聚醚多元醇中环状齐聚物的去除(续)

(接上期第 2 3页 )3　膜分离Doraietal[16] 通过超滤除去低相对分子质量级份 ,使聚醚多元醇 ,尤其是聚四氢呋喃多元醇 ,具有较窄的分布 (Mw∶Mn=1 .2～ 1 .8)。该方法通过对多分散的熔融聚合物实施物理分级 ,达到降低相对分子质量分布的目的 ,可使最终产物的相对分子质量为 40 0～ 40 0 0 ,分散度为 1 .2～ 1 .8。该方法首先需要准备 1套交叉流动的膜分离系统 ,采用渗透膜或半渗透膜 ,膜的一边是滞留物 ,另一边是超滤液。然后 ,在起始聚合物的熔点以上 ,分解温度以下 ,且温度不大于膜的熔融和分解温度 ,将起始聚合物熔融 ,并流入该系统中…     

Electrodeposition, composition and structure of Zn—Cr alloys

The effect of polyethylene glycol (PEG 1500) as additive and of deposition conditions on Zn—Cr alloy electrodeposition from an acidic sulfate electrolyte at room temperature, without agitation was investigated. PEG polarizes the overall cathodic reaction and inhibits Zn deposition. Cr codeposition with Zn starts at a cathodic potential of about –1,95 V vs Hg/Hg₂SO₄, which is reached at current density of about 20 A dm^–2 in galvanostatic conditions. Zn—Cr alloy coatings containing up to 28 at % Cr were obtained depending on the plating conditions. SEM observations showed an island-like structure, formed by the local growth of crystals, which covered the surface during further deposition. In the first stages of electrodeposition the powder diffraction spectra contain lines of b.c.c. -(Zn,Cr) phase (a 3.02 Å). After 30 s deposition time weak lines of Zn-based phase (a 2.67 Å, c 4.90 Å) appear, and become clearly visible in coatings deposited for 90 s. The average Cr content in the alloy coatings decreases with advancing deposition. The as-plated surface contains C in organic compounds and Zn(OH)₂. After 50 min sputtering, Zn and a mixture of Cr, Cr₂O₃ and Cr₇C₃ were found. The presence of organic C and O, probably from inclusions of PEG, were also detected.     

Electrocopolymerization kinetics of a binary mixture of 3‐chloroaniline 2‐amino‐4‐phenylthiazole and characterization of the obtained block copolymer films

Electrocopolymerization of a binary mixture of 3‐chloroaniline and 2‐amino‐4‐phenylthiazole on platinum electrode in acid medium was carried out under different reaction conditions such as temperature, current density, hydrochloric acid, and monomer concentrations with duration time. The initial rate of the electrocopolymerization reaction on platinum electrode is small and the rate law is R_p = K₂ [D]^1.29[HCl]^0.97[M]^1.94. The apparent activation energy is found to be 38.87 kJ/mol. The obtained copolymer film is characterized by ¹H‐NMR, elemental analysis, GPC IR, UV‐visible, and cyclic voltammetry and compared with those of the two homopolymers. The mechanism of the electrocopolymerization reaction is also discussed and the monomer reactivity ratio (r₁and r₂) is calculated. The thermogravimetric analysis (TGA) is used to confirm the proposed structure and determination of the number of water molecules in the polymeric chain unit. X‐ray and scanning electron microscopic analysis are used to investigate the surface morphology. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 97: 2076–2087, 2005     

去甲氨噻肟酸乙酯合成研究

去甲氨噻肟酸乙酯是半合成头孢菌素药物的重要中间体之一.报道了在环合反应中,采用甲醇和水(体积比为1∶1)的混合溶剂代替二氯甲烷,甲醇等单一溶剂,反应温度在25℃左右下进行,收率明显提高,可达56.2%,结果令人满意.产品结构用1HNMR验证.     

循环荷载作用下重塑饱和粉黏土的刚度弱化特性研究

以东海大桥海上风电场项目为课题背景,通过动三轴系统对重塑饱和粉质黏土开展一系列长期不排水循环加载三轴试验,分别考虑围压、动应力比和频率3种因素,特别是对高频(f5 Hz)下土体的动力弱化特性进行了研究。试验结果表明:累积塑性应变与累积孔压随着循环次数的增加而增大并且趋于稳定,呈现出应变软化和孔压软化现象。割线动变形刚度模量和割线动弹性刚度模量则随着循环次数的增加,先急剧降低然后趋于稳定,从而表现出刚度弱化现象。进一步研究了割线动弹性刚度模量与循环应变幅值的关系,割线动弹性刚度模量的衰减趋势受动应力比和频率的影响不大,与围压有关,围压越大,割线动弹性刚度模量衰减趋势越慢,衰减稳定幅值越低。     

制氢装置转化催化剂失活原因分析及对策

中石化西安分公司制氢装置转化催化剂在短期生产运行过程中,因催化剂积碳导致转化炉管表面出现大面积花斑,近半数炉管出现红管,炉管差压增大,转化出口甲烷含量超标,芳烃穿透.对催化剂失活原因进行细致分析后表明:装置开停车频繁;转化催化剂多次积碳-烧碳使催化剂表面剥蚀破碎、跑损严重为主要原因.针对失活原因制定了相应对策.     

Electrochemical investigations of copper behaviour in different cupric complex solutions: Voltammetric study

The electrochemical behaviour of copper has been investigated in different cupric complex solutions by cyclic voltammetry. In pyridinic and picolinic solutions the reduction of cupric complex occurred in two stages leading to Cu(I) and Cu(0), respectively. The electrodeposited copper is oxidized in two steps leading to Cu(I) and Cu(II) as in ammoniacal cupric complex solutions. In glycine, alanine, sulfamic acid and ethylenediamine solutions, the cuprous complex is an intermediate in the cupric complex reduction but it is not detected during the oxidation of the electrodeposited copper in these solutions. In EDTA and triethanolamine solutions, the cuprous complex is not observed. The rate of copper etching was determined in pyridinic and ammoniacal cupric solutions and was shown to be faster in ammoniacal cupric solutions than in the pyridinic solutions.     

Activation of a Au/TiO2 Catalyst by Loading a Large Amount of Fe–Oxide: Oxidation of CO Enhanced by H2 and H2O

Catalytic activity of a 1 wt% Au/TiO₂ catalyst is markedly improved by loading a large amount of FeO_x, on which the oxidation of CO in excess H₂ is selectively promoted at temperature lower than 60 °C. Oxidation of CO with O₂ on the FeO_x/Au/TiO₂ catalyst is markedly enhanced by H₂, and H₂O moisture also enhances the oxidation of CO but its effect is not so large as the promotion by H₂. We deduced that activation of Au/TiO₂ catalyst by loading FeO_x is not caused by the size effect of Au particles but a new reaction path via hydroxyl carbonyl intermediate is responsible for the superior activity of the FeO_x/Au/TiO₂ catalyst.     

循环经济与浮法玻璃工艺的发展

在玻璃行业贯彻循环经济的理念,改进工艺思想和方法,节约资源,降低消耗,提高资源利用率,减少污染物排放,是我们对后人应负的责任和对地球应尽的义务。     

Interactions between Cytochrome c and DNA Strands Self-Assembled at Gold Electrode

In this work, we reported the investigation on the interaction between DNA strands self-assembled at gold electrodes and an electron transfer protein, cytochrome c. We observed that cytochrome c exhibited well-defined electrochemistry in both double-stranded and single-stranded DNA films. This suggested that the electron transfer reaction of cytochrome c arose possibly due to the electron hopping along DNA strands rather than wiring along the double helix. We also compared the heterogeneous electron transfer rate of cytochrome c with that of a ruthenium complex, which further confirmed this mechanism.