熔敷金属扩散氢逸出特性研究

采用酒精法测量扩散氢 ,研究了焊条熔敷金属扩散氢含量以及在测氢过程中扩散氢逸出量与逸出时间的关系 (逸出特性 )。研究结果表明 ,熔敷金属扩散氢逸出特性受扩散氢含量、焊道数、熔敷金属化学成分和表面状态等多种因素的影响。熔敷金属扩散氢 (HDo)可以分为快速逸出扩散氢 (HDq)和慢速逸出扩散氢(HDs)两部分     

影响GPS水准高程的因素及高程拟合方法的探讨

在简单介绍高程系统的基础上，对影响GPS高程精度的几何水准联测误差、卫星分布不对称、星历误差、多路径误差等因素逐一进行了分析，并提出了相应的改进措施。同时，还对高程拟合使用的稳健估计方法进行了探讨。     

Assessing pre- and post-deformation in the southern Arava Valley segment of the Dead Sea Transform, Israel by differential interferometry

Differential radar interferometry, using archived ERS data over the region of the Dead Sea Transform, allows to detect ground movement (subsidence or uplift) in playas within the southern Arava Valley segment of the Dead Sea Rift. These measurements are consistent with a mean displacement rate of about 0.4 cm/month, in the direction of the radar beam, during the 8-month period preceding the Nuweiba earthquake of 22 November 1995. In the 3 years following the earthquake, the measured rate was smaller by a factor of 10. These movements are not related to salt diapirs or water pumping activities in the area. The exact location, along faults, suggests a possible correlation with pre-seismic and post-seismic fault deformation.A simple fault model consistent with the observed phenomena associates the observed subsidence/uplift to right and left stepping en-echelon fault patterns related to inter-seismic tensional accumulation along the faults. Further observations are necessary on this site and similar fault areas to corroborate the correlation between seismic activity and the observed phenomena. Monitoring of these sites should continue with differential Global positioning system (GPS) measurements and radar interferometric analysis using Envisat and Radarsat as well as archived data (including J-ERS).     

IMAGIS在数字校园建模中的应用

介绍了IMAGIS的功能和工作流程以及IMAGIS空间数据的获取途径,利用IMAGIS进行数字校园三维建模的实现,并以河南理工大学北校区数字校园建设为例介绍了IMAGIS在三维景观建模中的应用。     

冰覆盖下河道水流特性及床面高程的研究

本文对冰覆盖下的河道水流进行了区域划分,给出了区域分界面上的水流条件。应用水力学中的一些基本概念和基本原理,对冰覆盖下河道水流阻力、水流流速、切力、能坡及床面高程等问题进行了研究,给出了它们的物理概念和计算公式,并用实验观测资料进行了验证,结果令人满意。     

大比例尺地质剖面图第一条标高基线绘制方法的探讨

介绍了大比例尺地质剖面图第一条标高基线的几种绘制方法，总结了绘制经验。     

浅谈灵山岛超级堤堤顶特征高程拟定

以灵山岛超级堤工程为研究对象,分析阐述项目中各特征高程取值对堤防的影响,结合工程实际,根据不同频率的设计水位、亲水性、消浪蓄浪、景观要求等因素,对超级堤堤顶特征高程进行选定,可为类似超级堤工程提供参考。     

渠首水位实时调控模型——以船行灌区一支渠为例

很多大中型灌区在输配水过程中存在水位衔接不当的问题,加之田面高程存在起伏,使得灌溉时往往存在部分田面不能上水或受淹等问题。本文提出了空间灌溉率的概念,并利用GIS的三维分析功能研究了其与渠道渠首水位之间的关系。分析表明,空间灌溉率与渠首水位之间的关系符合Logistic曲线;针对船行灌区一支渠,得到该Logistic曲线的参数,并确定了一支渠渠首和干渠渠首不同空间灌溉率所需的水位,为灌区水位实时调控提供基础数据。     

重组G145R HBsAg亲和纯化方法的建立及其应用

目的建立重组乙型肝炎病毒G145R变异HBsAg抗体亲和纯化方法。方法用抗-HBs单克隆抗体(D12- McAb)制备亲和层析胶,对2A8细胞(分泌G145R变异HBsAg)培养上清盐析物进行亲和纯化。采用SDS-PAGE、Western blot及ELISA,对纯化产物的纯度、特异性、含量和回收率进行鉴定,并与同法纯化的HBsAg阳性血清及r-wHBsAg提取物进行比较。结果D12-McAb对重组真核表达G145R变异HBsAg、HBsAg阳性血清及r-wHBsAS三者具有相似的亲和性,产物纯度分别为90.3%、95.2%和93.1%,回收率分别为43.3%、72.0%和66.4%。结论已成功地建立了重组G145R变异HBsAg抗体亲和纯化方法,为G145R变异以及其他HBV免疫逃逸变异感染的深入研究奠定了重要的技术基础。     

Theoretical analysis of a multiple-effect diffusion still producing highly concentrated seawater

A multiple-effect diffusion still producing highly concentrated seawater was theoretically analyzed taking variations of the boiling point elevation (BPE) into account. The still consists of a series of seawater-soaked wicks stuck on closely-spaced parallel plates with the first plate steam-heated at 100°C and the last plate cooled in 30°C ambient air. Evaporation from the wicks increases the BPE more rapidly at downstream distances closer to exits of evaporating areas, and this increase reduces evaporation flux significantly at downstream regions on the wicks. An 80% heat recovery from products of hot condensate and concentrate reduces the steam consumption by 46%. The steam consumption decreases more rapidly with an increasing number of wicks than does the production rate; thus, a lower steam consumption ratio is observed for the still having more wicks. Narrowing the gaps between the plates greatly increases the production rate with a slight decrease in the steam consumption ratio. The still with 19 wicks with 1 m by 2 m evaporating areas, 5 mm gaps and 80% heat recovery produces 12 kg distillate and 3.3 kg concentrate of 0.16 kg/kg-water concentration per 1 kg steam consumption with a 26.4 kg/h distillate production rate.