预处理工艺对硬质合金与金刚石膜间粘结力的影响

在两种经不同预处理的硬质合金YG8基底上，采用微波等离子体化学气相沉积法，在微波功率2kW，压强4.0kPa和6.5kPa，CH4和H2流量分别为1.6cm/s和100.0cm/s的条件下生长金刚石薄膜。利用X射线衍射检测了金刚石薄膜是否存在，用拉曼光谱分析了薄膜的质量，用金相显微镜观察了薄膜的洛氏硬度压痕，标定并比较了不同预处理工艺膜与基底的结合力。实验结果表明，不同的预处理方法对于粘结力的影响不大，最主要的因素是钴含量的多少。     

高质量ZnO薄膜的退火性质研究

在LP－MOCVD中，我们利用Zn(C2H5)2作Zn源，CO2作氧源，在（0002）蓝宝石衬底上成功制备出皮c轴取向高度一致的ZnO薄膜，并对其进行500℃-800℃四个不同温度的退火。利用XRD、吸收谱、光致发光谱和AFM等手段研究了退火对ZnO晶体质量和光学性质的影响。退火后，（0002）ZnO的XRD衍射峰强度显著增强，c轴晶格常数变小，同时（0002）ZnOX射红衍射峰半高宽不断减小表明晶粒逐渐增大，这与AFM观察结果较一致。由透射谱拟合得到的光学带隙退火后变小，PL谱的带边发射则加强，并出现红移，蓝带发光被有效抑制，表明ZnO薄膜的质量得到提高。     

锂离子电池有机电解液成膜添加剂的研究现状

文章综述了锂离子电池有机电解液成膜添加剂的作用原理，具体介绍了CO2、SO2、VC化合物、卤化物、有机铜盐以及马来酐等添加剂的研究现状。     

Preparation and photochromism of nanocomposite thin film based on polyoxometalate and polyethyleneglycol

A photochromic nanocomposite based on Keggin structure phosphomolybdic acid (PMoA) well dispersed in polyethyleneglycol (PEG) was fabricated. TEM image showed that PMoA nanoparticles with narrow size distribution were finely dispersed in polymer matrix. FT-IR results showed that the Keggin geometry of polyoxometalates was still preserved inside the composites and strong coulombic interaction was built between PMoA and polymer matrix. Under UV irradiation, the film was reduced photochemically to yield a blue species, which was in accordance with a charge-transfer mechanism.     

交联透明质酸的降解及其释药性能

用己二酸二酰肼（ADH）对透明质酸（HA）进行化学修饰，制备交联透明质酸（HA-ADH）薄膜。粘度法测试表明HA-ADH是一种可降解的生物材料，并且与HA相比，HA．ADH的降解速率减慢。在此基础上，研究了以疏水性的替硝唑（TDZ）和亲水性的头孢唑啉钠（CEZ）为模拟药物的HA-ADH药物载体薄膜的释药性能。紫外-可见（UV-Vis）吸收光谱检测表明，HA-ADH是一种疏水性药物TDZ的优良缓释制荆，这是由于TDZ的疏水性和HA-ADH薄膜的缓慢溶胀和降解性能的结合而得到的，药物的释放主要受扩散机制控制。     

Corner flow in free liquid films

A lubrication-flow model for a free film in a corner is presented. The model, written in the hyperbolic coordinate system ξ = x ² −y ², η = 2xy, applies to films that are thin in the η-direction. The lubrication approximation yields two coupled evolution equations for the film thickness and the velocity field which, to lowest order, describes plug flow in the hyperbolic coordinates. A free film in a corner evolving under surface tension and gravity is investigated. The rate of thinning of a free film is compared to that of a film evolving over a solid substrate. Viscous shear and normal stresses are both captured in the model and are computed for the entire flow domain. It is shown that normal stress dominates over shear stress in the far field, while shear stress dominates close to the corner. This revised version was published online in October 2005 with corrected page numbers.     

Wave dynamics on a thin-liquid film falling down a heated wall

The dynamics of a thin liquid film falling down a uniformly heated wall is studied. The model introduced by Kalliadasis et al. [J. Fluid Mech. 475 (2003) 377] for the same problem is revisited and its deficiencies, namely the prediction of a critical Reynolds number with 20% error, cured. For the energy equation a high-order Galerkin projection in terms of polynomial test functions is developed. It is shown that not only does this more refined formulation correct the critical Reynolds number, but it also gives, with an appropriate expansion close to criticality, the long-wave theory. Bifurcation diagrams for permanent solitary waves are constructed and compared with the solution branches obtained from different models. It is shown that, in all cases, the long-wave theory exhibits limit points and branch multiplicity, while the other models predict the continuing existence of solitary waves. Time-dependent computations show that the free surface and interfacial temperature approach a train of coherent structures that resemble the infinite-domain stationary solitary pulses.     

Optical switching properties of RCo2-type alloy thin films by electrochemical hydrogenation

The switchable optical properties of Pd-protected RCo₂-type Ho_0.6Mm_0.4Co₂ alloy thin films have been investigated in a KOH electrolyte. The reversible optical switching has been carried out simultaneously by measuring transmitted light through the thin film during electrochemical charging–discharging of hydrogen. The dependence of switching speed and cyclic durability of the film on the charging and discharging current density as well as concentration of KOH electrolyte has been studied. In addition, cyclic voltammetric measurements have been performed to examine the hydride formation and decomposition reactions.     

用于PET薄膜回收的螺杆设计

根据PET薄膜的特点和高分子熔融态流动理论，分析了挤出回收用螺杆的各段结构，及螺杆参数选择，设计出大长径比、深槽、双排气、高效专用螺杆。