Investigation of failure mechanism and modification for film-lubricated precise angular-contact ball bearing

This paper describes an experimental investigation into the performance and lubrication failure mechanism of precise angular-contact ball bearings treated with MoS₂-sputtered film, etc. As an important executive component of various spacecrafts, there are some strict requirements on the lubrication performance of angular-contact ball bearing, but the related experimental data are rare to see in literatures. In this experiment, the lubrication performances of MoS₂-sputtered ball bearing pairs were evaluated by using lifetime test as a main method, and the topographies and compositions of working surfaces were investigated through SEM, AES and EDS. The systematical experiment results reveal that the degradation and failure process of solid lubrication for such ball bearing is divided into three stages with different characters. A supposed failure mechanism has been proposed. An improved lubrication treatment based on above mechanism was conducted for the precise ball bearings, and a later test showed that long endurance life with more than 10⁸ revolutions has been reached.     

新型InSb-In薄膜磁阻式振动传感器的设计

介绍了一种用InSb-In共晶体薄膜磁敏元件制成的准全方位振动传感器.它由两对对称轴方向互相垂直的InSb-In磁敏元件构成,可将检测方位范围由一维扩展到现在的二维平面,并用单片机P87LPC760对传感器信号进行处理,应用中可提高检测信号的准确性.经实测, 在机械振动的中低频率检测范围内,传感器的有效频带不窄于4～760Hz,其通频带内信噪比为30～32dB,经换算得灵敏度为16mV/gn.同时,得到传感器振动强度大小与磁敏电阻器输出信号关系曲线.     

二氧化硅薄膜材料热传导尺寸效应的实验研究

对微米SiO2薄膜材料沿膜面方向热传导尺寸效应进行了实验研究。结果表明,膜厚从微米数量级的尺寸开始,其传热的热导率就已开始体现出鲜明的膜厚尺寸依赖特性(即sizeeffect),经由微观能量输运理论分析后,得到了实验与理论相吻合的结果。     

Novel screen technology for high‐contrast front‐projection display by controlling ambient‐light reflection

Abstract— One problem with front‐projection displays is that the screen contrast ratio decreases in bright ambient light. In this paper, we propose a new front‐projection display system that incorporates the control of reflection of ambient light in the screen design, providing a high contrast ratio even in a brightly lit room.     

半导体薄膜生长实时监控系统的设计与应用

文章分析了半导体薄膜生长工艺流程的特点。在此基础上，为实验室的ECR—MOCVD设备设计了一套半导体薄膜生长的实时监控系统，介绍了系统的硬件结构以及在WIN98环境下用VB6．0实现生长实时监控系统软件的实现方法。经实验证明，系统保证了工艺流程的连续可靠运行，实验数据的可靠性和工艺流程的可重复性也大大提高，使用方便，降低了试验人员的劳动强度，实现了预期的设计目标。     

非晶Fe-Zr-B薄膜穆斯堡尔谱学研究

用X射线衍射分析、X射线光电子能谱(XPS)和穆斯堡尔谱学研究了直流磁控溅射法制备的Fe-Zr-B薄膜。X射线衍射分析结果表明制备态的薄膜是非晶的;X射线光电子能谱(XPS)结果表明样品表面氧化较明显,深层部分Fe, Zr, B结合占主导地位;穆斯堡尔谱学结果表明薄膜中Fe原子周围Zr、B原子的存在使Fe原子核内场值有所下降并导致超精细场分布P(H)出现双峰结构,薄膜中存在两种不同的局域微结构。     

Monte Carlo Simulation of Electron Swarm in the Diamond Film Growth via EACVD

Monte Carlo simulations are adopted to study the electron transport porcess in the non-uniform electric field.Some important parameters of electrons in diamond films dynamic process at low temperature via EACVD such as angle distribution,energy distribution,average energy of electrons are given.The results indicate that the electron scattering near the substrate is mainly of a large-angle scattering,exhibiting a double-peaking distribution .All of the conclusions provide some theoretical data referential to the vapor dynamic model of diamond film growth at low temperature via EACVD.     

Effects of Deposition Temperature on the Properties of Fluorinated Amorphous Carbon Films

Fluorinated amorphous carbon films (a-C:F) were prepared at different temperatures using a microwave electron cyclotron resonance chemical vapor deposition (ECR-CVD) reactor with CHF3 and C2H2 as source gases. Films were annealed at 500℃ in vacuum ambience inorder to investigate the relationship of their thermal stability, optical and electrical propertieswith deposition temperature. Results indicate that the films deposited at high temperature have a less CFx bonding and a more cross-linking structure thus a better thermal stability. They also have a lower bandgap, higher dielectric constant and higher leakage current.     

电容器用双向拉伸聚丙烯薄膜打滑试验研究

电容器用双向拉伸聚丙烯薄膜的打滑现象 ,是影响薄膜电容器制造质量的关键因素之一。本文分析了薄膜打滑机理、薄膜粗化机理 ,并进行了大量工艺试验 ,研究了影响薄膜打滑的主要因素 ,并提出了解决方法。优化合理的加工温度工艺是改进薄膜打滑的关键     

高纯金属与聚合物膜pH电极的研制

介绍以纯金属为基体,PVC为载体,α-萘胺为活性物质,三氯甲烷为溶剂研制成的聚合物膜电极,将它用于测定溶液的pH,取得了一些成效。