设计阶段的工程造价控制管理

从设计招标和方案竞选、设计方案的优化、标准化设计、限额设计、技术培训等方面分析了设计阶段造价控制和管理的特点，指出只有把控制造价的关键阶段确立在设计阶段，才能实现工期短、节约成本、效益显著的目标。     

Taxometrics in Psychopathology Research: An Introduction to Some of the Procedures and Related Methodological Issues.

This article introduces a special section on the use of taxometrics to examine the categorical versus the dimensional structure of various forms of psychopathology. Paving the way into the special section, this introduction briefly describes 3 taxometric methods--mean above minus below a sliding cut (MAMBAC), maximum covariation (MAXCOV), and maximum eigenvalue (MAXEIG)--and discusses possible threats to statistical conclusion validity that often emerge when such techniques are applied in psychopathology research. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

电视新闻拍摄也需要美感

分析电视新闻拍摄美感的重要性和必要性,提出在实地拍摄过程中如何体现电视新闻的美感。     

火炮身管内表面激光硬化处理的实验研究

提高身管寿命是火炮行业亟待解决的关键技术问题，激光表面改性技术是解决这一问题的有效方法之一。本文在分析激光表面相变硬化性能的基础上，对身管内表面进行了激光硬化处理实验研究，检测了其内表面阳线和阴线的硬化层硬度和深度，对比分析了离焦量和焦深对其内表面硬化层硬度的影响，并对激光相变硬化层金相组织进行了分析。经激光硬化处理后，身管的内表面硬度有明显提高，硬化层较深，且为很细的条状马氏体组织。     

IEEE 802.11g性能分析及应用

全面介绍IEEE802.11g标准的无线局域网,详细讲述IEEE802.11g草案标准的概念、产生背景、特点、构件及其体系结构和发展前景,探讨实现IEEE802.11gWLAN所需的关键技术及其双频多模应用方式,同时分析IEEE802.11g标准的网络性能。     

In-tube condensation of mixture of R134a and ester oil: empirical correlations

This paper presents a comparative study of the condensation heat transfer coefficients in a smooth tube when operating with pure refrigerant R134a and its mixture with lubricant Castrol “icematic sw”. The lubricant is synthetic polyol ester based oil commonly used in lubricating the compressors. Two concentrations of R134a-oil mixtures of 2% and 5% oil (by mass) were analysed for a range of saturation temperatures of refrigerant R134a between 35 °C and 45 °C. The mass flow rate of the refrigerant and the mixtures was carefully maintained at 1 g/s, with a vapour quality varying between 1.0 and 0. The effects of vapour quality, flow rate, saturation temperature and temperature difference between saturation and tube wall on the heat transfer coefficient are investigated by analysing the experimental data. The experimental results were then compared with predictions from earlier models [Int J Heat Mass Transfer (1979), 185; 6th Int Heat Transfer Congress 3 (1974) 309; Int J Refrig 18 (1995) 524; Trans ASME 120 (1998) 193]. Finally two new empirical models were developed to predict the two-phase condensation heat transfer coefficient for pure refrigerant R134a and a mixture of refrigerant R134a with Castrol “icematic sw”.     

气压传动与控制在电子专用设备上的应用

气压传动与控制已成为电子专用设备研制过程中一项不可缺少的内容 ,必须进行合理的气动系统设计及其控制 ,选择相应的气动元件以满足设备的功能要求。概述了气压传动与控制在电子专用设备上的应用。     

联产供冷与电力供冷能耗比较分析

文中将两种供冷能耗比较分解成用电煤耗差、用热煤耗量、增加产汽用电煤耗量三部分进行分析，按照热量法得出在目前一般情况下联产供冷比电力供冷通常费能和定性定量结论，为全面研究比较热电冷联产与分产的能耗奠定一个基础。     

浅谈综合布线系统接地设计

综合布线系统作为建筑智能化不可缺少的基础设施,其接地系统的好坏将直接影响到综合布线系统的运行质量,故而显得尤为重要。本文介绍了综合布线系统接地的结构及设计要求,并提出在接地设计中应注意的几个问题。     

回热循环在R134a汽车空调系统中的应用

本文通过试验方法对回热循环在R134a汽车空调系统中的应用进行了试验研究。试验结果表明具有回热器的空调系统其COP和制冷量都能得到一定程度的提高，同时指出，低压侧压降是设计回热器时的一个关键参数，应注意减少低压侧压力损失。