汽轮机回热系统给水焓升的最优分配

从汽轮机回热系统的实际情况出发，运用非线性规划理论和计算机技术，解决了给水焓升设计中的最优分配问题。结合具体实例，针对国产200MW汽轮机回热系统给水焓升的分配进行了说明。     

钼精矿结球机理及对策研究

钼精矿产品质量的提高、粒度变细,干燥过程中结球现象严重。在氧化钼的焙烧过程中MoS2残留量较高。本文针对这一现象,分析了其结球机理,提出了相应对策及解决办法。     

Detection and analysis of transition from annular to intermittent flow in vertical tubes

In vertical co-current gas-liquid flow, the transition from annular to intermittent flow occurs when gas core becomes interrupted by liquid bridges due to the instability of the interfacial capillary waves. An analytical model is formulated to explain the liquid bridging in terms of the growth of finite amplitude interfacial capillary waves. Experimental results show that the longest wave length, which is associated with the transition, is about eight times the wave length of waves moving with the velocity of the liquid film.     

Assessment of Capillary Rise from Shallow Groundwater by the Simulation Model SIMWASER Using Either Estimated Pedotransfer Functions or Measured Hydraulic Parameters

The performance of the water balance and crop growth model SIMWASER to estimate the water supply of a lawn by capillary rise from shallow ground water was investigated by using lysimeter measurements with a sandy and a clayey soil. Moreover the robustness of the model was evaluated by running it either with measured hydraulic soil parameters or with estimated pedotransfer functions (PTFs) derived from texture and bulk density. Simulations were performed for the years 1996–1998 with input data from the lysimeter station Berlin-Dahlem (Germany) for lysimeters containing undisturbed sandy or clayey soil monoliths, with groundwater at 135 cm depth. Simulated evapotranspiration and percolation/capillary rise were in good agreement with the measured data for all variants, while simulated soil water storage was acceptable only for the variants using hydraulic soil data based on laboratory measurements or using PTFs derived from known soil class and bulk density. PTFs based on mean total pore volume of the respective soil classes yielded soil water storages which were evidently too high; therefore they should be used with care and must be avoided at all in simulating the soil water balance of arid sites with shallow groundwater.     

毛细管微反应器中乙烯环氧化反应

在石英毛细管中涂覆α-Al2O3并负载银,制成微反应器,利用毛细管微反应器进行了乙烯环氧化反应的实验。考察了反应温度、乙烯含量、气态空速等因素对乙烯环氧化反应的影响。实验结果表明,在毛细管微反应器中可进行乙烯环氧化反应,在常压、不添加任何助催化剂和抑制剂的条件下,反应温度为230℃时,乙烯的转化率为69.54%,环氧乙烷的选择性和收率分别为82.00%和57.02%;毛细管微反应器的气态空速可达到5600h-1,超过工业装置的水平,缩短了反应时间,减小了深度氧化的几率。     

制冷剂充灌量和毛细管长度对空调系统性能的影响

在空调器的匹配中，制冷剂充灌量和毛细管长度是两个非常关键的因素。本文采用理论与数值计算的方法，对制冷剂充灌量和毛细管长度对空调系统性能的影响进行了分析，为空调器的优化设计匹配、提高空调器的性能奠定了基础。     

台式毛细管放电X光激光装置调试实验

对自行研制的台式毛细管放电X光激光装置进行了系统调试,在充氩气毛细管负载下,输出电流38kA,电流脉冲前沿40ns,并对有关问题进行了讨论.并在这个装置上开展充氩气毛细管放电荧光光谱实验研究.     

On using peak amplitude and rise time for AE source characterization

Acoustic Emission (AE) signals, which are electrical version of acoustic emissions, are usually analysed using a set of signal parameters. The major objective of signal analysis is to study the characteristics of the sources of emissions. Peak amplitude(P _a ) and rise time(R _t ) are two such parameters used for source characterization. In this paper, we theoretically investigate the efficiency ofP _a andR _t to classify and characterize AE sources by modelling the input stress pulse and transducer. Analytical expressions obtained forP _a andR _t clearly indicate their use and efficiency for source characterization. It is believed that these results may be of use to investigators in areas like control systems and signal processing also     

Mathematical analysis of viscometric (polymer) flow fields in capillaries: Taylor dispersion revisited

A general formulation for capillary flow of two miscible fluids – one a dilute plug of polymer fluid inserted into a fully developed Poiseuille flow of the other, a Newtonian stream – is examined for its long time behavior. Phenomenologically, the system evolves from an initial state, that of a plug within the boundaries of sharp, well defined fronts inside a Newtonian stream, to a more homogenized state in the very long time scale. This problem was addressed by G.I. Taylor but with regard to a system of two Newtonian fluids, leading to the well-known results commonly described as `Taylor axial dispersion'. In this paper, a general and systematic perturbation analysis is presented from which Taylor's result is recovered as a special case of a more general solution which applies to fluids incorporating elastic properties. In particular, the influence of viscoelasticity and (polymer) diffusivity on the observed pressure profile in the capillary conduit is examined. This effect is clearly separated out for small Peclet number flows using asymptotic and numerical analysis. The results identify the influence of fluid viscosity, elasticity, and diffusivity on the observed pressure profile and form the basis for the improved characterization of polymeric elasticity using capillaries – a finding that is of significant scientific and commercial interest. These results were obtained by the authors as a class of observations resulting from the perturbation analysis of forced-flow capillary devices in viscoelastic fluid property investigation.     

关于离子注入中温升的探讨

本文在理论和试验两个方面探讨了离子注入中的热效应和温升现象。注入样品的温升对离子注入层的性能有直接影响。分析了理论计算注入样品温升的一些情况。给出了实际测量注入样品温升的几种试验方法。阐明了控制注入样品温升的若干可能途径。