Water absorption properties of phosphate glass fiber‐reinforced poly‐ϵ‐caprolactone composites for craniofacial bone repair

The moisture uptake of polymers and composites has increasing significance where these materials are specified for invasive, long‐term medical applications. Here we analyze mass gain and the ensuing degradation mechanisms in phosphate glass fiber reinforced poly‐?‐caprolactone laminates. Specimens were manufactured using in situ polymerization of ?‐caprolactone around a bed of phosphate glass fibers. The latter were sized with 3‐aminopropyltriethoxysilane to control the rate of modulus degradation. Fiber content was the main variable in the study, and it was found that the moisture diffusion coefficient increased significantly with increasing fiber volume fraction. Diffusion, plasticization, and leaching of constituents appear to be the dominant aspects of the process over these short‐term tests. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2008     

基于基尼系数的Web社区稳定性度量

Web社区是互联网中自组织程度较高的部分,它不是一个孤立系统,而是一个耗散系统,很多时候涨落无法耗散摔,导致社区运行不稳定.基尼系数可以用来衡量Web社区稳定性,通过基尼系数的简易计算公式计算社区内部成员积分或者其它参数,可以得出Web社区稳定性的度量.该度量对于研究和利用Web社区具有重要参考意义.     

Analysis of low load transients for the Vandellòs-II NPP: Application to operation and control support

The Technical University of Catalonia (UPC) has been jointly working with the Asociación Nuclear Ascó-Vandellòs (ANAV) for a number of years in order to establish, qualify and use best estimate (BE) models for the reactors under the control of ANAV. ANAV is the consortium that is responsible for operation of the Ascó and Vandellòs-II reactors. The reactors are Westinghouse-design three-loop PWRs with an approximate electrical power of 1000 MW. The existing integral plant models for each plant are currently used for many different purposes among which are support of plant operation and control. Quite a number of studies have been done in order to improve both safety and plant competitiveness. Most of these dynamic analyses were carried out in relation to transients starting at nominal full power or at least, very close to full power. This paper develops a specific use of the Vandellòs-II plant model for operation and control support at low power involving new ranges of system actuation parameters. It also examines scenarios that are somewhat different from those typically analysed. The study starts showing the results of an assessment case, which is a start-up test and provides some additional qualification, and subsequently attempts to establish calculations to support both an improvement in feed water controls and to set up operating recommendations for low-load manual operation of feed water turbo-pump. Both results hopefully, will produce an outcome, which leads to an improvement in safety and reduces reactor trip probability.     

Use of chemical variation and predation as plant defenses byEncelia farinosa against a specialist herbivore

Larvae of the monophagous herbivore,Trirhabda geminata, selectively eat particular plants and plant parts of its natural host,Encelia farinosa. Measurements of leaf damage and larval positions on branches through time support this observation. Time-lapse movie photography revealed that larvae are sufficiently mobile to search most of a plant in a 48-hr period and that aggregations were the result of larval activity and not directly the result of oviposition. Experiments withT. geminata larvae on artificial diets containing a range of natural concentrations of chemical extracts fromE. farinosa leaves showed that the larvae grew significantly slower and had a lower overall survivorship at the high concentration. Combining the results of all choice tests, larvae appeared unable to distinguish between high- and low-concentration agar diets. Considered individually, larval preferences for natural production concentrations changed as the season progressed. Early-season larvae preferred low-concentration leaves, while late-season larvae preferred high-concentrations. Measurements of chemical and nitrogen content of leaves selected by larvae in the field confirmed this pattern. Percent parasitism in field-collected larvae increased with season as the larval population decreased. This combination of slowed growth and increasing parasitism and predation is a putative defense strategy ofEncelia farinosa to prevent adaptation by a specialist herbivore to the total range of compounds elaborated.     

Drying of Chestnuts (Castanea sativa Mill.) after Osmotic Dehydration with Sucrose and Glucose Solutions

Chestnuts were dehydrated by using a combined method of osmotic dehydration followed by air drying. Samples were osmotically pretreated with sucrose (60% w/w) and glucose (56% w/w) for 8 h, air-dried at temperatures of 45, 55, and 65°C, at a relative humidity of 30% and at a velocity of 2.7 m·s^-1 and the experimental data of the drying kinetics were obtained. Whole samples were dried with different peelings: (a) removal of endocarp and pericarp (peeled) and (b) additionally the internal rough surface (cut). In all cases, cut chestnuts show greater drying rates than peeled samples, indicating that a significant mass transfer resistance in the layer nearest to the surface takes place. Peeled samples pretreated with sucrose solutions behave in a similar way to untreated samples. For the rest of the samples, the cut samples osmotically treated with sucrose solutions and all the samples treated with the glucose solution, the drying rates decrease during drying. Drying kinetics are successfully modeled by employing a diffusional model that takes the shrinkage into account. The effective coefficient of water diffusion was evaluated and correlated with temperature. The quality of the final product was monitored by color change. In spite of the fact that the total color difference is not modified by the osmotic treatment, the L*, a*, and b* color coordinates of cut samples treated with sucrose and glucose solutions do undergo changes; the L* and a* coordinates change less than the b*.     

生烧石灰对氧化铝生产过程的影响及石灰炉热工现状分析

由于反苛化作用，生烧石灰对氧化铝生产的循环效率、溶出和蒸发工序有很大的影响。本文对石灰生烧的热工现状进行了热平衡验算，从热工的角度分析了石灰烧制中存在的缺陷，通过热工计算，提出了改善石灰烧制质量的建议，以消除其在生产过程的危害及实现增效的目的。     

Heat loss and thermoelectric generator design

With the object of evaluating its importance to thermoelectric generator design, heat loss is introduced into the standard thermoelectric generator design theory. The theory for both the constant hot and cold junction temperatures model and the constant heat input model are so modified. The modification is first order and, therefore, is limited to small leg heat-transfer coefficients. Numerical results using representative properties show that significant differences can exist between the optimum geometry and performance of a generator idealized as lossless and those of a generator designed by the modified theory. The largest differences occur with the constant heat input model.     

工业配料中的自控

本文介绍了微机在工业配料过程中的应用情况，对上料-计量-下料的全过程即“动态运行-静态计量-动态运行”进行控制．     

Convex relaxation for a 3D spatiotemporal segmentation model using the primal-dual method

A method based on 3D videos is proposed for multi-target segmentation and tracking with a moving viewing system. A spatiotemporal energy functional is built up to perform motion segmentation and estimation simultaneously. To overcome the limitation of the local minimum problem with the level set method, a convex relaxation method is applied to the 3D spatiotemporal segmentation model. The relaxed convex model is independent of the initial condition. A primal-dual algorithm is used to improve computational efficiency. Several indoor experiments show the validity of the proposed method.