《胶结颗粒料筑坝技术导则》亮点 解读与思考

近期即将出台的《胶结颗粒料筑坝技术导则》（以下简称《导则》）,是水利部第一次规范性指导堆石混凝土及胶凝砂砾石发展的技术性文件,必将对堆石混凝土技术发展体系的构建起到标杆的作用,对推进我国环保节能型社会发展具有重要意义。本文就《导则》中关于堆石混凝土技术的一些要点做些解读,并就技术在推广应用中应注意的问题提出建议。     

Properties and mechanism of red mud in preparation of ultra-lightweight sludge-red mud ceramics

New ultra-lightweight sludge-red mud ceramics (ULS-RMC) were prepared by red mud (RM), clay and dried sewage sludge (DSS). The properties and mechanism of RM in the preparation of ULS-RMC were discussed. The chemical components, thermal properties and mineral phases of RM were determined by energy dispersive X-ray (EDX), differential scanning calorimetry/thermal gravimetric analysis (DSC/TGA) and X-ray diffraction (XRD), respectively. Constant dosage of DSS to clay and different amounts of RM were utilized in the preparation of ULS-RMC. Physical properties test (bulk density, grain density, water absorption and expansion ratio), XRD and scanning electron microscopy (SEM) were employed to characterize the ULS-RMC. The results show that RM exhibits high hydroscopic property and good water-retention property, and bloating property and fluxing property of RM are caused by abound of gaseous components and flux, respectively. The two chemical properties are utilized to discuss the mineral phases and microstructures differences between ULSC and ULS-RMC.     

好氧颗粒污泥脱氮除磷效率研究

以实验室模拟废水为进水,在SBR反应器中利用好氧颗粒污泥进行N、P的去除效率研究.研究表明:在运行周期约为4h,进水COD控制在500～1200 mg/L之间,室温条件下,好氧颗粒污泥对COD、氨氮、硝氮、TP的去除率稳定维持在97％、95％、92％、86％,说明好氧颗粒污泥特有的结构特性和生物特性有利于脱氮除磷.     

浸提时间对城市污泥重金属浸出特性的影响

在研究含工业废水污泥中Zn、Cu、Pb、Cr、Mn、Ni含量的基础上,应用固体废物浸出毒性方法,以不同浸出时间对污泥中重金属的浸出特性进行了实验研究.结果表明:污泥中Mn和Zn含量较高,其次为Cu和Ni,而毒性较大的Pb和Cr含量较低.浸提时间对污泥中重金属的浸出具有重要影响,污泥中的Zn、Cu、Ni最大浸出浓度在8h时,而Fe和Mn随着浸提时间增加而增加;浸提时间对污泥中重金属浸出量的影响因该重金属的化学性质不同而存在较明显的差别,这可能与浸提过程中的吸附-解吸过程、络合-解离过程和溶解-沉淀/共沉淀等因素有关.     

Extended activated sludge model no. 1 (ASM1) for simulating biodegradation process using bacterial technology

Phosphorus is one of the most important nutrients required to support various kinds of biodegradation processes. As this particular nutrient is not included in the activated sludge model no. 1 (ASM1), this study extended this model in order to determine the fate of phosphorus during the biodegradation processes. When some of the kinetics parameters are modified using observed data from the restoration project of the Xuxi River in Wuxi City, China, from August 25 to 31 in 2009, the extended model shows excellent results. In order to obtain optimum values of coefficients of nitrogen and phosphorus, the mass fraction method was used to ensure that the final results were reasonable and practically relevant. The temporal distribution of the data calculated with the extended ASM1 approximates that of the observed data.     

Performance of Sewage Sludge Treatment and Electricity Generation by Different Configuration Microbial Fuel Cells

This paper compared the degradation efficiency of sludge organic matters and electric-production by two typical microbial fuel cells——dual-chamber microbial fuel cell(DMFC)and single chamber air cathode microbial fuel cell(SAMFC),and the variations of sludge protein,polysaccharide and ammonia nitrogen within the systems were also investigated.The results showed that the concentration of sludge soluble chemical oxygen demand,protein and carbohydrate of DMFC are higher than these of SAMFC during the systems operation,while DMFC can achieve a better ammonia nitrogen removal than SAMFC.Under the same operation condition,the stable voltage output of DMFC and SAMFC is 0.61 V and 0.37 V;the maximum power density of DMFC and SAMFC is 2.79 W/m3and 1.25 W/m3;TCOD removal efficiency of DMFC and SAMFC is 34.14%and 28.63%for 12 d,respectively.Meanwhile,DMFC has a higher coulomb efficiency than SAMFC,but both are less than5%.The results showed that DMFC present a better performance on sludge degradation and electric-production.     

Recycle of valuable products from oily cold rolling mill sludge

Oily cold rolling mill （CRM） sludge contains lots of iron and alloying elements along with plenty of hazardous organic components, which makes it as an attractive secondary source and an environmental contaminant at the same time. The compound methods of ＂vacuum distillation ＋ oxidizing roasting＂ and ＂vacuum distillation ＋ hydrogen reduction＂ were employed for the recycle of oily cold rolling mill sludge. First, the sludge was dynamically vacuum distilled in a rotating furnace at 50 r/rain and 600℃ for 3 h, which removed almost hazardous organic components, obtaining 89.2wt% ferrous resultant. Then, high purity ferric oxide powders （99.2wt%） and reduced iron powders （98.9wt%） were obtained when the distillation residues were oxidized and reduced, respectively. The distillation oil can be used for fuel or chemical feedstock, and the distillation gases can be collected and reused as a fuel.     

基于微观力学分析的散粒体静力液化本构模型

针对散粒体的静力液化特性,在散粒体颗粒运动微观力学分析的基础上,在临界状态土力学框架内建立了一个简单的静力液化弹塑性本构模型.模型屈服函数和和硬化规律根据Chang提出的砂土微观力学模型,通过积分粒间接触力为宏观的应力不变量而建立,考虑了与材料状态相关的剪胀性和初始密度对散粒体应力-应变关系的影响,并采用非相关联的流动法则.模型参数简单且有较明确物理意义,可以通过室内三轴试验确定.模型的数值结果与Toyoura砂以及砂-粉混合土的三轴不排水剪切试验的应力-应变曲线和应力路径吻合较好.     

基于城市污水好氧颗粒污泥脱氮除磷系统种群多样性研究

采用16S rDNA克隆文库方法对城市污水脱氮除磷好氧颗粒污泥的细菌种群进行了多样性研究.从16SrDNA克隆文库中随机挑选110个克隆子测序并进行了BLAST比对.结果表明:好氧颗粒污泥序批式反应器(GSBR)系统中细菌群落具有高度多样性,包含14个类群,优势细菌类群为Proteobacteria类群(变形菌类群),占85.18%;细菌类群优势顺序为β-Proteobacteria、α-Proteobacteria、γ-Proteobacteria、uncultured Bacteroidetes、Candidatedivision TM7、δ-proteobacterium、Firmicutes、Planctomycetacia、Actinobacteria、Sphingobacteria、Flavobacteria、Cytophagia、Uncultured bacterium和Uncultured anaerobic bacterium.初步分析了不同细菌类群在脱氮除磷系统中的作用,其中,Proteobacteria纲中部分为聚磷菌,Acidovorax sp.、Planctomycetacia、Cytophagia、Flavobacteria对氮的脱除均有一定作用.     

污泥资源化关键装置的构造设计

为解决城市生活污水处理后的副产品污泥的二次污染问题,提出将有害的污泥变成有用资源的机械设计模型。基于污泥脱水后与煤粉颗粒混合、成型形成可燃烧燃料的功能规划,在研究分析机构混合送进腔型和湿固体颗粒体物料受力运动之间的相互牵连关系的基础上,以进出物料总量的平衡和湿固体颗粒体物料在机构中充分混合的运动特性为理论依据,建立了以曲线外壁、变螺距螺旋叶片腔型的结构模型,经试验验证,获得污泥资源化关键装置结构模型的参数与约束关系,由此为自主研制开发新型高效的现代污水处理装置的关键设备提供理论基础。