利用电阻场板提高SOI-LIGBT的性能

通过在SOI-LIGBT中引入电阻场板和一个p-MOSFET结构,IGBT的性能得以大幅提高.p-MOSFET的栅信号由电阻场板分压得到.在IGBT关断过程中,p-MOSFET将被开启,作为阳极短路结构起作用,从而使漂移区的过剩载流子迅速消失,IGBT快速关断.而且由于电场受到电阻场板的影响,使得过剩载流子能沿着一个更宽的通道流过漂移区,几乎消去了普通SOI-LIGBT由于衬偏造成的关断的第二阶段.这两个因素使得新结构的关断时间大大减少.在IGBT的开启状态,由于p-MOSFET不导通,因此器件的开启特性几乎与普通器件一致.模拟结果表明,新结构至少能增加25%的耐压,减少65%的关断时间.     

Viscoelasticity of oxidized starch/low methoxy pectin mixtures in the presence of glucose syrup

The structural properties of mixtures of pectin, oxidized starch and glucose syrup were investigated using small deformation dynamic oscillation. In the absence of added calcium, preparations of low methoxy pectin with glucose syrup formed viscous solutions, which remained crystal-free at subzero temperatures. Samples of oxidized starch and glucose syrup, on the other hand, exhibited solid-like behaviour because of the crystalline nature of the amylose-like helices. Mixtures of the two polysaccharides with the co-solute clearly showed phase inversion from liquid to solid-like behaviour with increasing amounts of starch in the formulation. The transformation was reflected in the textural properties of samples, which varied from thick solutions to firm gels. The viscoelasticity of the system was modified further by the introduction of high methoxy pectin. Preparations of high methoxy pectin and glucose syrup formed rubbery gels whose amorphous nature underwent a glass transition during cooling.     

约束层阻尼夹芯板动态特性分析

本文给出了新的建立约束层阻尼薄板动力学模型的方法。粘弹性材料的本构关系随温度和频率变化,难以对粘弹结构进行动特性分析及控制研究,本文采用GHM方法描述弹性材料的本构关系,将粘弹性材料的动力特性描述与工程上最常用的有限元分析结合起来,建立了悬臂约束层阻尼板的动力学模型,计算了约束层阻尼夹芯悬臂板的模态参数,计算结果同其它方法相比,精度高且更接近于实验结果,同时与ANSYS5.5及NASTRAN70.7的计算结果基本一致,表明本文给出的方法是准确可靠的。     

新型压滤机液压控制系统的研制

 针对压滤机的工艺要求，在对新型压滤机液压控制系统研究设计的基础上，利用功率键合图方法建立了压滤机液压系统数学模型，并运用Matlab语言进行动态特性仿真．在压滤机现场实际运用表明该系统性能达到了预期目标，为压滤机液压系统优化设计提供了依据．     

Continuous formation of slurry ice by cooling water–oil emulsion in a tube

Water-silicone oil emulsion with an additive, (C₂H₅O)₃SiC₃H₆NH₂, was examined as a heat storage material. A spiral tube used as a heat exchanger was immersed in a low temperature bath and the emulsion was circulated in the tube to make ice continuously. Ice was separated from the ice–liquid suspension in an outlet tank. The amount of formed ice, the temperatures of the inlet and the outlet of the heat exchanger, and the temperatures in the tube wall were measured and the overall heat transfer coefficient and the heat flux through the tube were calculated. Experiments were carried out, varying the flow rate, the temperature of cooling brine, and the thickness of tube wall. The condition under which slurry ice was formed continuously without adhesion of ice to the cooling wall was clarified. Though decrease in the thermal resistance of the tube increased the rate of ice formation or raised the brine temperature, it narrowed the range of the flow rate and of the brine temperature in which slurry ice was formed continuously.     

固液相变蓄能的数学模型和自然对流换热系数的实验研究

引入自然对流换热系数 ,将固液蓄能数学模型简化为仅用能量方程加以描述。并通过实验测得相变过程的实际温度场 ,证明了自然对流固液相变换热的影响不可忽略 ,验证了固液相变界面移动速率随自然对流换热系数的增大而增大的定性关系     

DC-DC变换器突加负载时的动态性能研究

提出了一种能够有效改善DC-DC变换器动态性能的方案。该方案是在全桥电路基础上并联一单端正激变换电路，使变换器负载从10%轻载突加到100%满载时，其暂态过程小于1μs输出电压达到设计要求。文中对具体电路进行了详细分析，并通过仿真进行了验证。     

基于PLC电液比例控制的液力测功装置开发及其应用

本文介绍一种齿轮动态加载试验规范及技术要求，论述了运用电液比例控制技术所设计的液压加载系统原理及其使用效果，并简述由此构造的液力测功装置的原理与应用前景。     

无线移动自组网络的动态源路由策略

文章介绍无线移动自组网中动态源路由策略的路由发现和路由维护,并提出改进思路和今后研究的方向。     

云南省水环境状况及问题分析

根据2000年云南省主要河流水质监测评价结果，全省评价河段总长9280km中，水质为Ⅰ－Ⅲ类的河长占76．3％，总体上，云南省内各大水系水质良好，但水污染总体上正在加重，从1985－2000年，Ⅰ类河长年均减少2．3％，V类河长年均增长0．6％，废污水直接排入江河是引起污染的重要原因。水环境问题已成为社会经济可持续发展的关键问题，要切实加强水资源的保护，科学地开发利用水土资源，为了有效地改善水环境的质量，污染控制应从源头开始并采取综合治理措施。