Thermodynamic Analysis of Various Dehumidifying Dryers for Wood

Typical methods of dehumidification of air circulating in the dehumidifying driers (indirect and direct cooler and partial exchange of the air) were analysed. Energy aspect of cooler operation was evaluated. The method for minimization of unit thermal energy consumption in a dehumidifying drier by the optimal selection of the cooler point was also given. Methods of the heat recovery of heat conveyed in a cooler lending to save energy (heat regeneration. expansion and compression of the air, a dehumidifier) were analysed. It was indicated that introduction of dehumidifiers into contemporary wood driers caused significant improvement of energy aspects of their operation     

光催化氧化后四环素的分解率与COD去除率之间关系的探讨

以粉状无机半导体（ＺｎＯ）为催化剂，探讨了水溶液中四环素经光催化氧化分解率和ＣＯＤ去除率之间的关系。实验表明，在本实验中四环素的分解率和ＣＯＤ去除率之间有较好的正相关性。当反庆系统中有足量的活性催化剂和足够的光照时间时，绝大部分四环素将被较彻底地氧化分解成ＣＯ２，这不仅有助于光催化反应机理的研究，助于今后在环保中的实际应用。     

A demonstrative study for the wind and solar hybrid power system

In March 1995, a small scale wind and solar hybrid power system was installed at Ashikaga Institute of Technology. Until now, the authors have acquired the data of the output of the hybrid power plant along with wind speed, wind direction, and the solar radiation, in order to demonstrate a complementary relationship between solar energy and wind energy.After nine months operation of the system, the authors confirmed that there exists a complementary relationship between solar energy and wind energy. We also found, however, that the power output by wind does not have much prospect compared to that by solar cell especially in summer season in Ashikaga area.     

Saturated liquid viscosities and densities of environmentally acceptable hydrochlorofluorocarbons (HCFCs)

Measurements of saturated liquid viscosities and densities were performed on environmentally acceptable hydrochlorofluorocarbons (HCFCs), CH₃CCl₂F (HCFC-141b), CH₃CClF₂ (HCFC-142b; only for viscosity), CF₃CF₂CHCl₂ (HCFC-225ca), and CClF₂CF₂CHClF (HCFC-225cb), using a capillary viscometer and a glass pycnometer in the temperature range from 273 to 353 K. The uncertainty in the measurement of viscosity is estimated to be 5% based on the comparison of the present data with those in the literature for HCFC-141b. An equation is given to represent our saturated liquid viscosity data as a function of temperature.     

Effect of processing history on the properties of Ag-based tapes

The Bi-system tapes and coils were prepared by the powder-in-tube method. The effect of processing and heat treatment on the properties of the tapes and coils was studied. It is found that the shearing stress produced by the rolling process may destroy the 2223 phase, and the destroyed 2223 phase cannot be recovered by heat treatment, whereas the pressing stress produced by the uniaxial pressing process only makes the 2223 phase grains break, and the broken 2223 phase can be closed by the heat treatment. TheJ _c values of the rolling samples, pressing sample, and the coil with a diameter of 35 mm are over 1.3×10⁴, 2.5×10⁴, and 4×10³ A/cm² (77 K, 0 T), respectively.     

太阳能热水器内表面电刷镀锌

用电刷镀的方法,对尺寸为2000mm×1000mm×0.8mm 的 A_3钢板电刷镀锌保护层;并对影响镀锌层质量的因素进行了充分的研究。     

Simulation of leachate migration in leaky aquifers

A two-dimensional cross-section finite difference model is presented to simulate density dependent leachate migration in leaky aquifers. Unlike existing models, a new approach is adopted to couple the groundwater-flow equation and the hydrodynamic dispersion equation with the elimination of the intermediate step of calculating velocities. The concept of the reference density is employed, permitting increased accuracy (over pressure-based models) in the representation of the transport process. The model is then used to study the effect of several hydraulic and transport parameters on the flow pattern and plume migration which are found to be very sensitive to most of these parameters. Equiconcentration and equipotential lines are overlapped to provide a better understanding of the coupling effect.     

Magnetic properties of nickel filament polymer-matrix composites

The magnetic properties of polyethersulfone-matrix composites with 3-19 vol.% polycrystalline nickel filaments (0.4 (im diam) were investigated. These filaments were found to exhibit hysteresis energy loss 10800 J/m³ of nickel and coercive force 16.9 kA/m, compared to corresponding values of 4930 J/m³ and 4.7 kA/m for 2 μ.m diam polycrystalline nickel fibers, 1020 J/m³ and 0.5 kA/m for 20 μm diam polycrystalline nickel fibers, and 1280 J/m³ and 2.3 kA/m for solid polycrystalline nickel.     

氧化锌压敏陶瓷烧结致密化过程的研究

本文研究了氧化锌压敏陶瓷的致密化过程，结果发现只有当烧结温度升高到一定值时，试样中的ＺｎＯ粉粒产生聚集，致密化过程才开始．致密化是瓷体获得稳定电性能的基础．低熔点添加剂Ｂ２Ｏ３可以降低致密化的起始温度，而致密化过程中的等温烧结对ＺｎＯ压敏陶瓷的最大密度几乎没有影响．     

脱苯工艺的节能改造

焦化厂富油脱苯工艺中，管式炉法较蒸汽法节能。本溪钢铁公司焦化厂产焦１８０万ｔ／ａ的装置，其富油脱苯工艺由蒸汽法改为管式炉法后，每年可节煤７０００ｔ。