聚合物降解产物伤害与糖甙键特异酶破胶技术

综述了钻井，完井，尤其是水力压裂作业中产生的多糖类聚合物伤害和应用糖甙键特异酶破胶，解除多糖类聚合物伤害的技术。第一节报道了聚合物降解产物造成的伤害，指出冻胶破胶液粘度低并不代表压裂液已从充填裂缝中充分返排，氧化破胶剂和普通酶破胶剂不能使多糖类聚合物充分降解，产生的大分子量，水不溶的降解产物可对地层造成伤害，消除伤害的办法是采用对糖甙键有特异性的各种水解酶作压裂液破胶剂或伤害地层处理剂。第二节报道了各种聚合物（纤维素，瓜尔胶，淀粉）糖甙键特异酶降解聚合物的机理。第三节报道了糖甙键特异酶（主要针对瓜尔胶）的应用性能测试及结果，包括岩心流动实验，含糖量和分子量测定，传导性测试。第四节介绍了糖甙键特异酶消除聚合物伤害和用作压裂液破胶剂的现场应用，包括选井原则，实施工艺要点及3个典型井例。     

利用CFD获取超声流量计截面速度分布

 通过CFD技术在超声波流量计设计过程中的引入,为流量系数的获取提供了新的途径.通过对特定管道的理论计算表明,采用CFD技术获取的管道内部流型完全可以与试验数据吻合,有助于超声波流量计应用场合流量系数曲线的获取及其精度的保证.     

内循环好氧三相流化床处理造纸中段废水

本实验采用内循环好氧三相流化床处造纸中段废水，经过一段时间的驯化，获得了稳定的出水。CDO去除经保持在65％以上，系统对进水污染负荷的变化具有较大的承受能力。出水Cl^-的浓度有所增加，说明驯化后的微生物可能对有抽氯化物具有一定的降解作用。水气比在1／120至1／140之间可获得最好的COD去除效果。后进行絮凝处理后，出水COD降为60－80mg/L,BODo 50-60/L，色度为100－150CU，挥发性酚的质量浓度小于0．0265mg／L。     

A broad line n.m.r. study of oriented poly(vinylidene fluoride)

Broadline nuclear magnetic resonance measurements have been carried out for the proton resonance in oriented poly(vinylidene fluoride). The spectra in general show two component lines with distinctly different line widths. The broad component shows a high degree of molecular orientation and can be satisfactorily assigned to the crystalline regions of the polymer. The narrow component corresponds to an oriented non crystalline phase which is sufficiently constrained to allow motion about the chain axis only. An appreciable decrease in the value of the rigid mass fraction was observed in both of the samples over the temperature range examined. Our calculations indicate that this could play an important role in the temperature dependence of the pyroelectric response of this material.     

四平市地下水动态监测工作的问题和对策

根据四平市动态监测工作中存在的问题,分析其产生的原因,并提出相应对策。     

Voltage sag compensation with minimum energy injection by use of a micro‐SMES

This paper presents a method to compensate voltage sags with minimum energy injection for a series‐connected voltage restorer using a micro‐SMES. A circuit for extracting the fundamental symmetrical components from sag voltages and a minimum energy injection algorithm is described. Simulations of voltage sag compensation have been carried out using PSCAD/EMTDC for various faults. The simulation results confirm the validity of the proposed method and show the possibility of reducing the size of energy storage devices. © 2002 Wiley Periodicals, Inc. Electr Eng Jpn, 141(3): 70–80, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10047     

基于INI文件的动态构图案例编程

本文结合动态构图案例编程．主要分析了INI文件的结构特点，给出了设备仿真程序动态构图部分的编程方法，对于开发设备仿真类软件有一定的借鉴作用。     

NBR/PP热塑性弹性体研究进展

阐述了NBR／PP共混热塑性弹性体动态硫化胶的国内外研究进展、微观相态结构、性能、应用及展望。     

飞秒激光烧蚀研究进展

介绍飞秒激光烧蚀材料的机理论模型，阐述飞秒激光烧蚀的特性，揭示飞秒激光烧蚀的广泛应用前景。     

Viscosity estimation for slags containing calcium fluoride

Based on recently published experimental data, the Riboud model was modified for viscosity estimation of the slags containing calcium fluoride. The estimated values were in good agreement with measured data. Reasonable estimation can be achieved using the modified Riboud model for mould fluxes and ESR (eletro slag remelting) slags. Especially for ESR slags, the modified Riboud model can provide much more precise values than the original Riboud model.