分割电极片状压电致动器——(二)位移特性及狭缝宽度对其影响的实验研究

研究了悬臂梁式分割电极片状压电致动器的位移特性。理论分析表明，分割电极狭缝宽度会减小致动器自由端的位移输出，但当狭缝宽度小于致动器电极宽度的１０％时，可忽略狭缝宽度的影响。致动器端部位移的测试结果大于理论计算值。与现有磁头悬浮臂尺寸相近的致动器，在２０Ｖ～５０Ｖ的电压驱动下均可获得１μｍ～２μｍ的致动位移。对９８５０道／厘米的密度磁盘，该位移能覆盖至少一个磁道宽度，满足磁头定位两级伺服系统对第二级致动器位移的基本要求。     

Copper phthalocyanine as corrosion inhibitor for ASTM A606-4 steel in 16% hydrochloric acid

A study based on the corrosion inhibition properties of copper phthalocyanine is described. Coverage degrees of copper phthalocyanine (Cu-phcy) on ASTM-A606-4 steel, obtained by weight loss measurements, were fitted to Langmuir, Frumkin, Temkin and Flory–Huggins adsorption isotherms. A better fit to the Langmuir isotherm was obtained. The polarization curves showed that polarization of both the anodic and cathodic reactions were verified for concentrations higher than 10^–4 M, indicating a mixed type action. Only the anodic reactions were polarized for lower concentrations. At high frequencies the Nyquist diagrams showed one capacitive loop attributable to double layer charging and a small one at intermediary frequencies attributable to the faradaic process of hydrogen evolution. The formation of an adsorbed film was characterized by increasing charge transfer resistance values in the low frequency range for increasing inhibitor concentrations. According to the techniques used in this study, copper phthalocyanines showed a high corrosion inhibiting efficiency for all concentrations.     

孔径法测量铜带残余应力的试验研究

介绍了用于薄板残余应力测量的新方法——孔径法,该方法是通过测量冲孔直径的变化来间接求出各方向的残余应力;文中详细阐述了残余应力的标定方法;由于可针对不同材料建立了被测材料的平均应力(σ_l)与被测板材宽度(B)、厚度(H)以及冲孔后直径变化率(△D_i/D)之间的数学模型,因而使薄板残余应力测量变得简便而经济;此外还对该方法的分辨率与测量精度进行了实验、计算与分析。     

Gildes model studies of aqueous chemistry. III. Initial SO2-induced atmospheric corrosion of copper

The GILDES computer model, incorporating Stumm's concept of proton- and ligand-promoted dissolution, has been used to simulate the exposure of copper at room temperature to 210 ppb sulfur dioxide and 80% relative humidity. The agreement is good between the calculations and laboratory exposures performed under these exposure conditions. Surface reactions are relatively more important at lower relative humidities and the dominant corrosion products formed are solid state Cu₂SO₃, CuSO₃ and Cu₂U. Free-radical redox processes are important participants and control the relative distribution of Cu(I)- and Cu(H)-containing corrosion products.     

铜蒸汽激光器双闸流管触发系统的研究

研制成用于钢蒸汽激光器的双间流管触发系统。用两个闸流管并联进行交替触发，总输入电功率达7．8kW。低功率运行时，激光器的效率为0．6％与单间流管激光器的效率一致。     

人工接地装置设计方法分析

本文系统地论述了人工接地装置的设计方法,修正了现有文献中有关论述的缺点和错误,提出了通过迭代求解方程组来设计人工接地装置的新方法。     

废电解液除杂制取硫酸铜和粗镍

介绍了废电解液除杂制取硫酸铜和粗镍的主要工艺条件及试验结果。在废电解液中加入CH80调节pH值到一定范围后,再加入CH64将电解液中Fe2+等杂质除去,铁的去除率可达到94%～98%。然后向滤液中加入CH80调节pH值沉淀铜。过滤后的滤饼用H2SO4溶解后再结晶,可得到CuSO4·5H2O晶体。滤液中加入Na2CO3沉淀镍,过滤后的滤饼即为粗镍(NiCO3)。铜和镍的回收率分别达96%和90%。该流程简单,投资少,效益高,环境保护好,在工业上有较广的应用前景。     

A new approach to the mechanism of chlorine evolution: Separate examination of the kinetic steps using ac impedance on a rotating thin ring electrode

In the absence of a bulk diffusion effect, it is shown for the first time that the impedance spectra for the chlorine evolution reaction on a rotating thin ring electrode comprise three consecutive semicircles in the capacitive half of the complex plane. The first (highest frequency) semicircle is due to the charge-transfer resistance for chloride discharge and the simultaneous chlorine adsorption coupled to the double-layer capacitance. The second semicircle (around 5 Hz) is due to the adsorption and desorption of a chlorine intermediate. The third (lowest frequency, around 0.5 Hz) semicircle is due to the relaxation of surface oxygen species. The impedance data allow the steps of the overall reaction to be examined individually. On a Pt surface the rate of chloride discharge and simultaneous chlorine adsorption (the admittance of the first semicircle) is first order with respect to chloride concentration and has a potential-dependence close to 58 mV/decade. The rate of the adsorption and desorption process (the admittance of the second semicircle) is second order with respect to chloride concentration, and has a potential dependence close to 30 mV/decade. The time constant for the adsorption/desorption processes is ca 20 ms, independent of electrode potential in the range studied. These features are consistent with a mechanism in which a faster discharge reaction (Cl⁻ Cl_ad + e) is followed by a slower surface combination reaction (2Cl_ad → Cl₂), but inconsistent with mechanisms in which ion + atom desorption is predominant, the initial chloride discharge is slow, or a unipositively charged chlorine species is involved.     

Mechanism for the Peritectic Reaction and Growth of Aligned Grains in YBa2Cu3O6+x

It is experimentally observed that the peritectic reaction, 211 + liquid → 123, can be driven essentially to completion in 1 h at an undercooling of only ∽30°C. The kinetic data, together with the observed microstructures, are inconsistent with the normal mechanism of the peritectic reaction. It is proposed that the mechanism of the reaction involves dissolution of 211 particles into the liquid and precipitation of solid 123. The aligned grain structure is explained through sympathetic nucleation of new 123 grains on existing grains.     

乙醇电氧化的研究进展

简要地叙述了国内外乙醇电催化氧化的研究进展，着重介绍不同电极材料对乙醇电氧化的影响及目前所提山的机理，并对其可能的研究方向提出了建议。