Fenton试剂处理苯酚和甲醛废水的研究

用H2O2同Fe^2 结合的Fenton试剂处理有机废水是一种经典的催化氧化法，这种方法适合于处理废水中高浓度、难降解的有机物质。主要研究了Fenton试剂处理含苯酚和甲醛有机废水样的反应机理和影响因素，试验结果表明：废水中苯酚和甲醛的去除率均可达到95％以上，COD去除率达到85％以上，表明用Fenton法处理含苯酚和甲醛的有机废水是一种非常有效的方法。     

Pervaporation performance analysis and prediction—using a hybrid solution-diffusion and pore-flow model

A hybrid mathematic model for pervaporation is proposed which incorporates the concepts of solution-diffusion model and pore model. The model allows performance prediction as well as the establishment of the internal concentration and pressure profiles within the membrane. The model parameters specific to the particular membrane and mixture system are determined using liquid sorption and pervaporation experimental data. The model is experimentally examined using ethanol–water mixtures and poly(dimethyl siloxane)–poly(vinyldiene fluoride) (PDMS–PVDF) composite membranes. The characteristics of flux and separation factor predicted using the model are in fair agreement with the experimental data under various feed concentrations and downstream pressures for different membrane arrangements, including single-layer, reverse single-layer and double-layer PDMS–PVDF composite membranes. Internal profiles of pressure, concentration and component mole fraction can be established using the model. Concentration polarization phenomena for ethanol and water are located at membrane interfaces and vapor–liquid interfaces, respectively. Performances of several different membrane designs are compared using the model.     

纺牵—步法中粗旦丙纶长丝沸水收缩率初探

在纺牵联合一步法纺丝机上研究了丙纶切片的熔融指数对纤维沸水收缩率的影响，发现熔融指数高的切片，其纤维的沸水收缩率变化大。沸水收缩率随热定型的温度升高而下降。沸水收缩率可根据用户提供中心值（Ｍ）通过实验确定，一般以Ｍ±１．５为宜。     

Moisture Distribution and Dewatering Efficiency for Wet Materials

This review paper summarizes current research efforts toward a comprehensive view of wet material dewatering, considering the binding energy as the strength to hold water, and rupture energy given to remove moisture from materials.     

凹凸棒粘土用作高水速凝注浆悬浮剂

以凹凸棒粘土作为高水速凝固化充填材料的悬浮稳定剂，考察了不同制浆机械对凹凸棒粘土制浆率的影响。采用高剪切混合乳化机预制的1％凹凸棒粘土浆配制高水速凝固化充填材料甲、已料单浆可获得满意的悬浮稳定效果。其充填体结石抗压强度早期发展迅速，后期持续增长。采用此工艺，注浆料的材料成本仅增加2％。     

Effect of test frequency and water content on localized crack-tip heating in nylon-6,6

Fatigue crack propagation (FCP) tests were conducted at various frequencies on nylon-6,6 specimens equilibrated over a range of moisture levels to determine the crack growth rates and the crack-tip temperatures as a function of water content. Frequency-sensitivity was correlated with the amount of crack-tip heating taking place, with crack-tip temperature being found to depend strongly on the estimated loss compliance, D″, of the material. The frequency-sensitivity of FCP in nylon was seen also to be affected by mean stress, suggesting that creep processes are often significant in FCP of nylon.     

中央空调的水处理

本文扼要介绍了中央空调循环冷却水和冷冻水系统中常见的问题及其原因,并对冷却水和冷冻水的处理程序作了初步的阐述.     

呼和浩特石化公司凝结水回收改造工程总结

本文主要对呼和浩特石化公司凝结水回收系统改造前的状况、采取的改造措施及改造后的效果进行了总结，并就今后可能的改造作了预测分析。     

Modification of leather properties by grafting. I. Effect of monomer chain on the physico‐mechanical properties of grafted leather

Although leather has a number of desirable properties such as thermal stability and fire retardancey, in addition to high toughness, it has a few drawbacks such as weight, high water absorption, poor soil and rot resistance, and nonuniformity. If these defects are overcome, leather's usefulness would be further enhanced and its competitive position with respect to synthetics would increase. This study reports the physical and mechanical properties of buffalo leather after chemical graft copolymerization with ethyl acrylate, butyl acrylate, and 2‐ethyl hexyl acrylate using benzoyl peroxide as an initiator. The optimum conditions for grafting (e.g., monomer and initiator concentrations, temperature and time of grafting, and solvent leather ratio) were extensively investigated. The study achieved outstanding properties for buffalo leather in reduction of water uptake after grafting, especially on using 2‐ethyl hexyl acrylate and butyl acrylate monomers. FT‐IR and solid ¹³C‐NMR for leather before and after grafting confirmed the grafting process.© 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 1478–1483, 2003     

新一代水管式沉降仪控制模块的研制

新一代低功耗水管式沉降仪控制模块是基于16单片机MSP430F5436为处理器的低功耗装置.该文详细介绍了其硬件结构和工作原理,分别从电源系统、电磁阀控制电路、控制流程、数据采集等部分阐述了其特点,诠释了水管式沉降仪控制模块在人机交互、工作稳定性等多方面所具备的优势.新一代水管式沉降仪控制模块已在实际工程中得到了成功应用,其稳定性和精确性为大坝监控系统提供了准确的实时数据.