Effect of chromium aging on the structural and thermal properties of chromium polyacrylate

The effects of aging time of Cr(III) solutions on the structural, thermal, magnetic, and morphological properties of chromium polyacrylate complexes were studied. Chromium retention was found to increase with longer aging periods. IR spectra revealed the formation of polychelate structures with noticeable changes on aging. The interaction of multivalent, polynuclear Cr(III) species with the polymer backbone resulted in a decrease in thermal stability for the complexes prepared from olated chromium solutions. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 98: 490–493, 2005     

近临界水中薯蓣皂苷水解生成薯蓣皂苷元的工艺研究

薯蓣皂苷元是合成甾体激素类药物和甾体避孕药的重要中间体,传统工艺采用盐酸水解法将黄姜中的薯蓣皂苷水解生成薯蓣皂苷元,反应时间4 h,最大收率为1.78%.该工艺反应时间长,耗水量大,对环境污染严重.今研究了无催化剂条件下,近临界水中薯蓣皂苷水解成薯蓣皂苷元的工艺,分别考察了反应温度、反应压力、反应时间等因素对薯蓣皂苷元收率的影响.研究结果表明,近临界水解法工艺简单,反应时间短,对环境友好,在较佳工艺条件下:P=25.0 MPa,T=260℃,t=10 min,薯蓣皂苷元收率为1.46%.     

碳酸丙烯酯—水二元系溶液蒸汽分压的推算

从Ｖａｎ Ｌａａｒ方程出发，推算碳酸丙烯酯－水二元系溶液中碳酸丙烯酯和水的活度系数，然后再利用非理想溶液的Ｒａｏｕｌｔ定律，分别算出碳酸丙烯酯和水的蒸汽分压。     

亚硝酸型反硝化生物脱氮的节能机理及优化方案

须焦化污水处理工艺中，通过对亚硝酸型反硝化生物脱氮与硝酸型反硝化生物脱氮工艺的比较，探讨了需氧量、耗碱量及投资降低的机理。试验得出的优化方案是以NaOH为碱源的亚硝酸型反硝化生物脱氮工艺。     

柔性无机材料外墙保温隔热涂料的研制

以弹性丙烯酸乳液为成膜物,以玻化微珠、空心玻璃微珠、膨胀蛭石、岩棉纤维为填料,在助剂的配合下,制备柔性保温隔热涂料。以薄涂型施工于建筑外墙作保温层,其涂层具有生态环保、安全稳固、保温隔热、防水防火、柔韧抗裂、施工简便等优点,适用于夏热冬暖、夏热冬冷地区的建筑物外墙作保温施工。     

填料技术在高浓度氯碱化工废水生物接触氧化法处理中应用的研究

阐述了填料技术在生物接触氧化法处理高浓度氯碱化工废水中的应用,介绍了目前国内外应用较广的几种主要填料的工艺特点,对它们的性能进行了比较;并结合锦化化工(集团)有限责任公司污水处理厂多年的生产运行经验,讨论了生物接触氧化法中应用的几种较理想的填料;扼要分析了填料技术的发展方向和前景。     

去酸水用于钠离子交换树脂再生试验

根据离子交换原理，利用纺丝去酸水代替食盐、芒硝再生钠离子交换树脂，可以去除硬水中的钙离子和镁离子。再生阴床排出碱性废水加入去酸水中，可降低去酸水酸度，提高出水pH，出水水质达到软化水水质标推。用去酸水再生，可减少污染，降低纺丝工艺排水酸度，具有明显的社会效益和经济效益。     

消火栓水枪喷嘴水力计算方法的简化

针对目前消火栓喷嘴水力计算采用试算及图表法所存在的问题,通过对原求解函数的优化拟合,推导出可直接计算的解析式,便于基层设计人员在实际工程设计中应用。对该解析式计算精度的分析表明,在常用参数范围内,最大拟合误差仅为1.49%,满足现行规范要求。     

Dehydration of tetrahydrofuran by pervaporation using crosslinked PVA/PEI blend membranes

Dense blend membranes were prepared by blending hydrophilic polymers poly(vinyl alcohol) (PVA) and poly(ethyleneimine) (PEI), which were then crosslinked by glutaraldehyde (GA) in a mixture of solvents under the catalysis of hydrochloric acid (HCl) for the dehydration of tetrahydrofuran (THF) by pervaporation. The effect of experimental parameters such as feed water concentration, permeate pressure, and membrane thicknesses on permeate parameters, i.e., flux and selectivity were determined with feed water concentration less than 40 wt %. The membranes were found to have good potential for breaking the azeotrope of 94 wt % THF with a flux of 1.072 and 0.376 kg/m² h for plane PVA/PEI and crosslinked PVA/PEI blend membrane, which exhibited high selectivity of 156 and 579 respectively. Selectivity was found to improve with decreasing feed water concentration and increasing membrane thickness, whereas flux decreased correspondingly. High permeate pressure causes a reduction in both flux and selectivity. These effects were clearly elucidated with the aid of the known relationship among plasticization effect, degree of swelling, permeate pressure, and feed water concentration. These blend membranes were also subjected to sorption studies to evaluate the extent of interaction and degree of swelling in pure as well as binary feed mixtures. Further ion exchange capacity studies were carried out for all the crosslinked and uncrosslinked membranes to determine the total number of interacting groups present in the membranes. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 102: 1152–1161, 2006     

分析用水对陶瓷铅溶出量测定的影响

分析用水水质对日用陶瓷铅溶出量测定具有重要影响,CL-、SO42-、CO2等严重抑制铅的溶出,使测定结果偏低。