高气速选择性分离氨碳混和气模拟实验

采用二级串联鼓泡吸收器对NH3／CO2摩尔比为2：1的混和气体进行高气速选择性吸收，获得氨的总吸收率为96．7％，二氧化碳的总吸收率为33．1％，二级吸收器出口气相CO2摩尔含量达90．9％，液相氨碳摩尔比为5．85。将此吸收液在加压下精馏分离氨，基本可以把吸收液中游离氨回收。分离游离氨后的溶液在常压下进行解吸，蒸馏塔出口液体含NH3和CO2量仅为0．014％和0．006％，解吸气回串联吸收器进行循环吸收分离。对预计工业分离过程进行物料和能量衡算，分离1kg液氨需1MPa的蒸汽约3.2kg。     

原位聚合法纳米材料改性不饱和聚酯树脂研究

利用原位聚合法将nm SiO2预先分散到生产不饱和聚酯树脂的原料体系中,通过改进树脂生产工艺,可直接制得纳米改性不饱和聚酯树脂,并使树脂固化后的强度、韧性、耐热性等性能得到较大幅度的提高,并对其改性机理作了初步的探讨。     

邻菲啰啉分光光度法测定离子膜碱中的三氧化二铁

介绍采用邻菲啰啉分光光度法对离子膜碱中三氧化二铁进行的测定,并就吸收曲线、邻菲啰啉铁络合物的稳定性、显色剂浓度对照试验、邻菲啰啉与铁的摩尔比、溶液酸度对络合物的影响以及共存离子消除等条件进行了探讨,以能更好地满足实际检测工作的需要.     

氧化铝生产赤泥附液吸收H_2S实验研究

对氧化铝生产附产赤泥吸收净化H2 S废气进行了实验研究 ,赤泥附液吸收H2 S具有吸收效率高、吸收容量大、易控制 ,操作简便等优点 ,在较少时间内对H2 S的吸收效率保持在 90 %以上。     

N-己酰氨基葡萄糖合成方法的改进

改进了N-己酰氨基葡萄糖的合成方法，产率为91%；并研究了不同温度和不同比例时，产物在水和乙醇中的溶解度。     

原位聚合制备尼龙6/纳米SiO2复合材料研究

对原位聚合制备尼龙6／纳米SiO2进行研究。结果表明，无论是否对纳米SiO2复合材料进行偶联化处理，其表面均将在原位聚合过程中与尼龙6产生接枝；SiO2表面接枝物的生成，可在某种程度上造成体系结晶程度的降低，但复合体系的力学性能主要由SiO2粒子的分散程度、粒子和其体之间的相界面性质等因素决定；采用经偶联剂处理并具有较小粒径和较大比表面积的SiO2对尼龙6进行复合，可使复合体系的力学性能指标达到较高的水平，且硅烷偶联剂的最佳用是为SiO2的3％左右。     

Anodic dissolution of spongy titanium in ethanol solution for preparation of nano-sized TiO2 powder

Nano-sized TiO₂ powder was prepared by electrochemical dissolution of spongy titanium in an ethanol solution following direct hydrolysis of the electrolyte solution. Characterization of the electrochemical product revealed that Ti(OEt)₄ was formed by anodic dissolution of spongy titanium in ethanol solution. X-ray diffraction and transmission electron microscope were, respectively, used to investigate the structure of TiO₂. This study showed that nano-sized TiO₂ prepared by this method has a structural and thermal stability with a narrow size distribution of 5-10 nm. The optimum electrochemical operating conditions established were a temperature of 333-343 K, current density of 400 A m⁻² and faradaic efficiency of 86%. Experiments showed that this process might be recommended as a promising technique for synthesis of nano-sized powder.     

Potential for use of crushed waste calcined-clay brick as a supplementary cementitious material in Brazil

The Brazilian ceramic industry generates large amounts of calcined-clay waste. This paper examines the factors that influence its potential for use as a partial replacement of Portland cement. Superplasticized mortars of equal workability containing ground crushed waste calcined-clay brick (GCWCCB) in the proportions of 10, 20, 30 and 40% as a cement replacement were analyzed through mechanical tests, pore structure characterization and durability tests. The results indicated the optimal percentages of substitution lies between 10% to 20%. The potential reduction of CO₂ emissions could be as high as 10% of current Brazilian cement industry emissions if this approach were to be fully implemented, and it could be eligible for “Clean Development Mechanism” credits under Kyoto protocol.     

微波促进二氯菊酸甲酯的水解新工艺研究

采用微波技术对二氯菊酸甲酯在NaOH溶液中水解为二氯菊酸工艺进行了研究。结果表明,微波促进下最佳水解条件为:反应温度90℃,功率100 W,反应时间10 m in,物质的量比n(二氯菊酸甲酯)∶n(C2H5OH)∶n(NaOH)=1∶4∶1.5,重结晶后收率高达99.6%。与传统条件相比,时间缩短30倍,收率提高24.6%,无水乙醇用量减少60%,NaOH用量减少17%。并用红外光谱和熔点对二氯菊酸进行表征。     

ZnO压敏电阻器的性能及发展

简要回顾了ZnO压敏电阻器的历史，阐述了ZnO压敏电阻器的性能以及当前基础性研究的现状，并对其发展进行了展望。研究了Bi2O3和TiO2的掺杂对低压ZnO压敏电阻性能和微观结构的影响规律，从理论上分析了Bi2O3和TiO2添加剂的作用机理。为ZnO压敏电阻的低压化提供了理论依据和方法。