高密度下(2.55 g/cm^3)具有好的流变性,使用活化铁矿粉、活化重晶石加重.应用结果表明,由于采用了强抑制和多元封堵的措施,该钻井液具有良好的流变性和较强的携带能力,钻进中曾携带出重2.8 kg和5.1kg的大掉块;滤失量低,泥饼质量好,封堵能力强,造壁能力强,减轻了井下阻卡程度;有良好的储层保护能力;在室内研究的基础上,经过现场合理使用和维护钻井液,霍003井提高了机械钻速,缩短了钻井周期,井身质量优于邻井.指出在高密度下,未选出适合有机盐聚合醇氯化钾钻井液的稀释剂,钻井液流动性较差. 相似文献
135.
Yong Ma Yong‐zhen Peng Xiao‐lian Wang Shu‐ying Wang 《Journal of chemical technology and biotechnology (Oxford, Oxfordshire : 1986)》2005,80(10):1118-1124
The laboratory scale anaerobic–anoxic–aerobic (A2O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry 相似文献
136.
Hiroshi Ohta Tomoyuki Hirota Abdur Rahim 《The International Journal of Advanced Manufacturing Technology》2007,33(1-2):36-41
This paper analyzes a multi-product production / inventory system where demands for each item arrive according to a Poisson
process and the production time for each product has an Erlang distribution. The paper proposes an optimality condition that
specifies whether each product should be produced make-to-stock or make-to-order. In the event a product should be produced
make-to-stock, an approach for computing the optimal base-stock level is proposed. Numerical examples are given for illustrative
purpose. 相似文献
137.
LM2717型双降压直流/直流变换器的原理及其应用设计 总被引:1,自引:1,他引:0
LM2717是美国国家半导体公司推出的一款全新的高性能变换器,内含两个脉宽调制(PWM)直流/直流转换器,功能强大.介绍了该器件的主要参数、工作原理和引脚功能,讨论利用LM2717进行应用设计时选择外部器件的原则及设计中应注意的问题. 相似文献
138.
LIU Shu-ping JIA Yue-hu 《半导体光子学与技术》2006,12(1):21-24
According to Maxwell's theory, the optical transmission characteristics in GeSi/Si superlattice nanocrystalline layer have been analyzed and calculated. The calculated result shows that when the total thickness L is 340 nm, the single mode lightwave can be transmitted only at periodic number M≥15.5. In addition, at the direction of transmission, when the transmission distance is larger than 500 μm, the lightwave intensity is decreased greatly. Based on the above parameters, the design and manufacture of GeSi/Si superlattice nanocrystalline photodetector are carried out. 相似文献
139.
140.
In previous work, it has been found that a hydrogen-covered Pt(110) surface is acidic, but quantification of the acidity has not yet been done. In this paper a spectroscopic method is developed to measure the acidity of a metal surface for the first time. The technique involves measuring the intensity of the N–H stretch from the C5H4XNH+ that forms when hydrogen coadsorbs with pyridine, 2-fluoropyridine and 3-fluoropyridine. The Bethe approximation is then used to estimate the metal surface acidity/electronegativity (MSAEL). The proton affinity/MSAEL of Pt(110) has been determined to be 907 ± 4 kJ/mol at high coverage. This is the first time the MSAEL has been measured on a metal surface. Implications for fuel cell catalysis are discussed. 相似文献