Direct preparation of particles from liquid suspension for ESEM or SEM analysis

A simplified method for the preparation of particles from liquid suspensions has been developed. Particles are deposited directly on carbon planchets for rapid analysis by environmental scanning electron microscopy or by conventional scanning electron microscopy after an additional drying step. This is accomplished by filtering the liquid through thin carbon planchets. Three different grades of graphite were investigated for their suitability as the source material for these planchets. The high quality isomolded graphite is recommended for the filtration and direct observation of particles by electron microscopy. This technique is demonstrated for particles in hydraulic fluid and aquatic suspended particulate material from a natural water source.     

An attempt to compare the performance of bioscrubbers and biotrickling filters for degradation of ethyl acetate in gas streams

This study presents a comparison of the efficiency of a bioscrubber and a biotrickling filter (BTF) for the removal of ethyl acetate (EA) vapour from a waste gas stream, under the same operating conditions. The maximum EA elimination capacity achieved in the bioscrubber was 550 g m^?3 h^?1 with removal efficiency higher than 96%. For higher EA loadings the bioscrubber was oxygen limited, which caused incomplete EA biodegradation. When pure oxygen was fed to the bioscrubber at a rate of 0.02 L min^?1, the bioscrubber recovered and could treat higher EA loadings without any oxygen limitation. The BTF achieved EA elimination capacity of 600 g m^?3 h^?1 with removal efficiency higher than 97% and the dissolved oxygen concentration remained substantially higher than in the bioscrubber. However, severe channelling and blockage of the spray nozzle occurred due to the excessive biomass growth. Overall, the bioscrubber system was easier to operate and control than the BTF, while an enhancement of the oxygen mass transfer in the bioscrubber could potentially increase its performance by up to three times. Copyright © 2005 Society of Chemical Industry     

Comparison of mass transfer efficiency in horizontal rotating packed beds and rotating biological contactors

In this study, the mass transfer efficiencies of a novel horizontal rotating packed (h‐RPB) bed and the conventional disc‐type rotating biological contactor (RBC) were studied at four speeds and seven submergences. Pall rings of two different sizes (25, 38 mm), superintalox saddles and a wiremesh spiral bundle were used as packings in the h‐RPB. Volumetric gas–liquid mass transfer coefficients were determined by unsteady state absorption of atmospheric oxygen in de‐aerated water. Power consumption per unit liquid volume has been found for all geometries tested. The oxygen transfer efficiency values for the h‐RPB were found to be 2–5 kg kWh^?1 and for the disc RBC were found to be 1–2 kg kWh^?1. The performance of the h‐RPB was also compared with other gas–liquid contactors such as surface aerators. The study proves that the h‐RPB is a energy efficient alternative to conventional contactors. Copyright © 2005 Society of Chemical Industry     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry     

对水厂一期滤池技术改造后的经济评价

本文主要从经济角度分析净水厂实际生产情况及经济技术指标等方面的数据。阐述福州西区水厂一期滤池由原先双阀滤池改造成V型滤池的经济性。     

A New Algorithm for the Elimination of Common Subexpressions in Hardware Implementation of Digital Filters by Using Genetic Programming

A new algorithm based on Genetic Programming (GP) for the problem of optimization of Multiple constant Multiplication (MCM) by Common Subexpression Elimination(CSE) is developed. This method is used for hardware optimization for DSP systems. A solution based on Genetic Programming is shown in this paper. The performance of the technique is demonstrated in one- and multi-dimensional digital filters with constant coefficients.     

指状椭圆函数滤波器的研究与设计

阐述了指状椭圆函数滤波器的特点、适用范围，基本理论以及设计方法。用本文导出的公式进行设计有工程应用价值，介绍了一个L波段滤波器的例子。     

一种适用于有限长度混合相位未知脉冲的最小平方反褶积新方法

普通的最小平方反褶积只有在子波为最小相位脉冲和反射序列为白噪声的假设下才是成立的,而对于混合相位未知脉冲来说,这种最小平方反褶积就不再适用了。本文提出一种适合于有限长度混合相位未知脉冲的最小平方反褶积方法。运用此法只需预先估计一个混合相位子波的长度。合成数据的试验结果表明,该方法有较好的效果,且对预先估计出的子波长度不敏感。文中还证明混合相位未知脉冲最小平方反褶积等效于一种有间隙的平滑误差滤波器的作用,而这种有间隙的平滑误差滤波又可分解为一个前向多步预测误差滤波与一个后向多步预测误差滤波之和。可以预计这种新的反滤积方法将在地震数据处理中得到有效的应用。     

DO浓度对SUFR系统同步硝化反硝化的影响

采用螺旋升流式反应器（SUFR）处理生活污水，考察了好氧反应池中DO浓度对其同步硝化反硝化的影响。结果表明，在好氧反应池上部溶解氧浓度为3．0～3．5mg／L时，发生了明显的同步硝化反硝化现象，其对TN的去除量占SUFR系统对TN去除总量的16％左右；好氧反应池中的同步硝化反硝化反应只发生在池的下部，其中、上部只进行了好氧硝化反应；SUFR系统中好氧反应池上部的最佳溶解氧浓度范围为3．0～3．5mg／L，此时系统的硝化和反硝化效果最佳，好氧反应池中的脱氮效果也较好，系统对TN的去除率〉84％。     

A genetic‐based neuro‐fuzzy controller for blind equalization of time‐varying channels

This paper presents a neuro‐fuzzy network (NFN) where all its parameters can be tuned simultaneously using genetic algorithms (GAs). The approach combines the merits of fuzzy logic theory, neural networks and GAs. The proposed NFN does not require a priori knowledge about the system and eliminates the need for complicated design steps such as manual tuning of input–output membership functions, and selection of fuzzy rule base. Although, only conventional GAs have been used, convergence results are very encouraging. A well‐known numerical example derived from literature is used to evaluate and compare the performance of the network with other equalizing approaches. Simulation results show that the proposed neuro‐fuzzy controller, all parameters of which have been tuned simultaneously using GAs, offers advantages over existing equalizers and has improved performance. From the perspective of application and implementation, this paper is very interesting as it provides a new method for performing blind equalization. The main contribution of this paper is the use of learning algorithms to train a feed‐forward neural network for M‐ary QAM and PSK signals. This paper also provides a platform for researchers of the area for further development. Copyright © 2008 John Wiley & Sons, Ltd.