全文获取类型
收费全文 | 35488篇 |
免费 | 4348篇 |
国内免费 | 3422篇 |
专业分类
电工技术 | 2546篇 |
综合类 | 3630篇 |
化学工业 | 2081篇 |
金属工艺 | 5208篇 |
机械仪表 | 3247篇 |
建筑科学 | 7156篇 |
矿业工程 | 2740篇 |
能源动力 | 867篇 |
轻工业 | 396篇 |
水利工程 | 2433篇 |
石油天然气 | 1481篇 |
武器工业 | 434篇 |
无线电 | 1300篇 |
一般工业技术 | 5343篇 |
冶金工业 | 2094篇 |
原子能技术 | 281篇 |
自动化技术 | 2021篇 |
出版年
2024年 | 185篇 |
2023年 | 557篇 |
2022年 | 1051篇 |
2021年 | 1349篇 |
2020年 | 1358篇 |
2019年 | 1173篇 |
2018年 | 1059篇 |
2017年 | 1391篇 |
2016年 | 1515篇 |
2015年 | 1592篇 |
2014年 | 2316篇 |
2013年 | 2331篇 |
2012年 | 2694篇 |
2011年 | 2972篇 |
2010年 | 2146篇 |
2009年 | 2181篇 |
2008年 | 1940篇 |
2007年 | 2296篇 |
2006年 | 2169篇 |
2005年 | 1684篇 |
2004年 | 1429篇 |
2003年 | 1319篇 |
2002年 | 1112篇 |
2001年 | 893篇 |
2000年 | 803篇 |
1999年 | 703篇 |
1998年 | 539篇 |
1997年 | 478篇 |
1996年 | 345篇 |
1995年 | 327篇 |
1994年 | 266篇 |
1993年 | 190篇 |
1992年 | 177篇 |
1991年 | 135篇 |
1990年 | 130篇 |
1989年 | 107篇 |
1988年 | 89篇 |
1987年 | 38篇 |
1986年 | 30篇 |
1985年 | 31篇 |
1984年 | 20篇 |
1983年 | 23篇 |
1982年 | 16篇 |
1981年 | 5篇 |
1980年 | 13篇 |
1979年 | 24篇 |
1961年 | 5篇 |
1960年 | 6篇 |
1959年 | 11篇 |
1955年 | 7篇 |
排序方式: 共有10000条查询结果,搜索用时 0 毫秒
71.
This paper presents observations regarding the cracking behavior of tensile-loaded structural adhesive joints. Experiments showed that fracture occurred by the development and propagation of a damage zone, rather than a single, sharp crack, and that the presence of the adhesive spew fillet did not affect the fracture load of the adhesive joints studied. For joints bonded with the mineral-filled epoxy Cybond 4523GB (American Cyanamid), there was approximately 5 mm of subcritical crack propagation prior to final fracture. Fracture-load predictions based on the initial uncracked geometry made in previous papers were unaffected by this small change in geometry. For joints bonded with the rubber-toughened epoxy Permabond ESP 310, approximately 50 mm of subcritical crack propagation was observed. It was again found that predictions made in previous papers on the basis of the initial geometry gave a good estimate of the final fracture load even though this subcritical crack propagation significantly altered the geometry, and thus the applied energy release rates. The effect of shear deformations of the adherends was also investigated, and it was found that shear deformations could be neglected in engineering calculations for joints subject to remote tensile loading. 相似文献
72.
胜利油田污水储罐腐蚀防护方法评价 总被引:1,自引:0,他引:1
对胜利油田纯粱采油厂A3钢制生产污水(水温约60℃)储罐使用寿命过低的原因进行了实验考察。水质分析数据表明氯离子浓度高(45-48gm)是污水腐蚀性强的主要因素。A3钢在60℃污水中的腐蚀速率,由极化曲线数据计算的值大大高于失重法测定值,敞开系统中失重法测定值又高于密闭系统中测定值,挂片上出现蚀孔,说明储罐中A3钢发生了氧存在下氟离子引起的局部腐蚀(孔蚀)。元素分析结果表明.储罐阴极保护所用的牺牲阳极铝材含铁等元素量超标。牺牲阳极密封不良,在实验污水中7天后电流效率仅为2.92%,失去阴极保护能力。处于实验污水环境中的有涂层保护的A3钢.14天后出现腐蚀极化电流,表明涂层已失去完整性。要提高该采油厂及胜利油田其他采油厂污水储罐的使用寿命,必须改用合格的牺牲阳极和保护涂层材料。图3表2参7。 相似文献
73.
高压供电设备故障特别是输电线路的高压接地故障对工地的影响是相当大的。由于接地故障为隐性故障,没有明显的物理现象,且若是长期接地可能会发展成较为严重的两相或三相短路故障,使系统解列运行直至崩溃;由于工地流动人员较多,还易造成电击事故。利用高压一相接地时在线路中产生零序电压这一特性来迅速判断和切除接地的用电设备,可以保证各项施工的顺利进行。 相似文献
74.
The effect of deformation speed on defect structures introduced into bulk gold specimens at 298 K has been investigated systematically over a wide range of strain rate from ′=10−2 to 106 s−1. As strain rate increased, dislocation structure changed from heterogeneous distribution, so-called cell structure, to random distribution. Also, stacking fault tetrahedra (SFTs) were produced at anomalously high density by deformation at high strain rate. The anomalous production of SFTs observed at high strain rate is consistent with the characteristic microstructure induced by dislocation-free plastic deformation, which has been recently reported in deformation of gold thin foils. Thus, the results of the present study indicate that high-speed deformation induces an abnormal mechanism of plastic deformation, which falls beyond the scope of dislocation theory. Numerical analysis of dislocation structure and SFTs revealed that the transition point of variation of deformation mode is around the strain rate of 103 s−1. 相似文献
75.
双头螺栓失效分析 总被引:4,自引:3,他引:1
金蔚静 《理化检验(物理分册)》2003,39(5):268-270
与汽车电机装配在一起的双头螺栓在拧紧后不久便发生断裂。采用扫描电镜、化学分析、金相检验等方法对失效件进行了检测,同时又进行了氢脆试验验证。结果表明,螺栓在进行表面酸洗及电镀时,氢向金属内部扩散和富集,当氢浓度达到一定临界值后,促使氢致裂纹的产生和扩展。在外应力的作用下,即出现氢脆现象导致螺栓断裂。 相似文献
76.
本文从紧凑式轧机的轧制变形特点出发,分析了其变形规程设计的主要特点和方法,讨论了限制其道次变形量的基本因素,给出了优化设计的目标函数和约束条件。指出,类似这种具有复杂约束的轧制变形问题采用混合罚函数法处理更为有效,并成功地采用该方法进行了变形规程的试设定。 相似文献
77.
抽油机井有杆果采油装置检泵故障数据的特点在于相邻两次检泵间隔之间的时间并非总是来自同一总体,可能有某种趋势的变化。通过对故障数据的趋势性检验,可验证其对某一随机过程模型的适应性,从而判定某一口井或某一批工况大致相同油井的运行可靠性,实现对生产井运行可靠性的定量评估。还通过实例说明了有杆泵抽油系统检泵故障数据的可靠性分析方法。 相似文献
78.
本文基于弹塑性分叉理论研究单向纤维增强复合材料的压缩破坏模式和压缩强度对缺陷的敏感性问题。对于常见复合材料,所得结论是:无缺陷或者小缺陷情况的破坏模式为倾斜破坏带;大缺陷情况的破坏模式为水平破坏带;形成水平破坏带的压力值小于形成倾斜破坏带的压力。 相似文献
79.
80.
Royzman Edward B.; Cassidy Kimberly Wright; Baron Jonathan 《Canadian Metallurgical Quarterly》2003,7(1):38
This article reviews the evidence and theory pertaining to a form of perspective-taking failure--a difficulty in setting aside the privileged information that one knows to be unavailable to another party. The authors argue that this bias (epistemic egocentrism, or EE) is a general feature of human cognition and has been tapped by 2 independent and largely uncommunicating research traditions: the theory-of-mind tradition in developmental psychology and, with more sensitive probes, the "heuristics and biases" tradition in the psychology of human judgment. This article sets the stage for facilitating communication between these traditions as well as for the recognition of EE's breadth and potential interdisciplinary significance. The authors propose a life-span account and a tentative taxonomy of EE; and they highlight the interdisciplinary significance of EE by discussing its implications for normative ethics. (PsycINFO Database Record (c) 2010 APA, all rights reserved) 相似文献