实炉底节能连续式加热炉

轧钢生产使用实炉底连续式加热炉加热钢坯，炉内双纵滑管用耐热耐高温材料，无水冷，起到节约水、电的作用，达到节能增效的目的。     

连轧管“竹节”问题的研究

本文就各工艺参数对“竹节”的影响进行了较系统的试验。在此基础上，对连轧管“竹节”问题进行了分析，得出了“竹节”形态的基本特征；后“竹节”与轧制压力的关系；影响后“竹节”的主要工艺因素等一系列有意义的结果。对前、后“竹节”形态明显不同的原因进行了初步探讨。提出了“竹节”在线控制模型的初步设想。     

连续重整装置仿真系统的设计开发

为提高操作人员对连续重整装置开停工及事故处理的熟练程度，并对生产进行指导，采用半机理模型结合设计和现场数据介发的连续重整装置仿真系统已在现场成功投用。介绍了该仿真系统的软硬件结构、动态模型及仿真功能。     

金属清净剂的性能研究

为了改进金属清净剂的抗氧性和极压抗磨性能，用一种含硫磷的羧酸衍生物部分中和清净剂中过碱性组分，得到两种改进的金属清净剂，并用四球机和热重分析仪评价其极压抗磨和抗氧化性能。结果表明功能化处理提高了金属清净剂抗氧化和极压性能，但未对分散和抗磨性能产生显著影响。     

Recrystallization/precipitation behaviour in microalloyed steels

Microalloyed high-strength low-alloy (HSLA) steels contain additions of Nb, V, Ti, or in combination, in amounts of 0.01 to 0.1 weight percent to improve mechanical properties, which are strongly dependent on the thermomechanical interaction taking place in the course of rolling mill processes. The recrystallizatian of hat-twisted austenite has been investigated in a cylindrical specimen (f 6×50 mm) machined from hat rolled plates of 0,052 wt % Niobium microalloyed steel. Continuous and interrupted torsion test were carried out in the temperature range 1123 K to 1173 K after a solution treatment of 1.5 minutes at 1423 K and torque-twist data were analysed. The various methods were discussed for obtaining results from torsion tests. The effect of precipitation kinetics was appreciated by way of connection t_p/t_p(red), where t_p is the experimental measured time for the peak stress and t_p(red) is the newly defined reduced time. The softening ratio X and time t_0.05R for start of static recrystallization were established.

The correlation between precipitation and recrystallization is presented as a graphs for chosen requirements (temperature of austenitization, carbon and niobium content and strain rate). If temperature goes below 850°C, the restoration processes are hardly suppressed, both are limited by diffusion and Nb(CN) precipitation, which are extended dynamically in the range of strains rates 10⁻² to 1 s⁻¹.

In the present paper, an attempt is made to derive the PRTT diagram and to define all mathematical equations for describing recrystallization times t_0.05R, t_0.5R, t_0.95R and t_0.05P for the start of precipitation. In real metal forming processes such as the hot rolling of plates or strips the knowledge of these parameters and results is extremely important for the the correct microstructure and sheet quality to be obtained.     

连续驱动摩擦焊动态扭矩检测的新方法—VCMM法

连续驱动摩擦焊动态扭矩检测的新方法──ＶＣＭＭ法刘金合，罗键连续驱动摩擦焊扭矩是一个重要的工艺参数。摩擦焊扭矩是动态扭矩，具有时变性、速变性以及变化范围大等特点。现有的检测摩擦焊扭矩的方法均有一定的局限性’‘－’‘，本文提出了通过驱动主电机定子电压和...     

Lake-Level Change and Water Balance Analysis at Lake Qinghai,West China during Recent Decades

Lake Qinghai, the largest saline lake with an area of 4,260 km² (2000) and average depth of 21 m (1985) in West China, has experienced severe decline in water level in recent decades. This study aimed to investigate water balance of the lake and identify the causes for the decline in lake level. There was a 3.35-m decline in water level with an average decreasing rate of 8.0 cm year⁻¹ between 1959 and 2000. The lake water balance showed that mean annual precipitation between 1959 and 2000 over the lake was 357 ± 10 mm, evaporation was 924 ± 10 mm, surface runoff water inflow was 348 ± 21 mm, groundwater inflow was 138 mm ± 9 and the change in lake level was −80 ± 31 mm. The variation of lake level was highly positively correlated to surface runoff and precipitation and negatively to evaporation, the correlation coefficients were 0.89, 0.81 and −0.66, respectively. Water consumption by human activities accounts for 1% of the evaporation loss of the lake, implying that water consumption by human activities has little effect on lake level decline. Most dramatic decline in lake level occurred in the warm and dry years, and moderate decline in the cold and dry years, and relatively slight decline in the warm and wet years, therefore, the trend of cold/warm and dry climate in recent decades may be the main reasons for the decline in lake level.     

奥钢联板坯连铸计算机系统升级研究

某钢厂板坯连铸过程控制系统采用的奥钢联(VAI)技术,运行数年来,由于模型不透明,维护和调整困难,迫切需要升级改造。改造后的计算机系统充分考虑现有资源和需求,能够达到升级改造的目的。     

连续蒸煮器内洗涤结合器外扩散洗涤的应用

连续蒸煮器内洗涤结合器外扩散洗涤，具有洗涤时间长、洗涤效率高、提取黑液浓度高、浆层厚度均匀、浆层结构组织和浓度一致等特点，运行可靠，易于自动化控制，实现了洗涤用水的封闭循环。     

连续式超临界流体萃取进卸料装置

概括了超临界流体萃取技术和包括连续式操作在内的超临界流体萃取装置的研究现状 ,提出了一种通过球形进、卸料器完成固相物料超临界流体萃取连续化进卸料的装置 ,介绍了该装置的结构和工作原理 ,给出装置中各主要部件的计算方法。