Granular gases in mechanical engineering: on the origin of heterogeneous ultrasonic shot peening

The behavior of an ultrasonic shot peening process is observed and analyzed by using a model of inelastic hard spheres in a gravitational field that are fluidized by a vibrating bottom wall (sonotrode) in a cylindrical chamber. A marked heterogeneous distribution of impacts appears when the collision between the shot and the side wall becomes inelastic with constant dissipation. This effect is one order of magnitude larger than the simple heterogeneity arising from boundary collision on the cylinder. Variable restitution coefficients bring the simulation closer to the general observation and allow the investigation of peening regimes with changing shot density. We compute within this model other physical quantities (impact velocities, impact angle, temperature and density profile) that are influenced by the number N of spheres.     

油田采出水的高温水解-好氧处理工艺研究

根据油田采出水的水质特征，采用厌氧(水解)-好氧(接触氧化)处理工艺。实验表明，虽然油田采出水的BOD5／CODCr，较低，属于难生物降解废水，但是当温度为50～60℃时，选择厌氧停留时间为6h，好氧停留时间为3．5h，气水比为10～20，可使其出水的CODCr稳定在120mg／L左右。如果排除Cl^-产生的影响，CODCr，约为60～70mg／L，达到GB8978-1996一级排放标准。     

Municipal solid waste conversion to energy

In recent years it has been recognised by an increasing number of nations that there is considerable energy potential within MSW. As a result many countries have established R,D& D programmes to examine methods of exploiting this potential. The IEA's MSW Conversion Activity was set up in 1986 to provide an infrastructure for sharing information and co-ordinating work in this area internationally. This Activity was extended in 1989 and currently a total of 9 nations participate in it.

To cope with the wide scope of the area (encompassing both biological and thermal processing of MSW) the Activity was divided into three subgroups or Expert Working Groups (EWGs). Each of these dealt with a distinct area of expertise:

1. •Downstream effects of source separation and screening of MSW

2. •Sampling and analytical protocols

3. •Landfill gas

In addition to these groups a central secretariat based at Harwell (UK) has provided guidance, established and administered databases of contacts and produced a series of national reports.

This paper describes the achievements of the Activity and discusses work proposed for the future.     

Physicochemical characteristics and leachability of scale and sludge from Bulalo geothermal system, Philippines

Scale and sludge from Bulalo geothermal field, Philippines, have been characterized by whole rock analysis, radioactivity counting, size analysis, light microscopy, scanning electron microscopy, and X-ray diffraction. Their leachability was assessed by regulatory leaching procedures and by sequential extraction. Both scale and sludge consisted mostly of oxides of Si, Al, and Fe with no radionuclides detected. The scale had 10% S content. Sulfides and silicates were important phases in both samples having size ranges from submicron to 2 mm. Geothermal soils at Bulalo have higher than normal soil levels of As, S, Cu, Cr, Zn, and Pb but regulatory leaching tests indicated that these elements are not released. However, the sequential extraction showed that As, Cu, and Zn were leachable under extreme conditions.     

SBR工艺污泥膨胀的纠正方法

在对国内外有关资料的研究基础上，介绍了几种应对SBR反应池内污泥膨胀的措施。着重叙述了氯化法和无机合成絮凝剂法的应用注意点及如何定量运用这两种方法，同时给出了相应的工程实例。     

二氧化氯处理油田回注水工艺

针对中原油田回注水中细菌易产生抗药性,难以控制的问题,提出了应用二氧化氯处理油田回注水工艺。经室内评价及现场试验,二氧化氯可杀死回注水中的细菌,控制微生物生长,同时该工艺可降低现有回注水污泥残渣产出量的50%,减少污泥对环境的污染,提高注水水质。     

(Fe_(0.86)Zr_(0.033)Nb_(0.033)B_(0.068)Cu_(0.01))_x(Al_2O_3)_(1-x)颗粒膜的霍耳效应

用磁控溅射方法制备了系列 (Fe0 .86 Zr0 .0 33Nb0 .0 33B0 .0 6 8Cu0 .0 1 ) x(Al2 O3) 1 -x颗粒膜样品 ,体积百分比x从 0 .3 3～ 0 .63 ,样品厚度约为10 0nm。室温下在Fe0 .86 Zr0 .0 33Nb0 .0 33B0 .0 6 8Cu0 .0 1 体积百分比x =0 .43时得到 17.5 μΩ·cm的最大饱和霍耳电阻率 ,比纯铁磁金属提高了 3～ 4个量级。对其磁性和微结构进行了研究 ,样品霍耳电阻率随外场的变化曲线 ρxy～H与磁场平行于膜面时的磁化曲线M～H有相似性 ,说明霍尔电阻率 ρxy与磁化强度M相关。样品电阻率 ρxx随金属体积百分比x的减小而增加 ,在x =0 .43附近发生突变 ,从金属导电变为绝缘体。根据微结构和输运性质对可能的机制进行了探讨     

DRYING OF GRANULAR PARTICLES IN A MULTISTAGE INCLINED FLUIDIZED BED WITH MECHANICAL VIBRATION

A mathematical model for the drying rate of granular particles in a multistage inclined fluidized bed(IFB) is presented from the standpoint of simultaneous heat and mass transfer, with taking the effect of mechanical vibration added vertically into consideration.

Steady-state distributions for the temperatures and concentrations of the particles and the heating gas, and for the moisture content of the particles are numerically calculated based on the present model. The calculated results show fairly good agreement with the experimental data, which were obtained from the drying experiments of brick particles in a three-stage IFB using comparatively low temperature air(40-60°C) as the heating gas.

It has been found within the range of the experimental conditions employed that, the mechanical vibration added vertically enhances the over-all drying rate of the particles and its effect can be considered equivalent to an increase in the air velocity.     

含油污泥焦化处理实验研究

采用焦化方法对含油污泥进行处理。经过筛选选取活性白土作为焦化处理催化剂,分别研究了反应时间、反应温度、氮气吹扫量、加热速率等因素对处理效果的影响。4个影响因素对液相油品收率的影响顺序为:氮气吹扫量>反应温度>反应时间>加热速率;对反应转化率的影响顺序为:反应温度>反应时间>氮气吹扫量>加热速率。较为理想的反应参数:反应温度490℃;反应时间60min;氮气吹扫量90mL.min-1;加热速率4℃.min-1。在此反应条件下,含油污泥液相油品收率>80%,反应转化率>99.9%,经焦化处理后的废渣含油率<3‰,达到农用污泥排放标准,实现了达标排放和回收资源的目的。     

厌氧胶快速渗补技术在汽车发动机上的应用

将金属铜易与过氧化物发生氧化还原反应生成游离基的原理应用于厌氧胶，开发了针时金属零件表面微孔进行局部渗补的实用技术。在相关技术可靠性和工艺可行性得以论证的前提下。将局部渗补技术成功地应用于渗补发动机泄漏缸盖，减少了废品损失，取得了良好的经济效益。