Response level crossing rate of a linear system excited by a partially specified Gaussian load process

The problem of determining the maximum mean response level crossing rate of a linear system driven by a partially specified Gaussian load process has been considered. The partial specification of the load is given only in terms of its total average energy. The critical input power spectral (PSD) function, which maximizes the mean response level crossing rate, is obtained. The critical input PSD turns out to be highly narrow-banded which fails to capture the erratic nature of the excitation. Consequently, the trade-off curve between the maximum mean response level crossing rate and the maximum disorder in the input process, quantified in terms of its entropy rate, has been generated. The method of Pareto optimization is used to tackle the conflicting objectives of the simultaneous maximization of the mean response level crossing rate and the input entropy rate. The non-linear multi-objective optimization has been carried out using a recently developed multi-criteria genetic algorithm scheme. Illustrative example of determining the critical input of an axially vibrating rod, excited by a partially specified stationary Gaussian load process, has been considered.     

智能磁流变(RM)阻尼器的实验研究

磁流变 (MR)液是一种新型的智能材料 ,而MR阻尼器具有在外加电流作用下快速可逆地改变阻尼特性的特点。本文针对所作的MR阻尼器实验研究 ,介绍了实验过程及相关数据 ,并对其进行了分析。实验表明 :MR阻尼器具有良好的阻尼可控制特性 ,是结构消能减振控制的理想元件。     

《周培德三角剖分不是最小权三角剖分》一文商榷——反例不成立

周培协三角剖分是否能得到最小权三角剖分，周培德在《周培德三角部分不是最小权三角剖分》一文撰写之前已有新的结论，本文还指出《周培德三角剖分不是最小权三角剖分》一文所举反例不成立。     

中国先进研究堆导流箱流场的数值模拟

采用目前国内普遍使用的计算流体力学 (CFD)软件PHOENICS 3 2对中国先进研究堆不同结构的导流箱的三维流场进行数值模拟计算。结果表明 :导流箱入口导流板和导流筒能显著改善导流箱入口冷却剂的流动状况 ,获得入口冷却剂沿周向均匀分流的效果 ,达到显著减缓入口冷却剂对垂直辐照孔道导管及安全棒导管直接的横向水力冲刷的设计目的     

国外钻井液和完井液用聚合物

９０年代以来，国外钻井液和完井液用聚合物添加剂的发展取得长足进步。本文介绍了国外目前用于钻井液和完井液的聚合物添加剂的类型及作用。     

预测井眼稳定性的力学化学耦合方法

在井眼力学稳定性评价的基础上，将硬脆性页岩水化后岩石强度等参数的变化规律用于页岩水化前后坍塌压力变化的对比分析，结果表明，地层坍塌压力当量密度随页岩水化程度的增加逐渐升高。给出了预测井眼稳定性的力学化学耦合方法，并将该方法应用于现场生产中，取得了较好的预测效果     

Experimental densities for compressed R134a

This paper reports densities of compressed R134a (1,1,1,2-tetrafluoroethane) determined by using a contiuously weighed pycnometer at 20 K intervals between 180 and 380 K at pressures from slightly greater than the vapour pressure to 70 MPa. The results are accurate to within ±0.1%. Saturated liquid densities derived by extrapolation from the experimental values agree with other reported values to within ±0.3%.     

Dynamics of Solidification in 2% Corn Starch-Water Mixtures: Effect of Variations in Freezing Rate on Product Homogeneity

Directional solidification studies of gelatinized corn starch-water mixtures were undertaken in order to examine, in situ, the freezing behavior of this food model. The solidification rate was controlled by varying sample cell velocity as it moved from a 25°C hot stage to a -25°C cold stage. While freezing at cell velocities ≤7.5 μm/sec, starch granules were alternately pushed or entrapped by the advancing solid-liquid interface producing a segregated structure consisting of alternating high-starch and low-starch bands. At a cell velocity of 10 μm/sec, the frozen product was homogeneous. The relationship between the solid-liquid interface velocity and segregation behavior was quantified and compared to an existing model of particle-interface interactions.     

基于Patel-Teja状态方程的统一粘度模型(Ⅱ)应用于油气藏流体粘度的预测

基于(I)报根据pVT和Tμp图形的相似性和Patel-Teja状态方程建立的预测纯流体气、液相粘度的统一模型,通过引入常规的状态方程参数的混合规则,将其应用于二元轻烃混合物共计1894个数据点及模拟天然气高压粘度的预测,平均相对误差分别为13.78%和16.75%;应用于油藏原油和天然气高压粘度的预测,结果优于现有的有关油气藏流体粘度模型.     

有机盐聚合醇氯化钾钻井液的应用

霍尔果斯背斜构造极其复杂,内应力极高,地层倾角大,断层、破碎带多,并存在高低压互层;安集海河组的灰绿色软泥岩水化严重并具有粘弹塑性.该区块重点探井霍003井三开、四开井段选用有机盐聚合醇氯化钾钻井液,同时为保证钻井液在高密度下（2.55 g/cm^3）具有好的流变性,使用活化铁矿粉、活化重晶石加重.应用结果表明,由于采用了强抑制和多元封堵的措施,该钻井液具有良好的流变性和较强的携带能力,钻进中曾携带出重2.8 kg和5.1kg的大掉块;滤失量低,泥饼质量好,封堵能力强,造壁能力强,减轻了井下阻卡程度;有良好的储层保护能力;在室内研究的基础上,经过现场合理使用和维护钻井液,霍003井提高了机械钻速,缩短了钻井周期,井身质量优于邻井.指出在高密度下,未选出适合有机盐聚合醇氯化钾钻井液的稀释剂,钻井液流动性较差.